參數資料
型號: HFA3861A
廠商: Intersil Corporation
元件分類: 基帶處理器
英文描述: Direct Sequence Spread Spectrum Baseband Processor(直接序列擴頻基帶處理器)
中文描述: 直接序列擴頻基帶處理器(直接序列擴頻基帶處理器)
文件頁數: 23/36頁
文件大?。?/td> 279K
代理商: HFA3861A
23
CONFIGURATION REGISTER 5 ADDRESS (0Ah) R/W TX SIGNAL FIELD
Bits 7:4
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
Bits 3
Select preamble mode
0 = Normal, long preamble interoperable with 1 and 2Mbps legacy equipment
1= short preamble and header mode (optional in 802.11)
Bit 2
Reserved, must be set to 0
Bits 1:0
TX data Rate. Must be set at least 2
μ
s before needed in TX frame. This selects TX signal field code from the registers above.
00 = DBPSK - 11 chip sequence (1Mbps)
01 = DQPSK - 11 chip sequence (2Mbps)
10 = CCK - 8 chip sequence (5.5Mbps)
11 = CCK - 8 chip sequence (11Mbps)
CONFIGURATION REGISTER 6 ADDRESS (0Ch) R/W TX SERVICE FIELD
Bits 7:0
R/W but not currently used internally. Bit 7 may be employed by the MAC in 802.11 situations to resolve an ambiguity in the
length field when in the 11Mbps mode. Bit 2 should be set to a 1 where the reference oscillator of the radio is common for both
the carrier frequency and the data clock. All other bits should be set to 0 to insure compatibility.
CONFIGURATION REGISTER 7 ADDRESS (0Eh) R/W TX LENGTH FIELD (HIGH)
Bits 7:0
This 8-bit register contains the higher byte (bits 8-15) of the transmit Length Field described in the Header. This byte combined
with the lower byte indicates the number of microseconds the data packet will take.
CONFIGURATION REGISTER 8 ADDRESS (10h) R/W TX LENGTH FIELD (LOW)
Bits 7:0
This 8-bit register contains the lower byte (bits 0-7) of the transmit Length Field described in the Header. This byte combined
with the higher byte indicates the number of microseconds the data packet will take.
CONFIGURATION REGISTER 9 ADDRESS (12h) R/W TX CONFIGURE
Bit 7
CCA sample mode time
0 = 19.9
μ
s
1 = 15.8
μ
s
Bits 6:5
CCA mode
00 - CCA is based only on ED
01 - CCA is based on (CS1 OR SQ1/CS2)
10 - CCA is based on (ED AND (CS1 OR SQ1/CS2))
11 - CCA is based on (ED OR (CS1 | SQ1/CS2))
Bit 4
TX test modes
0 = Alternating bits for carrier suppression test. (Needs scrambler off (CR32 <2> = 1)).
1 = all chips set to 1 for CW carrier. This allows frequency measurement
Bit 3
Enable TX test modes
0 = normal operation
1 = Invoke tests described by bit 4
Bit 2
Antenna choice for TX
0 = Set AntSel low
1 = Set AntSel high
Bit:1
TX Antenna Mode
0 = set AntSel pin to value in bit 2
1 = set AntSel pin to antenna for which last valid header CRC occurred
Bit 0
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
CONFIGURATION REGISTER 10 ADDRESS (14h) R/W RX CONFIGURE
Bit 7
Initial CS2 estimate
0 = Use dot product result
1 = Use SQ1 from Barker correlator peaks
see CR30 and CR48 for related thresholds
Bit 6
CIR estimate/ Dot product clock control.
0 = on during acquisition
1 = only on after detect.
HFA3861A
相關PDF資料
PDF描述
HFA3861B Direct Sequence Spread Spectrum Baseband Processor(直接序列擴譜基帶處理器)
HFA3861 Direct Sequence Spread Spectrum (DSSS) baseband processor(直接序列擴頻基帶處理器)
HFA3861IV Direct Sequence Spread Spectrum Baseband Processor
HFA3861IV96 Direct Sequence Spread Spectrum Baseband Processor
HFA3925 2.4GHz - 2.5GHz 250mW Power Amplifier(2.4GHz - 2.5GHz 250mW 功率放大器)
相關代理商/技術參數
參數描述
HFA3861AIN 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processo
HFA3861AIN96 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processo
HFA3861B 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processor
HFA3861BIN 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processor
HFA3861BIN96 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Direct Sequence Spread Spectrum Baseband Processor