- 您現在的位置：買賣IC網 > PDF目錄384982 > TLC34075-135 (Texas Instruments, Inc.) Video Interface Palette PDF資料下載
參數資料
| 型號： | TLC34075-135 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | Video Interface Palette |
| 中文描述： | 視頻接口面板 |
| 文件頁數： | 44/52頁 |
| 文件大?。?/td> | 284K |
| 代理商： | TLC34075-135 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁當前第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
B
–
1
Appendix B
PC Board Layout Considerations
PC Board Considerations
A four-layer PC board should be used with the TLC34075: one layer each for 5-V power and GND and two
layers for signals. The layout should be optimized for the lowest-possible noise on the TLC34075 power and
ground lines by shielding the digital inputs and providing good decoupling. The lead length between groups
of V
DD
and GND pins should be minimized so as to reduce inductive ringing. The terminal assignments for
the TLC34075 P<0:31> inputs were selected for minimum interconnect lengths between these inputs and
the VRAM pixel data outputs. The TLC34075 should be located as close to the output connectors as
possible to minimize noise pickup and reflections due to impedance mismatching.
Ground Plane
A single ground plane is recommended for both the TLC34075 and the rest of the logic. Separate digital and
analog ground planes are not needed.
Power Plane
Split power planes are recommended for the TLC34075 and the rest of the logic. The TLC34075 and its
associated analog circuitry should have their own power plane (referred to as A
VCC
in Figure 18). The two
power planes should be connected at a single point through a ferrite bead as shown in Figures 18, 19, and
20. This bead should be located within three inches of the TLC34075.
Supply Decoupling
Bypass capacitors should be installed using the shortest leads possible, consistent with reliable operation,
to reduce the lead inductance.
For the best performance, a 0.1-
μ
F ceramic capacitor in parallel with a 0.01-
μ
F chip capacitor should be
used to decouple each of the three groups of power pins to GND. These capacitors should be placed as
close as possible to the device as shown in Figure 19.
If a switching power supply is used, the designer should pay close attention to reducing power supply noise
and should consider using a three-terminal voltage regulator for supplying power to A
VCC
.
COMP and V
REF
Terminals
A 100-
resistor and 0.1-
μ
F ceramic capacitor (approximate values) should be connected in series
between the device
’
s COMP and V
DD
terminals in order to avoid noise and color-smearing problems. Also,
whether an internal or external voltage reference is used, a 0.1-
μ
F capacitor should be connected between
the device
’
s V
REF
and GND terminals to further stabilize the video image. These resistor and capacitor
values may vary depending on the board layout; experimentation may be required in order to determine
optimum values.
相關PDF資料 |
PDF描述 |
|---|---|
| TLC34075-66 | Video Interface Palette |
| TLC34075-85 | Video Interface Palette |
| TLC352MFK | LinCMOSE DUAL DIFFERENTIAL COMPARATOR |
| TLC352MJG | LinCMOSE DUAL DIFFERENTIAL COMPARATOR |
| TLC363C20V8 | TRIPLE LOW CAPACITANCE MOUNT ZENER DIODE ARRAY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLC34075-135AFN | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TLC34075-135AFNR | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Video Interface Palette Data Manual |
| TLC34075-135FN | 制造商:Texas Instruments 功能描述:1024 X 768 PIXELS PALETTE-DAC DSPL CTLR, PQCC84 |
| TLC34075-66 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Video Interface Palette |
| TLC34075-66AFN | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。