參數資料
型號: ADM6995L
廠商: Electronic Theatre Controls, Inc.
英文描述: 5 PORT 10/100 MB/s SINGLE CHIP ETHERNET SWITCH CONTROLLER
中文描述: 5端口10/100 MB / s的單芯片以太網交換控制器
文件頁數: 21/57頁
文件大小: 1815K
代理商: ADM6995L
ADM6995L
Function Description
3.4.11
Bad SSD Detection
A bad start of stream delimiter (Bad SSD) is an error condition that occurs in the
100Base-X receiver if carrier is detected (CRS asserted) and a valid /J/K set of code-
group (SSD) is not received.
If this condition is detected, then the ADM6995L will assert RXER and present
RXD[3:0] = 1110 to the internal MII for the cycles hat correspond to received 5B code-
groups until at least two idle code-groups are detected. Once at least two idle code groups
are detected, RXER and CRS become de-asserted.
3.4.12
Far-End Fault
Auto negotiation provides a mechanism for transferring information from the Local
Station to the link Partner that a remote fault has occurred for 100Base-TX. As auto
negotiation is not currently specified for operation over fiber, the far end fault indication
function (FEFI) provides this capability for 100Base-FX applications.
A remote fault is an error in the link that one station can detect while the other cannot. An
example of this is a disconnected wire at a station’s transmitter. This station will be
receiving valid data and detect that the link is good via the link integrity monitor, but will
not be able to detect that its transmission is not propagating to the other station.
A 100Base-FX station that detects such a remote fault may modify its transmitted idle
stream from all ones to a group of 84 ones followed by a single 0. This is referred to as
the FEFI idle pattern.
3.5 100Base-TX Transceiver
ADM6995L implements a TP-PMD compliant transceiver for 100Base-TX operation.
The differential transmit driver is shared by the 10Base-T and 100Base-TX subsystems.
This arrangement results in one device that uses the same external magnetic for both the
10Base-T and the 100Base-TX transmission with simple RC component connections.
The individually wave-shaped 10Base-T and 100Base-TX transmit signals are
multiplexed in the transmission output driver selection.
3.5.1
Transmit Drivers
The ADM6995L 100Base-TX transmission driver implements MLT-3 translation and
wave-shaping functions. The rise/fall time of the output signal is closely controlled to
conform to the target range specified in the ANSI TP-PMD standard.
ADMtek Inc.
3-5
相關PDF資料
PDF描述
ADM6995 5 PORT 10/100 MB/S SINGLE CHIP ETHIERNET SWITCH CONTROLLER
ADS-930 16-Bit, 500kHz Sampling A/D Converters
ADS-930MC 16-Bit, 500kHz Sampling A/D Converters
ADS-930MM 16-Bit, 500kHz Sampling A/D Converters
ADS-EVAL3 16-Bit, 500kHz Sampling A/D Converters
相關代理商/技術參數
參數描述
ADM6995LAAT1 功能描述:IC SWITCH CNTRLR 10/100 128QFP RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN(6x6) 包裝:* 其它名稱:Q6396337A
ADM6995LAAT1NP 制造商:Infineon Technologies AG 功能描述:SWITCH / PHY
ADM6995LCACT1 制造商:Infineon Technologies AG 功能描述:
ADM6995LCACT1NP 制造商:Infineon Technologies AG 功能描述:SWITCH / PHY
ADM6995LCADT1NP 制造商:Infineon Technologies AG 功能描述:SWITCH / PHY