參數資料
型號： 73S1217F-68M/F/PE
廠商： Maxim Integrated
文件頁數： 5/140頁
文件大?。?/td> 0K
描述： IC SOC SMART CARD READER 68QFN
標準包裝： 260
系列： *
73S1217F Data Sheet
DS_1217F_002
Protocol Mode Register (SPrtcol): 0xFE0D
0x03
This register determines the protocol to be use when communicating with the selected smart card. This
register should be updated as required when switching between smart card interfaces.
Table 92: The SPrtcol Register
MSB
LSB
SCISYN
MOD9/8B SCESYN
0
TMODE
CRCEN
CRCMS RCVATR
Bit
Symbol
Function
SPrtcol.7
SCISYN
Smart Card Internal Synchronous mode – Configures internal smart card
interface for synchronous mode. This mode routes the internal interface
buffers for RST, IO, C4, C8 to SCCtl register bits for direct firmware control.
CLK is generated by the ETU counter.
SPrtcol.6
MOD9/8B
Synchronous 8/9 bit mode select – For sync mode, in protocols with 9-bit
words, set this bit. The first eight bits read go into the RX FIFO and the
ninth bit read will be stored in the IO (or SIO) data bit of the SRXCtl
register.
SPrtcol.5
SCESYN
Smart Card External Synchronous mode – Configures External Smart Card
interface for synchronous mode. This mode routes the external smart card
interface buffers for SIO to SCECtl register bits for direct firmware control.
SCLK is generated by the ETU counter.
SPrtcol.4
0
Reserved bit, must always be set to 0.
SPrtcol.3
TMODE
Protocol mode select – 0: T=0, 1: T=1. Determines which smart card
protocol is to be used during message processing.
SPrtcol.2
CRCEN
CRC Enable – 1 = Enabled, 0 = Disabled. Enables the
checking/generation of CRC/LRC while in T=1 mode. Has no effect in T=0
mode. If enabled and a message is being transmitted to the smart card,
the CRC/LRC will be inserted into the message stream after the last TX
byte is transmitted to the smart card. If enabled, CRC/LRC will be checked
on incoming messages and the value made available to the firmware via
the CRC LS/MS registers.
SPrtcol.1
CRCMS
CRC Mode Select – 1 = CRC, 0 = LRC. Determines type of checking
algorithm to be used.
SPrtcol.0
RCVATR
Receive ATR – 1 = Enable ATR timeout, 0 = Disable ATR timeout. Set by
firmware after the smart card has been turned on and the hardware is
expecting ATR.
102
Rev. 1.2
相關PDF資料
PDF描述
73S1210F-68M/F/PH IC SOC SMART CARD READER 68QFN
73S1210F-68M/F/PG IC SOC SMART CARD READER 68QFN
73S1210F-68MR/F/PH IC SOC SMART CARD READER 68QFN
FQD1N80TM MOSFET N-CH 800V 1A DPAK
73S1210F-68MR/F/PG IC SOC SMART CARD READER 68QFN
相關代理商/技術參數
參數描述
73S1217F-68MR/F/PE 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
73S1217F-EB 功能描述:開發板和工具包 - 8051 73S1217F Eval Brd (Usb Cable, Doc. Cd) RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓:
73S1217F-EB-Lite 功能描述:開發板和工具包 - 8051 73S1217F EVB Lite w/Plug & Play/Usb RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓:
73S1217F-IMR/F 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:Bus-Powered 80515 System-on-Chip with USB, ISO 7816 / EMV, PINpad and More
73S13B 制造商:QUARTZCOM 制造商全稱:QUARTZCOM the communications company 功能描述:-20 ~ +70 °C commercia l application -30 ~ +75 °C on request
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*