
20.3
Functions
The 10-bit AD converter operates in either single mode in which AD conversion is performed only once or repeat
mode in which AD conversion is performed repeatedly.
20.3.1
Single mode
In single mode, the voltage at a designated analog input pin is AD converted only once.
Setting ADCCR1<ADRS> to "1" after setting ADCCR1<AMD> to "01" allows AD conversion to start.
ADCCR1<ADRS> is automatically cleared after the start of AD conversion. As AD conversion starts,
ADCCR2<ADBF> is set to "1". It is cleared to "0" if AD conversion is finished or if AD conversion is forced to
stop.
After AD conversion is finished, the conversion result is stored in the AD converted value registers (ADCDRL
and ADCDRH), ADCCR2<EOCF> is set to "1", and the AD conversion finished interrupt (INTADC) is gener-
ated. The AD converted value registers (ADCDRL and ADCDRH) should be usually read according to the
INTADC interrupt processing routine. If the upper side (ADCDRH) of the AD converted value register is read,
ADCCR2<EOCF> is cleared to "0".
Note:Do not perform the following operations on the ADCCR1 register when AD conversion is being executed
(ADCCR2<ADBF>="1"). If the following operations are performed, there is the possibility that AD con-
version may not be executed properly.
·
Changing the ADCCR1<SAIN> setting
·
Setting ADCCR1<AINEN> to "0"
·
Changing the ADCCR1<AMD> setting (except a forced stop by setting AMD to "00")
·
Setting ADCCR1<ADRS> to "1"
Status of ADCDRL
and ADCDRH
Clearing EOCF based on
the conversion result
Read of conversion result
ADCCR2<EOCF>
INTADC interrupt
request
ADCCR2<ADBF>
ADCCR1<ADRS>
Result of the first conversion
Result of the second conversion
Indeterminate
AD conversion start
Read of ADCDRH
Read of ADCDRL
Figure 20-2 Single Mode
20.3.2
Repeat mode
In repeat mode, the voltage at an analog input pin designated at ADCCR1<SAIN> is AD converted repeatedly.
Setting ADCCR1<ADRS> to "1" after setting ADCCR1<AMD> to "11" allows AD conversion to start. After
the start of AD conversion, ADCCR1<ADRS> is automatically cleared. After the first AD conversion is finished,
the conversion result is stored in the AD converted value registers (ADCDRL and ADCDRH), ADCCR2<EOCF>
is set to "1", and the AD conversion finished interrupt (INTADC) is generated. After this interrupt is generated,
the second (next) AD conversion starts immediately.
TMP89FH46L
20. 10-bit AD Converter (ADC)
20.3
Functions
Page 310
RA002