參數資料
型號: ADF4151BCPZ
廠商: Analog Devices Inc
文件頁數: 16/28頁
文件大小: 0K
描述: IC PLL FREQ SYNTHESIZER 32LFCSP
標準包裝: 1
類型: *
PLL:
輸入: CMOS,TTL
輸出: 時鐘
電路數: 1
比率 - 輸入:輸出: 2:1
差分 - 輸入:輸出: 是/無
頻率 - 最大: 3.5GHz
除法器/乘法器: 是/是
電源電壓: 3 V ~ 3.6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 32-WFQFN 裸露焊盤,CSP
供應商設備封裝: 32-LFCSP-WQ(5x5)
包裝: 托盤
Data Sheet
ADF4151
Rev. B | Page 23 of 28
Reference Spurs
Reference spurs are generally not a problem in fractional-N
synthesizers because the reference offset is far outside the loop
bandwidth. However, any reference feedthrough mechanism
that bypasses the loop can cause a problem. Feedthrough of low
levels of on-chip reference switching noise, through the RFIN
pin back to the VCO, can result in reference spur levels as high
as 90 dBc. PCB layout must ensure adequate isolation between
VCO traces and the input reference to avoid a possible
feedthrough path on the board.
SPUR CONSISTENCY AND FRACTIONAL SPUR
OPTIMIZATION
With dither off, the fractional spur pattern due to the quanti-
zation noise of the SDM also depends on the particular phase
word with which the modulator is seeded.
The phase word can be varied to optimize the fractional and
subfractional spur levels on any particular frequency. Thus, a
look-up table of phase values corresponding to each frequency
can be constructed for use when programming the ADF4151.
If a look-up table is not used, keep the phase word at a constant
value to ensure consistent spur levels on any particular frequency.
PHASE RESYNC
The output of a fractional-N PLL can settle to any one of the
MOD phase offsets with respect to the input reference, where
MOD is the fractional modulus. The phase resync feature in the
ADF4151 produces a consistent output phase offset with respect
to the input reference. This is necessary in applications where the
output phase and frequency are important, such as digital beam
forming. See the Phase Programmability section for how to
program a specific RF output phase when using phase resync.
Phase resync is enabled by setting Bit DB16, Bit DB15 in
Register 3 to 1, 0. When phase resync is enabled, an internal
timer generates sync signals at intervals of tSYNC given by the
following formula:
tSYNC = CLK_DIV_VALUE × MOD × tPFD
where:
CLK_DIV_VALUE is the decimal value programmed in
Bits[DB14:DB3] of Register 3 and can be any integer in the
range of 1 to 4095.
MOD is the modulus value programmed in Bits[DB14:DB3] of
Register 1 (R1).
tPFD is the PFD reference period.
When a new frequency is programmed, the second sync pulse
after the LE rising edge is used to resynchronize the output
phase to the reference. The tSYNC time must be programmed to
a value that is at least as long as the worst-case lock time. This
guarantees that the phase resync occurs after the last cycle slip
in the PLL settling transient.
In the example shown in Figure 28, the PFD reference is
25 MHz and MOD is 125 for a 200 kHz channel spacing. tSYNC
is set to 400 s by programming the clock divider value,
CLK_DIV_VALUE, to 80.
10265-
028
LE
PHASE
FREQUENCY
SYNC
(INTERNAL)
–100
0
100
200
1000
300
400
500
600
700
800
900
TIME (s)
PLL SETTLES TO
CORRECT PHASE
AFTER RESYNC
tSYNC
LAST CYCLE SLIP
PLL SETTLES TO
INCORRECT PHASE
Figure 28. Phase Resync Example
Phase Programmability
The phase word in Register 1 controls the RF output phase. As
this word is swept from 0 to MOD, the RF output phase sweeps
over a 360° range in steps of 360°/MOD.
相關PDF資料
PDF描述
MS27467P17A6SA CONN PLUG 6POS STRAIGHT W/SCKT
ADF4154BCPZ IC FRACTION-N FREQ SYNTH 20LFCSP
MS27473E20F2S CONN PLUG 65POS STRAIGHT W/SCKT
ADF4150BCPZ IC PLL SYNTHESIZER 24-LFCSP
MS27472P24B35P CONN RCPT 128POS WALL MNT W/PINS
相關代理商/技術參數
參數描述
ADF4151BCPZ-RL7 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器,PLL,頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML,PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤,16-MLF? 供應商設備封裝:16-MLF?(3x3) 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND
ADF4152HVBCPZ 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:在售 類型:* PLL:是 輸入:CMOS 輸出:時鐘 電路數:1 比率 - 輸入:輸出:2:2 差分 - 輸入:輸出:是/無 頻率 - 最大值:5GHz 分頻器/倍頻器:是/是 電壓 - 電源:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:32-VFQFN 裸露焊盤,CSP 供應商器件封裝:32-LFCSP-VQ(5x5) 標準包裝:1
ADF4152HVBCPZ-RL7 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP 制造商:analog devices inc. 系列:- 包裝:剪切帶(CT) 零件狀態:在售 類型:* PLL:是 輸入:CMOS 輸出:時鐘 電路數:1 比率 - 輸入:輸出:2:2 差分 - 輸入:輸出:是/無 頻率 - 最大值:5GHz 分頻器/倍頻器:是/是 電壓 - 電源:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:32-VFQFN 裸露焊盤,CSP 供應商器件封裝:32-LFCSP-VQ(5x5) 標準包裝:1
ADF4153 制造商:AD 制造商全稱:Analog Devices 功能描述:Fractional-N Frequency Synthesizer
ADF4153ABCPZ 制造商:Analog Devices 功能描述:SINGLE RF F-N PLL 制造商:Analog Devices 功能描述:SINGLE RF F-N PLL - Trays 制造商:Analog Devices 功能描述:IC PLL FREQ SYNTHESIZER 20-LFCSP 制造商:Analog Devices 功能描述:IC FREQ SYNTHESIZER 4GHZ 20 制造商:Analog Devices 功能描述:IC, FREQ SYNTHESIZER, 4GHZ, 20LFCSP 制造商:Analog Devices Inc. 功能描述:Phase Locked Loops - PLL Single RF F-N PLL 制造商:Analog Devices 功能描述:PLL SYNTHESIZER, FREQUENCY, 4GHZ, LFCSP-20; PLL Type:Frequency Synthesis; Frequency:4GHz; Supply Current:20mA; Supply Voltage Min:2.7V; Supply Voltage Max:3.3V; Digital IC Case Style:LFCSP; No. of Pins:20; Package / Case:20-LFCSP 制造商:Analog Devices 功能描述:IC, FREQ SYNTHESIZER, 4GHZ, 20LFCSP; Synthesizer Type:Frequency; Frequency:4GHz; Supply Voltage Min:2.7V; Supply Voltage Max:3.3V; Supply Current:20mA; Digital IC Case Style:LFCSP; No. of Pins:20; Operating Temperature Min:-40C; ;RoHS Compliant: Yes 制造商:Analog Devices 功能描述:PLL SYNTHESIZER, FREQUENCY, 4GHZ, LFCSP-20; PLL Type:Frequency Synthesis; Frequency:4GHz; Supply Current:20mA; Supply Voltage Min:2.7V; Supply Voltage Max:3.3V; Digital IC Case Style:LFCSP; No. of Pins:20; Package / Case:20-LFCSP ;RoHS Compliant: Yes