- 您現在的位置：買賣IC網 > PDF目錄384004 > TLC34058-110M (Texas Instruments, Inc.) 256 ?24 COLOR PALETTE PDF資料下載
參數資料
| 型號： | TLC34058-110M |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 256 ?24 COLOR PALETTE |
| 中文描述： | 256？24調色板 |
| 文件頁數： | 17/21頁 |
| 文件大?。?/td> | 322K |
| 代理商： | TLC34058-110M |
TLC34058-110M
256
×
24 COLOR PALETTE
SGLS075 – JANUARY 1994
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
POST OFFICE BOX 1443
HOUSTON, TEXAS 77251–1443
PRINCIPLES OF OPERATION
frame-buffer interface and timing
An internal latch and multiplexer enables the frame buffer to send the pixel data to the device at TTL rates. On
the rising edges of LD, information for four or five consecutive pixels is latched into the device. This information
includes the palette-RAM address (up to 8 bits), the overlay-register address (up to 2 bits), and the sync and
blank information for each of the four or five consecutive pixels. The timing diagram for this pixel-data input
transfer is shown in Figure 2, along with the video output waveforms (IOR, IOG, and IOB). With this architecture,
the sync and blank timing can only be recognized with four- or five-pixel resolution.
The display-refresh process follows the first-in first-out format. Color data is output from the device in the same
order in which palette RAM and overlay addresses are input. This process continues until all four or five pixels
have been output, at which point the cycle repeats.
The overlay timing can be controlled by the pixel timing; however, this approach requires that the frame buffer
emit additional bit planes to control the overlay selection on a pixel basis. Alternately, the overlay timing can be
controlled by external-character or cursor-generation timing (see the color selection section).
No phase relationship between the LD and CLK signals is required (see Figure 2). Therefore, the LD signal can
be derived by externally dividing the CLK signal by four or five. Any propagation delay in LD caused by the divider
circuitry does not render the device nonfunctional. Regardless of the phase relationship between LD and CLK,
the pixel, overlay, sync, and blank data are latched on the rising edge of LD.
The device has an internal load signal (not brought out to a pin) that is synchronous to CLK and follows LD by
at least one and not more than four clock cycles. This internal load signal transfers the LD-latched data into a
second set of latches, which are then internally multiplexed at the pixel clock or CLK signal frequency.
For 4:1 or 5:1 multiplexing, a rising edge of LD should occur every four or five clock cycles. Otherwise, the
internal load signal generation circuitry cannot lock onto or synchronize with LD.
color selection
The read mask, blink mask, and command registers process eight bits of color information (P0–P7) and two
bits of overlay information (OL0–OL1) for each pixel every clock cycle. Control registers allow individual bit
planes to be enabled/disabled for display and/or blinked at one of four blink rates and duty cycles (see the
command register section, bits CR4–CR5).
By monitoring the BLK input to determine vertical retrace intervals, the device ensures that a color change due
to blinking occurs only during the nonactive display time. A color change does not occur in the middle of the
screen. A vertical retrace is sensed when BLK is low for at least 256 LD cycles. The color information is then
selected from the palette RAM or overlay registers in accordance with the processed input pixel data.
Table 5 presents the effect of the processed input pixel data upon color selection. P0 is the least significant bit
(LSB) of the color-palette RAM. When CR6 is high and both OL1 and OL0 are low, color information resides in
the color-palette RAM. When CR6 is low or either of the overlay inputs is high, the overlay registers provide the
DAC inputs.
相關PDF資料 |
PDF描述 |
|---|---|
| TLC354MD | LinCMOSE QUADRUPLE DIFFERENTIAL COMPARATORS |
| TLC354MN | LinCMOSE QUADRUPLE DIFFERENTIAL COMPARATORS |
| TLC354PW | LinCMOSE QUADRUPLE DIFFERENTIAL COMPARATORS |
| TLC354Y | LinCMOSE QUADRUPLE DIFFERENTIAL COMPARATORS |
| TLC354D | LinCMOSE QUADRUPLE DIFFERENTIAL COMPARATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLC34058-110MGA | 制造商:TI 制造商全稱:Texas Instruments 功能描述:256 x 24 COLOR PALETTE |
| TLC34058-110MGAB | 制造商:TI 制造商全稱:Texas Instruments 功能描述:256 ?? 24 COLOR PALETTE |
| TLC34058-110MHFG | 制造商:TI 制造商全稱:Texas Instruments 功能描述:256 x 24 COLOR PALETTE |
| TLC34058-135FN | 制造商:TI 制造商全稱:Texas Instruments 功能描述:256 ?? 24 COLOR PALETTE |
| TLC34058-80FN | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。