- 您現在的位置：買賣IC網 > PDF目錄385088 > ADM6995L (Electronic Theatre Controls, Inc.) 5 PORT 10/100 MB/s SINGLE CHIP ETHERNET SWITCH CONTROLLER PDF資料下載
參數資料
| 型號： | ADM6995L |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 5 PORT 10/100 MB/s SINGLE CHIP ETHERNET SWITCH CONTROLLER |
| 中文描述： | 5端口10/100 MB / s的單芯片以太網交換控制器 |
| 文件頁數： | 42/57頁 |
| 文件大?。?/td> | 1815K |
| 代理商： | ADM6995L |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁當前第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
ADM6995L
Register Description
4.4 EEPROM Access
Customer can select ADM6995L read EEPROM contents as chip setting or not.
ADM6995L will check the signature of
EEPROM to decide read content of EEPROM or not.
RESETL & EEPROM content relationship
RESETL
CS
SK
0
High Impedance
High Impedance
Rising edge 0
1
(30ms)
1 (after 30ms)
Input
Input
Keep at least 30ms after RESETL from 0
1. ADM6995L will read data from EEPROM.
After RESETL if CPU update EEPROM that ADM6995L will update configuration
registers too.
When CPU programming EEPROM & ADM6995L, ADM6995L recognizes the
EEPROM WRITE instruction only. If there is any Protection instruction before or after
the EEPROM WRITE instruction, CPU needs to generate separated CS signal cycle for
each Protection & WRITE instruction.
CPU can directly program ADM6995L after 30ms of Reset signal rising edge with or
without EEPROM
ADM6995L serial chips will latch hardware-reset value as recommend value. It includes
EEPROM interface:
EECS: Internal Pull down 40K resister.
EESK: TP port Auto-MDIX select. Internal pull down 40K resister as non Auto-MDIX
mode.
EDI: Dual Color Select. Internal pull down 40K resister as Single Color Mode.
EDO: EEPROM enable. Internal pull up 40K resister as EEPROM enable.
Below Figure is ADM6995L serial chips EEPROM pins operation at different stage.
Reset signal is control by CPU with at least 100ms low. Point1 is Reset rising edge. CPU
must prepare proper value on EECS(0), EESK, EDI, EDO(1) before this rising edge.
ADM6995L will read this value into chip at Point2. CPU must keep these values over
point2. Point2 is 200ns after Reset rising edge.
ADM6995L serial chips will read EEPROM content at Point4 which 800ns far away
from the rising edge of Reset. CPU must turn EEPROM pins EECS, EESK, EDI and
EDO to High-Z or pull high before Point4.
If user want change state to High-Z or pull high on EEPROM pins, the order is CS-> DI -
> DO -> SK is better.
DI
High Impedance
Output
DO
High Impedance
Input
Output
Output
Output
Input
ADMtek Inc.
4-12
相關PDF資料 |
PDF描述 |
|---|---|
| ADM6995 | 5 PORT 10/100 MB/S SINGLE CHIP ETHIERNET SWITCH CONTROLLER |
| ADS-930 | 16-Bit, 500kHz Sampling A/D Converters |
| ADS-930MC | 16-Bit, 500kHz Sampling A/D Converters |
| ADS-930MM | 16-Bit, 500kHz Sampling A/D Converters |
| ADS-EVAL3 | 16-Bit, 500kHz Sampling A/D Converters |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM6995LAAT1 | 功能描述:IC SWITCH CNTRLR 10/100 128QFP RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| ADM6995LAAT1NP | 制造商:Infineon Technologies AG 功能描述:SWITCH / PHY |
| ADM6995LCACT1 | 制造商:Infineon Technologies AG 功能描述: |
| ADM6995LCACT1NP | 制造商:Infineon Technologies AG 功能描述:SWITCH / PHY |
| ADM6995LCADT1NP | 制造商:Infineon Technologies AG 功能描述:SWITCH / PHY |
發布緊急采購，3分鐘左右您將得到回復。