- 您現在的位置：買賣IC網 > PDF目錄9174 > FS6370-01G-XTD (ON Semiconductor)IC CLOCK GEN 3-PLL EEPROM 16SOIC PDF資料下載
參數資料
| 型號： | FS6370-01G-XTD |
| 廠商： | ON Semiconductor |
| 文件頁數： | 27/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CLOCK GEN 3-PLL EEPROM 16SOIC |
| 標準包裝： | 48 |
| 類型： | PLL 時鐘發生器 |
| PLL： | 是 |
| 輸入： | 晶體 |
| 輸出： | CMOS |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:4 |
| 差分 - 輸入:輸出： | 無/無 |
| 頻率 - 最大： | 230MHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 3 V ~ 5.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SOIC |
| 包裝： | 管件 |
| 產品目錄頁面： | 1115 (CN2011-ZH PDF) |
| 其它名稱： | 766-1025 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁
FS6370
Figure 5: FS6370 to FS6377
7.2 Non-Programming Migration Path
If the design has solidified on a particular EEPROM programming pattern, the EEPROM pattern can be hard-coded into a ROM-based
device. For high-volume requirements, a ROM-based device offers significant cost savings over the FS6370. Contact an ON
Semiconductor sales representative for more detail.
8.0 I2C-bus Control Interface
This device is a read/write slave device meeting all Philips I2C-bus specifications except a "general call." The bus has to
be controlled by a master device that generates the serial clock SCL, controls bus access and generates the START and
STOP conditions while the device works as a slave. Both master and slave can operate as a transmitter or receiver, but
the master device determines which mode is activated. A device that sends data onto the bus is defined as the
transmitter, and a device receiving data as the receiver.
I2C-bus logic levels noted herein are based on a percentage of the power supply (VDD). A logic-one corresponds to a nominal voltage of
VDD, while a logic-low corresponds to ground (VSS).
8.1 Bus Conditions
Data transfer on the bus can only be initiated when the bus is not busy. During the data transfer, the data line (SDA) must remain stable
whenever the clock line (SCL) is high. Changes in the data line while the clock line is high will be interpreted by the device as a START
or STOP condition. The following bus conditions are defined by the I2C-bus protocol.
8.1.1. Not Busy
Both the data (SDA) and clock (SCL) lines remain high to indicate the bus is not busy.
8.1.2. START Data Transfer
A high to low transition of the SDA line while the SCL input is high indicates a START condition. All commands to the device must be
preceded by a START condition.
Rev. 3 | Page 8 of 28 | www.onsemi.com
相關PDF資料 |
PDF描述 |
|---|---|
| VE-23K-MX-B1 | CONVERTER MOD DC/DC 40V 75W |
| DS1803Z-050+T&R | IC POT DUAL ADDRESS 50K 16-SOIC |
| DS1848E-050+T&R | IC RES/MEM TEMP 50/10K 14-TSSOP |
| VE-23K-MW | CONVERTER MOD DC/DC 40V 100W |
| 74LVX138MTCX | DECODER/DEMUX 1-OF-8 LV 16TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FS6370-01G-XTP | 功能描述:時鐘發生器及支持產品 EE PROG 3-PLL CLOCK RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| FS6377 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Programmable 3-PLL Clock Generator IC |
| FS6377-01 | 制造商:AMI 制造商全稱:AMI 功能描述:Programmable 3-PLL Clock Generator IC |
| FS6377-01G | 制造商:AMI 制造商全稱:AMI 功能描述:Programmable 3-PLL Clock Generator IC |
| FS6377-01G-XTD | 功能描述:時鐘發生器及支持產品 I2C PROG 3-PLL CLK RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
發布緊急采購，3分鐘左右您將得到回復。