- 您現在的位置：買賣IC網 > PDF目錄385354 > HC4046 (System Logic Semiconductor Co., Ltd.) Phase-Locked Loop PDF資料下載
參數資料
| 型號： | HC4046 |
| 廠商： | System Logic Semiconductor Co., Ltd. |
| 英文描述： | Phase-Locked Loop |
| 中文描述： | 鎖相環 |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 134K |
| 代理商： | HC4046 |
SL74HC4046
S ystem Logic
Semiconductor
SLS
DETAILED CIRCUIT DESCRIPTION
Voltage Controlled Oscillator/Demodulator Output
The VCO requires two or three external
components to operate. These are R1, R2, C1. Resistor
R1 and Capacitor C1 are selected to determine the
center frequency of the VCO (see typical performance
curves Figure 12). R2 can be used to set the offset
frequency with 0 volts at VCO input. For example, if R2
is decreased, the offset frequency is increased. If R2 is
omitted the VCO range is from 0 Hz. By increasing the
value of R2 the lock range of the PLL is increased and
the gain (volts/Hz) is decreased. Thus, for a narrow
lock range, large swings on the VCO input will cause
less frequency variation.
Internally, the resistors set a current in a current
mirror, as shown in Figure 5. The mirrored current
drives one side of the capacitor. Once the voltage
across the capacitor charges up to V
ref
of the
comparators, the oscillator logic flips the capacitor
which causes the mirror to change the opposite side of
the capacitor. The output from the internal logic is then
taken to VCO output (Pin4).
The input to the VCO is a very high impedance
CMOS input and thus will not load down the loop filter,
easing the filters design. In order to make signals at the
VCO input accessible without degrading the loop
performance, the VCO input voltage is buffered
through a unity gain Op-amp, to Demod Output. This
Op-amp can drive loads of 50K ohms or more and
provides no loading effects to the VCO input voltage
(see Figure 10).
An inhibit input is provided to allow disabling
of the VCO and all Op-amps (see Figure 5). This is
useful if the internal VCO is not being used. A logic
high on inhibit disables the VCO and all Op-amps,
minimizing standby power consumption.
The output of the VCO is a standard high speed
CMOS output with an equivalent LS-TTL fan out of 10.
The VCO output is approximately a square wave. This
output can either directly feed the COMP
IN
of the
phase comparators or feed external prescalers
(counters) to enable frequency synthesis.
Figure 5. Logic Diagram for VCO
相關PDF資料 |
PDF描述 |
|---|---|
| HC4053 | IC-VLTG REG 125V-1A |
| HC4094 | T-NPN-SI HIGH VLTG AMP |
| HC49J | SM Crystal Formed Leads |
| HC534 | Voltage Regulator IC; Package/Case:3-TO-3; Current Rating:1.5A; Output Voltage Max:-12V; Voltage Regulator Type:Fixed Voltage; Mounting Type:Through Hole |
| HC5503CBZ | Low Cost 24V SLIC For PABX / Key Systems |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HC4046A | 制造商:Motorola Inc 功能描述: |
| HC-405 | 制造商:Thomas & Betts 功能描述: |
| HC4051A-L85H WAF | 制造商:ON Semiconductor 功能描述: |
| HC4052 | 制造商:SLS 制造商全稱:System Logic Semiconductor 功能描述:Analog Multiplexer/Demultiplexer(High-Performance Silicon-Gate CMOS) |
| HC4052A-L85H WAF | 制造商:ON Semiconductor 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。