參數資料
型號： 935270057557
廠商： NXP SEMICONDUCTORS
元件分類： 微控制器/微處理器
英文描述： 4 CHANNEL(S), 5M bps, SERIAL COMM CONTROLLER, PQFP80
封裝： 12 X 12 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-315-1, LQFP-80
文件頁數： 3/52頁
文件大小： 680K
代理商： 935270057557
Philips Semiconductors
SC16C754
Quad UART with 64-byte FIFO
Product data
Rev. 02 — 14 March 2003
11 of 49
9397 750 11192
Koninklijke Philips Electronics N.V. 2003. All rights reserved.
Remark: When using software ow control, the Xon/Xoff characters cannot be used
for data characters.
There are two other enhanced features relating to software ow control:
Xon Any function (MCR[5]): Operation will resume after receiving any character
after recognizing the Xoff character. It is possible that an Xon1 character is
recognized as an Xon Any character, which could cause an Xon2 character to be
written to the RX FIFO.
Special character (EFR[5]): Incoming data is compared to Xoff2. Detection of the
special character sets the Xoff interrupt (IIR[4]) but does not halt transmission. The
Xoff interrupt is cleared by a read of the IIR. The special character is transferred to
the RX FIFO.
6.3.1
RX
When software ow control operation is enabled, the SC16C754 will compare
incoming data with Xoff1,2 programmed characters (in certain cases, Xoff1 and Xoff2
must be received sequentially). When the correct Xoff character are received,
transmission is halted after completing transmission of the current character. Xoff
detection also sets IIR[4] (if enabled via IER[5]) and causes INT to go HIGH.
To resume transmission, an Xon1,2 character must be received (in certain cases
Xon1 and Xon2 must be received sequentially). When the correct Xon characters are
received, IIR[4] is cleared, and the Xoff interrupt disappears.
6.3.2
TX
Xoff1/2 character is transmitted when the RX FIFO has passed the HALT trigger level
programmed in TCR[3:0].
Xon1/2 character is transmitted when the RX FIFO reaches the RESUME trigger
level programmed in TCR[7:4].
The transmission of Xoff/Xon(s) follows the exact same protocol as transmission of
an ordinary byte from the FIFO. This means that even if the word length is set to be 5,
6, or 7 characters, then the 5, 6, or 7 least signicant bits of Xoff1,2/Xon1,2 will be
transmitted. (Note that the transmission of 5, 6, or 7 bits of a character is seldom
done, but this functionality is included to maintain compatibility with earlier designs.)
X
0
no receive ow control
X
1
0
receiver compared Xon1, Xoff1
X
0
1
receiver compares Xon2, Xoff2
1011transmit Xon1, Xoff1
receiver compares Xon1 and Xon2, Xoff1 and Xoff2
0111transmit Xon2, Xoff2
receiver compares Xon1 and Xon2, Xoff1 and Xoff2
1111transmit Xon1, Xon2, Xoff1, Xoff2
receiver compares Xon1 and Xon2, Xoff1 and Xoff2
Table 3:
Software ow control options (EFR[0:3])…continued
EFR[3]
EFR[2]
EFR[1]
EFR[0]
TX, RX software ow controls
相關PDF資料
PDF描述
935270056512 4 CHANNEL(S), 5M bps, SERIAL COMM CONTROLLER, PQCC68
935270071112 1 CHANNEL(S), 3M bps, SERIAL COMM CONTROLLER, PDIP40
935270058512 1 CHANNEL(S), 3M bps, SERIAL COMM CONTROLLER, PQCC44
935270058518 1 CHANNEL(S), 3M bps, SERIAL COMM CONTROLLER, PQCC44
935270070151 1 CHANNEL(S), 3M bps, SERIAL COMM CONTROLLER, PQFP48
相關代理商/技術參數
參數描述
935270713557 制造商:NXP Semiconductors 功能描述:SUB ONLY IC CHP
935270792551 制造商:NXP Semiconductors 功能描述:IC BUFF DVR TRI-ST 16BIT 56VFBGA
935270792557 制造商:NXP Semiconductors 功能描述:IC BUFF DVR TRI-ST 16BIT 56VFBGA
935270793551 制造商:NXP Semiconductors 功能描述:IC BUS TRCVR 3-ST 16BIT 56VFBGA
935270793557 制造商:NXP Semiconductors 功能描述:IC BUS TRCVR 3-ST 16BIT 56VFBGA
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*