參數資料
型號: DK-DEV-4CGX150N
廠商: Altera
文件頁數: 13/42頁
文件大?。?/td> 0K
描述: KIT DEVELOPMENT CYCLONE IV GX
應用說明: Cyclone IV Design Guidelines
產品培訓模塊: Three Reasons to Use FPGA's in Industrial Designs
Cyclone IV FPGA Family Overview
軟件下載: DK-DEV-4CGX150N Kit Install
特色產品: Cyclone? IV GX FPGA Development Kit
標準包裝: 1
系列: CYCLONE® IV GX
類型: FPGA
適用于相關產品: Cyclone IV GX
所含物品: 板,線纜,文檔,電源
其它名稱: 544-2713
1–20
Chapter 1: Cyclone IV Device Datasheet
Switching Characteristics
December 2013
Altera Corporation
PLD-Transceiver Interface
Interface speed
(F324 and smaller
package)
25
125
25
125
25
125
MHz
Interface speed
(F484 and larger
package)
25
156.25
25
156.25
25
156.25
MHz
Digital reset pulse
width
Minimum is 2 parallel clock cycles
Notes to Table 1–21:
(1) This specification is valid for transmitter output jitter specification with a maximum total jitter value of 112 ps, typically for 3.125 Gbps SRIO and XAUI
protocols.
(2) The minimum reconfig_clk frequency is 2.5 MHz if the transceiver channel is configured in Transmitter Only mode. The minimum reconfig_clk frequency
is 37.5 MHz if the transceiver channel is configured in Receiver Only or Receiver and Transmitter mode.
(3) The device cannot tolerate prolonged operation at this absolute maximum.
(4) The rate matcher supports only up to ±300 parts per million (ppm).
(5) Supported for the N148, F169, and F324 device packages only.
(6) Supported for the F484, F672, and F896 device packages only. Pending device characterization.
(7) To support CDR ppm tolerance greater than ±300 ppm, implement ppm detector in user logic and configure CDR to Manual Lock Mode.
(8) Asynchronous spread-spectrum clocking is not supported.
(9) For the EP4CGX30 (F484 package only), EP4CGX50, and EP4CGX75 devices, the CDR ppl tolerance is ±200 ppm.
(10) Time taken until pll_locked goes high after pll_powerdown deasserts.
(11) Time that the CDR must be kept in lock-to-reference mode after rx_analogreset deasserts and before rx_locktodata is asserted in manual mode.
(12) Time taken to recover valid data after the rx_locktodata signal is asserted in manual mode (Figure 1–2), or after rx_freqlocked signal goes high in
automatic mode (Figure 1–3).
(13) Time taken to recover valid data after the rx_locktodata signal is asserted in manual mode.
(14) Time taken to recover valid data after the rx_freqlocked signal goes high in automatic mode.
(15) To support data rates lower than the minimum specification through oversampling, use the CDR in LTR mode only.
Table 1–21. Transceiver Specification for Cyclone IV GX Devices (Part 4 of 4)
Symbol/
Description
Conditions
C6
C7, I7
C8
Unit
Min
Typ
Max
Min
Typ
Max
Min
Typ
Max
相關PDF資料
PDF描述
AIRD-02-2R7K INDUCTOR PWR DRUM CORE 2.7UH
AIRD-02-1R5K INDUCTOR PWR DRUM CORE 1.5UH
ECC30DJCB CONN EDGECARD 60PS .100 PRESSFIT
D-SCE-1K-4.8-50-S1-9 HEAT SHRINK SLEEVE MARKER
SPX1431S-L/TR IC VREF SHUNT PREC ADJ 8-SOICN
相關代理商/技術參數
參數描述
DK-DEV-4CGX150N 制造商:Altera Corporation 功能描述:KIT STARTER CYCLONE IV GX ((NS
DK-DEV-4S100G5N 功能描述:可編程邏輯 IC 開發工具 FPGA Development Kit For EP4S100G5F RoHS:否 制造商:Altera Corporation 產品:Development Kits 類型:FPGA 工具用于評估:5CEFA7F3 接口類型: 工作電源電壓:
DK-DEV-4SE530N 功能描述:可編程邏輯 IC 開發工具 FPGA Development Kit For EP4SE530H35 RoHS:否 制造商:Altera Corporation 產品:Development Kits 類型:FPGA 工具用于評估:5CEFA7F3 接口類型: 工作電源電壓:
DK-DEV-4SGX230N 功能描述:可編程邏輯 IC 開發工具 FPGA Development Kit For EP4SGX230KF40C2N RoHS:否 制造商:Altera Corporation 產品:Development Kits 類型:FPGA 工具用于評估:5CEFA7F3 接口類型: 工作電源電壓:
DK-DEV-4SGX230N/C2 功能描述:EP4SGX230KF40C2N Stratix? IV GX FPGA Evaluation Board 制造商:altera 系列:Stratix? IV GX 零件狀態:過期 類型:FPGA 配套使用產品/相關產品:EP4SGX230KF40C2N 內容:板,線纜,電源 標準包裝:1