- 您現在的位置：買賣IC網 > PDF目錄1980 > AD7298BCPZ-RL7 (Analog Devices Inc)IC ADC 10BIT SPI/SRL 8CH 20LFCSP PDF資料下載
參數資料
| 型號： | AD7298BCPZ-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 7/25頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 10BIT SPI/SRL 8CH 20LFCSP |
| 標準包裝： | 1 |
| 位數： | 12 |
| 采樣率（每秒）： | 1M |
| 數據接口： | DSP，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 22.7mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-WFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 20-LFCSP-WQ（4x4） |
| 包裝： | 標準包裝 |
| 輸入數目和類型： | 8 個單端，單極 |
| 其它名稱： | AD7298BCPZ-RL7DKR |
AD7298
Rev. B | Page 14 of 24
111...111
111...110
111...000
011...111
000...010
000...001
000...000
1LSB = VREF/4096
ANALOG INPUT
NOTES
1. VREF IS 2.5V.
AD
C
O
D
E
+VREF –1LSB
1LSB
0V
08754-007
Figure 23. Straight Binary Transfer Characteristic
TEMPERATURE SENSOR OPERATION
The AD7298 contains one local temperature sensor. The
on-chip, band gap temperature sensor measures the temp-
erature of the AD7298 die.
The temperature sensor module on the AD7298 is based on
the three-current principle (see Figure 24), where three currents
are passed through a diode and the forward voltage drop is
measured, allowing the temperature to be calculated free of
errors caused by series resistance.
I4 × I
INTERNAL
SENSE
TRANSISTOR
BIAS
DIODE
VDD
8 × I
IBIAS
VOUT+
VOUT–
TO ADC
0
875
4-
00
8
Figure 24. Top-Level Structure of Internal Temperature Sensor
The temperature conversion consists of two phases, the integra-
tion followed by the conversion. The integration is initiated on
the CS falling edge. It takes a period of approximately 100 μs to
complete the integration and conversion of the temperature
result. When the integration is completed, the conversion is
initiated automatically. Once the temperature integration is
initiated, the TSENSE_BUSY signal goes high to indicate that a
temperature conversion is in progress and remains high until
the conversion is completed.
Theoretically, the temperature measuring circuit can measure
temperatures from –512°C to +511°C with a resolution of
0.25°C. However, temperatures outside TA (the specified
temperature range for the AD7298) are outside the guaranteed
operating temperature range of the device. The temperature
sensor is selected by setting the TSENSE bit in the control register.
TEMPERATURE SENSOR AVERAGING
The AD7298 incorporates a temperature sensor averaging
feature to enhance the accuracy of the temperature measure-
ments. To enable the temperature sensor averaging feature, both
the TSENSEAVG bit and the TSENSE bit must be enabled in the
control register. In this mode the temperature is internally
averaged to reduce the effect of noise on the temperature result.
The temperature is measured each time a TSENSE conversion is
performed and a moving average method is used to determine
the result in the TSENSE Result Register. The average result is
given by the following equation:
()
Result
Current
Result
Average
Previous
AVG
T
SENSE
_
8
1
_
8
7
+
=
The TSENSE result read when averaging is enabled is the
TSENSEAVG result, a moving average temperature measurement.
The first TSENSE conversion result given by the AD7298 after the
temperature sensor and averaging mode has been selected in
the control register (Bit D1 and Bit D5) is the actual first TSENSE
conversion result. If the control register is written to and the
content of the TSENSEAVG bit changed, the averaging function is
reset and the next TSENSE average conversion result is the current
temperature conversion result. If the status of the TSENSEAVG bit
is not changed on successive writes to the control register, the
averaging function is reinitialized and continues calculating the
cumulative average.
The user has the option of disabling the averaging by setting
Bit TSENSEAVG to 0 in the control register. The AD7298 defaults
on power-up with the averaging function disabled. The total
time to measure a temperature channel is typically 100 μs.
相關PDF資料 |
PDF描述 |
|---|---|
| AD7302BRUZ-REEL7 | IC DAC 8BIT DUAL R-R 20-TSSOP |
| AD7303BRM | IC DAC 8BIT DUAL R-R 8-MSOP |
| AD7305BRU | IC DAC 8BIT QUAD R-R 20-TSSOP |
| AD7321BRUZ-REEL7 | IC ADC 12BIT+ SAR 2CHAN 14TSSOP |
| AD7322BRUZ-REEL7 | IC ADC 12BIT+ SAR 2CHAN 14TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD73 | 制造商:Distributed By MCM 功能描述:REFRIGERATR DOOR GASKET DIRECT |
| AD7302 | 制造商:AD 制造商全稱:Analog Devices 功能描述:2.7 V to 5.5 V, Parallel Input Dual Voltage Output 8-Bit DAC |
| AD7302BN | 功能描述:IC DAC 8BIT DUAL R-R 20-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| AD7302BNZ | 功能描述:IC DAC 8BIT DUAL R-R 20-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF) |
| AD7302BR | 功能描述:IC DAC 8BIT DUAL 2.7V 20-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。