- 您現在的位置：買賣IC網 > PDF目錄385311 > GS1559-CB (Gennum Corporation) GS1559 HD-LINX-TM II Multi-Rate Deserializer with Loop-Through Cable Driver PDF資料下載
參數資料
| 型號： | GS1559-CB |
| 廠商： | Gennum Corporation |
| 英文描述： | GS1559 HD-LINX-TM II Multi-Rate Deserializer with Loop-Through Cable Driver |
| 中文描述： | GS1559的HD - LINX進程，商標第二多速率解串器與環通電纜驅動器 |
| 文件頁數： | 41/74頁 |
| 文件大小： | 686K |
| 代理商： | GS1559-CB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
GS1559 Data Sheet
30572 - 4
July 2005
41 of 74
4.8 DVB-ASI Functionality
The GS1559 is said to be in DVB-ASI mode once the device has detected 32
consecutive DVB-ASI words without a single word or disparity error being
generated. The device will remain in DVB-ASI mode until 32 consecutive DVB-ASI
word or disparity errors are detected, or until SMPTE TRS ID words have been
detected.
The lock detect block may also drop out of DVB-ASI mode under the following
conditions:
K28.5 sync patterns in the received DVB-ASI data stream will be detected by the
device in either inverted or non-inverted form.
RESET_TRST is asserted LOW
CDx is HIGH
SMPTE_BYPASS is asserted HIGH in slave mode
DVB_ASI is asserted LOW in slave mode
In master mode, the GS1559 sets the SMPTE_BYPASS pin LOW and the
DVB_ASI pin HIGH to indicate that it has locked to a DVB-ASI input data stream.
When operating in slave mode, the application layer must set the SD/HD pin HIGH,
in addition to setting SMPTE_BYPASS LOW and DVB_ASI HIGH, in order to
enable DVB-ASI operation.
4.8.1 DVB-ASI 8b/10b Decoding and Word Alignment
After serial-to-parallel conversion, the internal 10-bit data bus is fed to the DVB-ASI
8b/10b decode and word alignment block. The function of this block is to word align
the data to the K28.5 sync characters, and 8b/10b decode and bit-swap the data
to achieve bit alignment with the data outputs.
The extracted 8-bit data will be presented to DOUT[17:10], bypassing all internal
SMPTE mode data processing.
NOTE: When operating in DVB-ASI mode, DOUT[9:0] are forced LOW.
4.8.2 Status Signal Outputs
In DVB-ASI mode, the DOUT19 and DOUT18 pins will be configured as DVB-ASI
status signals SYNCOUT and WORDERR respectively.
SYNCOUT will be HIGH whenever a K28.5 sync character is present on the output.
This output may be used to drive the write enable signal of an external FIFO, thus
providing a means of removing the K28.5 sync characters from the data stream.
Parallel DVB-ASI data may then be clocked out of the FIFO at some rate less than
27MHz. See
Figure 4-4
.
WORDERR will be high whenever the device has detected a running disparity error
or illegal code word.
相關PDF資料 |
PDF描述 |
|---|---|
| GS1559-CBE2 | GS1559 HD-LINX-TM II Multi-Rate Deserializer with Loop-Through Cable Driver |
| GS2905 | 500mA CMOS LDO Voltage Regulator |
| GS2905X15 | 500mA CMOS LDO Voltage Regulator |
| GS2905X18 | 500mA CMOS LDO Voltage Regulator |
| GS2905X25 | 500mA CMOS LDO Voltage Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS1559CBE2 | 制造商:Gennum Corporation 功能描述:DESERIALISER HD/SDI/ASI W/DRV 100BGA 制造商:Gennum Corporation 功能描述:DESERIALISER, HD/SDI/ASI, W/DRV, 100BGA |
| GS1559-CBE2 | 功能描述:RF, RFID, WIRELESS RoHS:是 類別:集成電路 (IC) >> 接口 - 串行器，解串行器 系列:* 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 功能:解串器 數據速率:2.5Gbps 輸入類型:串行 輸出類型:并聯 輸入數:- 輸出數:24 電源電壓:1.8 V ~ 3.3 V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:管件 |
| GS1560 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HD-LINX II Voltage Controlled Oscillator |
| GS1560A | 制造商:Gennum Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。