參數資料
型號: BX80532KC2800D
廠商: INTEL CORP
元件分類: 微控制器/微處理器
英文描述: 32-BIT, 2800 MHz, MICROPROCESSOR
文件頁數: 5/129頁
文件大?。?/td> 1640K
代理商: BX80532KC2800D
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁
Intel Xeon Processor with 512 KB L2 Cache
102
Datasheet
In the Sleep state, the processor is incapable of responding to snoop transactions or latching
interrupt signals. No transitions or assertions of signals (with the exception of SLP# or RESET#)
are allowed on the front side bus while the processor is in Sleep state. Any transition on an input
signal before the processor has returned to Stop-Grant state will result in unpredictable behavior.
If RESET# is driven active while the processor is in the Sleep state, and held active as specified in
the RESET# pin specification, then the processor will reset itself, ignoring the transition through
Stop-Grant state. If RESET# is driven active while the processor is in the Sleep state, the SLP# and
STPCLK# signals should be deasserted immediately after RESET# is asserted to ensure the
processor correctly executes the reset sequence.
Once in the Sleep state, the SLP# pin can be deasserted if another asynchronous front side bus
event occurs. The SLP# pin should only be asserted when the processor (and all logical processors
within the physical processor) is in the Stop-Grant state. SLP# assertions while the processors are
not in the Stop-Grant state is out of specification and may result in illegal operation.
7.2.6
Bus Response During Low Power States
While in AutoHALT Power Down and Stop-Grant states, the processor will process a front side bus
snoop.
When the processor is in Sleep state, the processor will not process interrupts or snoop
transactions.
7.3
Thermal Monitor
Thermal Monitor is a feature of the processor that allows system designers to lower the cost of
thermal solutions, without compromising system integrity or reliability. By using a factory-tuned,
precision on-die temperature sensor, and a fast acting thermal control circuit (TCC), the processor,
without the aid of any additional software or hardware, can control the processors’ die temperature
within factory specifications under typical real-world operating conditions. Thermal Monitor thus
allows the processor and system thermal solutions to be designed much closer to the power
envelopes of real applications, instead of being designed to the much higher maximum processor
power envelopes.
Thermal Monitor controls the processor temperature by modulating (starting and stopping) the
internal processor core clocks. The processor clocks are modulated when the thermal control
circuit (TCC) is activated. Thermal Monitor uses two modes to activate the TCC: Automatic mode
and On-Demand mode. Automatic mode must be enabled via BIOS, which is required for the
processor to operate within specifications. Once automatic mode is enabled, the TCC will
activate only when the internal die temperature is very near the temperature limits of the processor.
When the TCC is enabled, and a high temperature situation exists (i.e. TCC is active), the clocks
will be modulated by maintaining a duty cycle within a range of 30% - 50%. Clocks will not be off
or on more than 3.0 ms when the TCC is active. Cycle times are processor speed dependent and
will decrease as processor core frequencies increase. A small amount of hysteresis has been
included to prevent rapid active/inactive transitions of the TCC when the processor temperature is
near the trip point. Once the temperature has returned to a non-critical level, and the hysteresis
timer has expired, modulation ceases and the TCC goes inactive. Processor performance will be
decreased by ~50% when the TCC is active (assuming a duty cycle that varies from 30%-50%),
however, with a properly designed and characterized thermal solution the TCC most likely will
only be activated briefly during the most power intensive applications while at maximum chassis
ambient temperature.
相關PDF資料
PDF描述
BX80524R300128 32-BIT, 300 MHz, MICROPROCESSOR, XMA
BZV09/A0332/04 3A, 250VAC, FEMALE AND MALE, MAINS POWER CONNECTOR
BZV09/A0332/14 3A, 250VAC, FEMALE AND MALE, MAINS POWER CONNECTOR
BZV09/A0332/37 3A, 250VAC, FEMALE AND MALE, MAINS POWER CONNECTOR
BKT-146-01-F-V 92 CONTACT(S), MALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
相關代理商/技術參數
參數描述
BX80532KC2800DU 制造商:Intel 功能描述:MPU XEON PROCESSOR NETBURST 64-BIT 0.13UM 2.8GHZ - Boxed Product (Development Kits)
BX80532KC2800F 制造商:Intel 功能描述:MPU XEON PROCESSOR NETBURST 64-BIT 0.13UM 2.8GHZ - Boxed Product (Development Kits)
BX80532KC3000D 制造商:Intel 功能描述:MPU XEON PROCESSOR NETBURST 64-BIT 0.13UM 3GHZ - Boxed Product (Development Kits)
BX80532KC3000H 制造商:Intel 功能描述:MPU XEON NETBURST 64-BIT 0.13UM 3GHZ - Boxed Product (Development Kits)
BX80532KE2000D 制造商:Intel 功能描述:MPU XEON PROCESSOR NETBURST 64-BIT 0.13UM 2GHZ - Boxed Product (Development Kits)