- 您現在的位置：買賣IC網 > PDF目錄9160 > ADF4151BCPZ (Analog Devices Inc)IC PLL FREQ SYNTHESIZER 32LFCSP PDF資料下載
參數資料
| 型號： | ADF4151BCPZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 18/28頁 |
| 文件大小： | 0K |
| 描述： | IC PLL FREQ SYNTHESIZER 32LFCSP |
| 標準包裝： | 1 |
| 類型： | * |
| PLL： | 是 |
| 輸入： | CMOS，TTL |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:1 |
| 差分 - 輸入:輸出： | 是/無 |
| 頻率 - 最大： | 3.5GHz |
| 除法器/乘法器： | 是/是 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-WFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 32-LFCSP-WQ（5x5） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Data Sheet
ADF4151
Rev. B | Page 25 of 28
INTERFACING
The ADF4151 has a simple SPI-compatible serial interface
for writing to the device. CLK, DATA, and LE control the data
transfer. When LE goes high, the 32 bits that have been clocked
into the appropriate register on each rising edge of CLK are
transferred to the appropriate latch. See Figure 2 for the timing
diagram and Table 5 for the register address table.
ADuC812 Interface
Figure 30 shows the interface between the ADF4151 and the
on an 8051 core, this interface can be used with any 8051-based
microcontroller. The MicroConverter is set up for SPI master
mode with CPHA = 0. To initiate the operation, the I/O port
driving LE is brought low. Each latch of the ADF4151 needs a
32-bit word, which is accomplished by writing four 8-bit bytes
from the MicroConverter to the device. When the fourth byte
has been written, the LE input should be brought high to
complete the transfer.
ADuC812
ADF4151
CLK
DATA
LE
CE
MUXOUT
(LOCK DETECT)
SCLOCK
MOSI
I/O PORTS
10265-
030
Figure 30. ADuC812 to ADF4151 Interface
I/O port lines on the ADuC812 are also used to control power-
down (CE input) and detect lock (MUXOUT configured as
lock detect and polled by the port input). When operating in
the described mode, the maximum SCLOCK rate of the
ADuC812 is 4 MHz. This means that the maximum rate at
which the output frequency can be changed is 125 kHz.
Blackfin BF527 Interface
Figure 31 shows the interface between the ADF4151 and the
Blackfin ADSP-BF527 digital signal processor (DSP). The
ADF4151 needs a 32-bit serial word for each latch write. The
easiest way to accomplish this using the Blackfin family is to use
the autobuffered transmit mode of operation with alternate
framing. This provides a means for transmitting an entire block
of serial data before an interrupt is generated. Set up the word
length for eight bits and use four memory locations for each
32-bit word. To program each 32-bit latch, store the four 8-bit
bytes, enable the autobuffered mode, and write to the transmit
register of the DSP. This last operation initiates the autobuffer
transfer. As in the microcontroller case, just make sure that the
clock speeds are within the maximum limits outlined in Table 2.
ADSP-BF527
ADF4151
CLK
DATA
LE
CE
MUXOUT
(LOCK DETECT)
SCLK
MOSI
GPIO
I/O FLAGS
10265-
031
Figure 31. ADSP-BF527 to ADF4151 Interface
PCB DESIGN GUIDELINES FOR CHIP SCALE
PACKAGE
The lands on the chip scale package (CP-32-7) are rectangular.
The PCB pad for these must be 0.1 mm longer than the package
land length and 0.05 mm wider than the package land width.
The land is to be centered on the pad. This ensures that the
solder joint size is maximized. The bottom of the chip scale
package has a central thermal pad.
The thermal pad on the PCB must be at least as large as the
exposed pad. On the PCB, there is to be a minimum clearance
of 0.25 mm between the thermal pad and the inner edges of the
pad pattern. This ensures that shorting is avoided.
Thermal vias can be used on the PCB thermal pad to improve
the thermal performance of the package. If vias are used, they
are to be incorporated in the thermal pad at 1.2 mm pitch grid.
The via diameter must be between 0.3 mm and 0.33 mm, and
the via barrel must be plated with one ounce copper to plug
the via.
相關PDF資料 |
PDF描述 |
|---|---|
| MS27467P17A6SA | CONN PLUG 6POS STRAIGHT W/SCKT |
| ADF4154BCPZ | IC FRACTION-N FREQ SYNTH 20LFCSP |
| MS27473E20F2S | CONN PLUG 65POS STRAIGHT W/SCKT |
| ADF4150BCPZ | IC PLL SYNTHESIZER 24-LFCSP |
| MS27472P24B35P | CONN RCPT 128POS WALL MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4151BCPZ-RL7 | 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
| ADF4152HVBCPZ | 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:在售 類型:* PLL:是 輸入:CMOS 輸出:時鐘 電路數:1 比率 - 輸入:輸出:2:2 差分 - 輸入:輸出:是/無 頻率 - 最大值:5GHz 分頻器/倍頻器:是/是 電壓 - 電源:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:32-VFQFN 裸露焊盤，CSP 供應商器件封裝:32-LFCSP-VQ（5x5） 標準包裝:1 |
| ADF4152HVBCPZ-RL7 | 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP 制造商:analog devices inc. 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:* PLL:是 輸入:CMOS 輸出:時鐘 電路數:1 比率 - 輸入:輸出:2:2 差分 - 輸入:輸出:是/無 頻率 - 最大值:5GHz 分頻器/倍頻器:是/是 電壓 - 電源:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:32-VFQFN 裸露焊盤，CSP 供應商器件封裝:32-LFCSP-VQ（5x5） 標準包裝:1 |
| ADF4153 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Fractional-N Frequency Synthesizer |
| ADF4153ABCPZ | 制造商:Analog Devices 功能描述:SINGLE RF F-N PLL 制造商:Analog Devices 功能描述:SINGLE RF F-N PLL - Trays 制造商:Analog Devices 功能描述:IC PLL FREQ SYNTHESIZER 20-LFCSP 制造商:Analog Devices 功能描述:IC FREQ SYNTHESIZER 4GHZ 20 制造商:Analog Devices 功能描述:IC, FREQ SYNTHESIZER, 4GHZ, 20LFCSP 制造商:Analog Devices Inc. 功能描述:Phase Locked Loops - PLL Single RF F-N PLL 制造商:Analog Devices 功能描述:PLL SYNTHESIZER, FREQUENCY, 4GHZ, LFCSP-20; PLL Type:Frequency Synthesis; Frequency:4GHz; Supply Current:20mA; Supply Voltage Min:2.7V; Supply Voltage Max:3.3V; Digital IC Case Style:LFCSP; No. of Pins:20; Package / Case:20-LFCSP 制造商:Analog Devices 功能描述:IC, FREQ SYNTHESIZER, 4GHZ, 20LFCSP; Synthesizer Type:Frequency; Frequency:4GHz; Supply Voltage Min:2.7V; Supply Voltage Max:3.3V; Supply Current:20mA; Digital IC Case Style:LFCSP; No. of Pins:20; Operating Temperature Min:-40C; ;RoHS Compliant: Yes 制造商:Analog Devices 功能描述:PLL SYNTHESIZER, FREQUENCY, 4GHZ, LFCSP-20; PLL Type:Frequency Synthesis; Frequency:4GHz; Supply Current:20mA; Supply Voltage Min:2.7V; Supply Voltage Max:3.3V; Digital IC Case Style:LFCSP; No. of Pins:20; Package / Case:20-LFCSP ;RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。