- 您現在的位置：買賣IC網 > PDF目錄385388 > HMP8117CN (INTERSIL CORP) NTSC/PAL Video Decoder PDF資料下載
參數資料
| 型號： | HMP8117CN |
| 廠商： | INTERSIL CORP |
| 元件分類： | 顏色信號轉換 |
| 英文描述： | NTSC/PAL Video Decoder |
| 中文描述： | COLOR SIGNAL DECODER, PDSO80 |
| 封裝： | PLASTIC, MS-022GB-1, MQFP-80 |
| 文件頁數： | 8/45頁 |
| 文件大小： | 269K |
| 代理商： | HMP8117CN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁
8
remove high-frequency Y data. This may make a noisy image
more pleasing to the user, although softer.
Coring of the high-frequency Y data may be done to reduce
low-level high frequency noise.
Coring of the Y data may also be done to reduce low-level
noise around black. This forces Y data with the following
values to a value of 0:
coring = 1:
±
1
coring = 2:
±
1,
±
2
coring = 3:
±
1,
±
2.
±
3
High-frequency components of the luminance signal may be
“peaked” to control the sharpness of the image. Maximum
gain may be selected to occur at either 2.6MHz or the color
subcarrier frequency. This may be used to make the
displayed image more pleasing to the user. It should not be
used if the output video will be compressed, as the circuit
introduces high-frequency components that will reduce the
compression ratio.
The brightness control adds or subtracts a user-specified
DC offset to the Y data. The contrast control multiplies the Y
data by a user-specified amount. These may be used to
make the displayed image more pleasing to the user.
Finally, a value of 16 is added to generate a nominal range of
16 (black) to 235 (white).
CbCr Processing
The CbCr data is low-pass filtered to either 0.85MHz or
1.5MHz.
Coring of the CbCr data may be done to reduce low-level
noise around zero. This forces CbCr data with the following
values to a value of 128.
coring = 1: 127, 129
coring = 2: 126, 127, 129, 130
coring = 3: 125, 126, 127, 129, 130, 131
The saturation control multiplies the CbCr data by a user-
specified amount. This may be used to make the displayed
image more pleasing to the user. The CbCr data may also
be optionally multiplied by the contrast value to avoid color
shifts when changing contrast.
The hue control provides a user-specified phase offset to the
color subcarrier during decoding. This may be used to
correct slight hue errors due to transmission.
YCbCr Output Format Processing
Y has a nominal range of 16 to 235. Cb and Cr have a
nominal range of 16 to 240, with 128 corresponding to zero.
Values less than 1 are made 1 and values greater than 254
are made 254.
While BLANK is asserted, Y is forced to have a value of 16,
with Cb and Cr forced to have a value of 128, unless VBI
data is present.
RGB Output Format Processing
The 4:2:2 YCbCr data is converted to 4:4:4 YCbCr data and
then converted to either 15-bit or 16-bit gamma-corrected
RGB (R
′
G
′
B
′
) data. While BLANK is asserted, RGB data is
forced to a value of 0.
15-Bit R
′
G
′
B
′
The following YCbCr to R
′
G
′
B
′
equations are used to
maintain the proper black and white levels:
R
′
= 0.142(Y - 16) + 0.194(Cr - 128)
G
′
= 0.142(Y - 16) - 0.099(Cr - 128) - 0.048(Cb - 128)
B
′
= 0.142(Y - 16) + 0.245(Cb - 128)
The resulting 15-bit R
′
G
′
B
′
data has a range of 0 to 31.
Values less than 0 are made 0 and values greater than 31
are made 31.
The 15-bit R
′
G
′
B
′
data may be converted to 15-bit linear
RGB, using the following equations. Although the PAL
specifications specify a gamma of 2.8, a gamma of 2.2 is
normally used. The HMP8117 allows the selection of the
gamma to be either 2.2 or 2.8, independent of the video
standard.
for gamma = 2.2:
for R
′
G
′
B
′
< 0.0812*31
R = (31)((R
′
/31)/4.5)
G = (31)((G
′
/31)/4.5)
B = (31)((B
′
/31)/4.5)
for R
′
G
′
B
′
>= 0.0812*31
R = (31)(((R
′
/31) + 0.099)/1.099)
2.2
G = (31)(((G
′
/31) + 0.099)/1.099)
2.2
B = (31)(((B
′
/31) + 0.099)/1.099)
2.2
for gamma = 2.8:
R = (31)(R
′
/31)
2.8
G = (31)(G
′
/31)
2.8
B = (31)(B
′
/31)
2.8
16-Bit R
′
G
′
B
′
The following YCbCr to R
′
G
′
B
′
equations are used to
maintain the proper black and white levels:
R
′
= 0.142(Y - 16) + 0.194(Cr - 128)
G
′
= 0.288(Y - 16) - 0.201(Cr - 128) - 0.097(Cb - 128)
B
′
= 0.142(Y - 16) + 0.245(Cb - 128)
The resulting 16-bit R
′
G
′
B
′
data has a range of 0 to 31 for R
′
and B
′
, and a range of 0 to 63 for G
′
. Values less than 0 are
made 0; R
′
and B
′
values greater than 31 are made 31, G
′
values greater than 63 are made 63.
The 16-bit R
′
G
′
B
′
data may be converted to 16-bit linear RGB,
using the following equations. Although the PAL specifications
specify a gamma of 2.8, a gamma of 2.2 is normally used.
The HMP8117 allows the selection of the gamma to be either
2.2 or 2.8, independent of the video standard.
HMP8117
相關PDF資料 |
PDF描述 |
|---|---|
| HMP8154 | NTSC/PAL Encoders |
| HMP8154CN | NTSC/PAL Encoders |
| HMP8156A | NTSC/PAL Encoders |
| HMP8154EVAL1 | NTSC/PAL Encoders |
| HMP8190 | NTSC/PAL Video Encoder |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HMP8117CN96 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| HMP8117CNZ | 功能描述:編碼器、解碼器、復用器和解復用器 W/ANNEAL 80PQFP 0+70 DECODER W/MA RoHS:否 制造商:Micrel 產品:Multiplexers 邏輯系列:CMOS 位數: 線路數量（輸入/輸出）:2 / 12 傳播延遲時間:350 ps, 400 ps 電源電壓-最大:2.625 V, 3.6 V 電源電壓-最小:2.375 V, 3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Tray |
| HMP8154 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:NTSC/PAL Encoders |
| HMP8154_05 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:NTSC/PAL Encoders |
| HMP8154CN | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。