參數資料
型號： TPIC8300IPWRQ1
廠商： TEXAS INSTRUMENTS INC
元件分類： 模擬信號調理
英文描述： SPECIALTY ANALOG CIRCUIT, PDSO16
封裝： PLASTIC, TSSOP-16
文件頁數： 44/47頁
文件大小： 546K
代理商： TPIC8300IPWRQ1
SLDS171 – NOVEMBER 2009
www.ti.com
DETAILED FUNCTIONAL DESCRIPTION
Pre-Amplifier (Front End)
Due to initial large offset in the pressure sensor output, the analog front end has an offset correction as needed.
Fault Detection
Sensor inputs SIP, SIN
The following faults are detected and a fault bit set in a register. The minimum fault detection filter time is 5 ms.
There are 1-
μA pulldown current source on the SIP and SIN terminals. Fault detection capabilities of this device
are for both SIP and SIN sensor inputs. The following type of faults are reported and sent to the DIAG bits.
Shorts to Vcc
Shorts to Gnd
Open piezo-resistive or strain gauge (i.e., open-circuit between SIP and SIN inputs)
ADC
The ADC is a 14-bit with resolution of ±3 LSB (10 bit).
Digital I/O
I/O data transfer via DI/DO pins.
Refer to data format communications between microprocessor to IC: Mode selection (microprocessor
→ IC)
chart.
DI/DO interface become active only when specified data format and protocol are used.
Start bit is used to initiate the communication: DI/DO repeats Rx-Tx-Rx-Tx, to realize one pin Tx-Rx
communication. When sensor, temperature, diagnostics, and trimming data are requested, DI/DO remain in
Rx mode until all frames are sent.
DI/DO output current capability is 5 mA at low level.
Memory
EEPROM : Read/Write cycle is less than 25 times
Data retention: 15 years at 90°C
Data fault detection (CRC8)
Fault write/erase prevention
EEROM Write
Generate programming voltage after receiving the write RQ.
Output Diag during the write
EEROM write sequence
1. Send data to appropriate bank or field
2. Send WE = 1
(a) Calculate new CRC
(b) Set charge pump on
(c) Reload all registers from EEPROM
(d) Check CRC value
3. Read Diag register to confirm PROG_OK = 1
4. Send WE = 0 (
≥ 15 ms must elapse for write sequence to complete before microprocessor can disable
EEPROM write)
6
Copyright 2009, Texas Instruments Incorporated
Product Folder Link(s): TPIC83000-Q1
相關PDF資料
PDF描述
TPIC9201PWPR 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20
TPIC9201N 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDIP20
TPL0102-100PWR DIGITAL POTENTIOMETER, PDSO14
TPL0102-100RUCR DIGITAL POTENTIOMETER, PQCC14
TPL0202-10MRTER DIGITAL POTENTIOMETER, PQCC16
相關代理商/技術參數
參數描述
TPIC83R00QRHHRQ1 制造商:Texas Instruments 功能描述:- Tape and Reel
TPIC84000-Q1 制造商:TI 制造商全稱:Texas Instruments 功能描述:LOW-FREQUENCY ANTENNA DRIVER FOR PASSIVE START AND PASSIVE ENTRY
TPIC84000TPWPRQ1 功能描述:RFID應答器 AC Low-Freq MultiCh Antenna Driver RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel
TPIC84125-Q1 制造商:TI 制造商全稱:Texas Instruments 功能描述:LOW-FREQUENCY ANTENNA DRIVER FOR PASSIVE START AND PASSIVE ENTRY
TPIC84125TPWPRQ1 功能描述:RFID應答器 AC Low-Freq Antenna Driver RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*