- 您現在的位置：買賣IC網 > PDF目錄382587 > THS6012DWP (Texas Instruments, Inc.) 500-mA DUAL DIFFERENTIAL LINE DRIVER PDF資料下載
參數資料
| 型號： | THS6012DWP |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 500-mA DUAL DIFFERENTIAL LINE DRIVER |
| 中文描述： | 500毫安雙差分線路驅動器 |
| 文件頁數： | 30/35頁 |
| 文件大?。?/td> | 604K |
| 代理商： | THS6012DWP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁
THS6012
500-mA DUAL DIFFERENTIAL LINE DRIVER
SLOS226C– SEPTEMBER 1998 – REVISED FEBRUARY 2000
30
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
ADSL (continued)
The ADSL transmit band consists of 255 separate carrier frequencies each with its own modulation and
amplitude level. With such an implementation, it is imperative that signals put onto the telephone line have as
low a distortion as possible. This is because any distortion either interferes directly with other ADSL carrier
frequencies or it creates intermodulation products that interfere with ADSL carrier frequencies.
The THS6012 has been specifically designed for ultra low distortion by careful circuit implementation and by
taking advantage of the superb characteristics of the complementary bipolar process. Driver single-ended
distortion measurements are shown in Figures 29 – 32. It is commonly known that in the differential driver
configuration, the second order harmonics tend to cancel out. Thus, the dominant total harmonic distortion
(THD) will be primarily due to the third order harmonics. For these tests the load was 25
. Additionally, distortion
should be reduced as the feedback resistance drops. This is because the bandwidth of the amplifier increases,
which allows the amplifier to react faster to any nonlinearities in the closed-loop system.
Another significant point is the fact that distortion decreases as the impedance load increases. This is because
the output resistance of the amplifier becomes less significant as compared to the output load resistance.
general configurations
A common error for the first-time CFB user is to create a unity gain buffer amplifier by shorting the output directly
to the inverting input. A CFB amplifier in this configuration oscillates and is
not
recommended. The THS6012,
like all CFB amplifiers,
must
have a feedback resistor for stable operation. Additionally, placing capacitors
directly from the output to the inverting input is not recommended. This is because, at high frequencies, a
capacitor has a very low impedance. This results in an unstable amplifier and should not be considered when
using a current-feedback amplifier. Because of this, integrators and simple low-pass filters, which are easily
implemented on a VFB amplifier, have to be designed slightly differently. If filtering is required, simply place an
RC-filter at the noninverting terminal of the operational-amplifier (see Figure 49).
VI
VO
C1
+
–
RG
RF
R1
f–3dB
1
2 R1C1
VO
VI
1
RF
RG
1
1
sR1C1
Figure 48. Single-Pole Low-Pass Filter
If a multiple pole filter is required, the use of a Sallen-Key filter can work very well with CFB amplifiers. This is
because the filtering elements are not in the negative feedback loop and stability is not compromised. Because
of their high slew-rates and high bandwidths, CFB amplifiers can create very accurate signals and help minimize
distortion. An example is shown in Figure 50.
相關PDF資料 |
PDF描述 |
|---|---|
| THS6012EVM | 500-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6012IGQE | 500-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6012CGQE | 500-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6022GQE | 250-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6022EVM | 250-mA DUAL DIFFERENTIAL LINE DRIVER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS6012EVM | 功能描述:其他開發工具 THS6012 Hi-Spd Amp Eval Mods RoHS:否 制造商:Parallax 產品:ELEV-8 Hex Upgrade Kits 類型:Robotics 工具用于評估:ELEV-8 Quadcopter 工作電源電壓: |
| THS6012GQE | 制造商:TI 制造商全稱:Texas Instruments 功能描述:500-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6012IDWP | 功能描述:緩沖器和線路驅動器 500-mA Dual Diff Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel |
| THS6012IDWPG4 | 功能描述:緩沖器和線路驅動器 500mA Dual Diff Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel |
| THS6012IDWPR | 功能描述:緩沖器和線路驅動器 500-mA Dual Diff Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。