- 您現在的位置：買賣IC網 > PDF目錄1976 > XRT73R12IB-L (Exar Corporation)IC LIU E3/DS3/STS-1 12CH 420TBGA PDF資料下載
參數資料
| 型號： | XRT73R12IB-L |
| 廠商： | Exar Corporation |
| 文件頁數： | 44/89頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIU E3/DS3/STS-1 12CH 420TBGA |
| 標準包裝： | 40 |
| 類型： | 線路接口裝置（LIU） |
| 驅動器/接收器數： | 12/12 |
| 規程： | DS3，E3，STS-1 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 420-LBGA 裸露焊盤 |
| 供應商設備封裝： | 420-TBGA（35x35） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁當前第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁
XRT73R12
46
REV. 1.0.3
TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
7.1
THE MICROPROCESSOR INTERFACE BLOCK SIGNALS
The LIU may be configured into different operating modes and have its performance monitored by software
through a standard microprocessor using data, address and control signals. These interface signals are de-
scribed below in Table 14. The microprocessor interface can be configured to operate in Asynchronous mode
or Synchronous mode.
TABLE 14: XRT73R12 MICROPROCESSOR INTERFACE SIGNALS
PIN NAME
TYPE
DESCRIPTION
Pmode
I
Microprocessor Interface Mode Select Input pin
This pin is used to specify the microprocessor interface mode.
D[7:0]
I/O
Bi-Directional Data Bus for register "Read" or "Write" Operations.
Addr[7:0]
I
Eight-Bit Address Bus Inputs
The XRT73R12 LIU microprocessor interface uses a direct address bus. This address bus is
provided to permit the user to select an on-chip register for Read/Write access.
CS
I
Chip Select Input
This active low signal selects the microprocessor interface of the XRT73R12 LIU and enables
Read/Write operations with the on-chip register locations.
RD
I
Read Signal This active low input functions as the read signal from the local
P. When this
pin is pulled “Low” (if CS is “Low”) the LIU is informed that a read operation has been
requested and begins the process of the read cycle.
WR
I
Write Signal This active low input functions as the write signal from the local
P. When this
pin is pulled “Low” (if CS is “Low”) the LIU is informed that a write operation has been
requested and begins the process of the write cycle.
RDY
O
Ready Output This active low signal is provided by the LIU device. It indicates that the cur-
rent read or write cycle is complete, and the LIU is waiting for the next command.
INT
O
Interrupt Output This active low signal is provided by the LIU to alert the local mP that a
change in alarm status has occured. This pin is Reset Upon Read (RUR) once the alarm sta-
tus registers have been cleared.
RESET
I
Reset Input This active low input pin is used to Reset the LIU.
相關PDF資料 |
PDF描述 |
|---|---|
| XRT75L00DIV-F | IC LIU E3/DS3/STS-1 SGL 52TQFP |
| XRT75L00IV-F | IC LIU E3/DS3/STS-1 SGL 52TQFP |
| XRT75L02DIV-F | IC LIU E3/DS3/STS-1 2CH 100TQFP |
| XRT75L03DIV-F | IC LIU E3/DS3/STS-1 3CH 128LQFP |
| XRT75L03IV-F | IC LIU E3/DS3/STS-1 3CH 128LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT74L73 | 制造商:EXAR 制造商全稱:EXAR 功能描述:3 CHANNEL, ATM UNI/PPP DS3/E3 FRAMING CONTROLLER |
| XRT74L73IB | 制造商:EXAR 制造商全稱:EXAR 功能描述:3 CHANNEL, ATM UNI/PPP DS3/E3 FRAMING CONTROLLER |
| XRT74L74 | 制造商:EXAR 制造商全稱:EXAR 功能描述:4 CHANNEL, ATM UNI/PPP DS3/E3 FRAMING CONTROLLER |
| XRT74L74IB | 制造商:EXAR 制造商全稱:EXAR 功能描述:4 CHANNEL, ATM UNI/PPP DS3/E3 FRAMING CONTROLLER |
| XRT75L00 | 制造商:EXAR 制造商全稱:EXAR 功能描述:E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR |
發布緊急采購，3分鐘左右您將得到回復。