- 您現在的位置：買賣IC網 > PDF目錄382587 > THS6012DWP (Texas Instruments, Inc.) 500-mA DUAL DIFFERENTIAL LINE DRIVER PDF資料下載
參數資料
| 型號： | THS6012DWP |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 500-mA DUAL DIFFERENTIAL LINE DRIVER |
| 中文描述： | 500毫安雙差分線路驅動器 |
| 文件頁數： | 22/35頁 |
| 文件大小： | 604K |
| 代理商： | THS6012DWP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁
THS6012
500-mA DUAL DIFFERENTIAL LINE DRIVER
SLOS226C– SEPTEMBER 1998 – REVISED FEBRUARY 2000
22
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
recommended feedback and gain resistor values
As with all current feedback amplifiers, the bandwidth of the THS6012 is an inversely proportional function of
the value of the feedback resistor. This can be seen from Figures 17 – 20. The recommended resistors with a
±
15 V power supply for the optimum frequency response with a 25-
load system are 680-
for a gain = 1 and
620-
for a gain = 2 or –1. Additionally, using a
±
5 V power supply, it is recommended that a 1-k
feedback
resistor be used for a gain of 1 and a 820-
feedback resistor be used for a gain of 2 or –1. These should be
used as a starting point and once optimum values are found, 1% tolerance resistors should be used to maintain
frequency response characteristics. Because there is a finite amount of output resistance of the operational
amplifier, load resistance can play a major part in frequency response. This is especially true with these drivers,
which tend to drive low-impedance loads. This can be seen in Figure 11, Figure 23, and Figure 24. As the load
resistance increases, the output resistance of the amplifier becomes less dominant at high frequencies. To
compensate for this, the feedback resistor should change. For 100-
loads, it is recommended that the
feedback resistor be changed to 820
for a gain of 1 and 560
for a gain of 2 or –1. Although, for most
applications, a feedback resistor value of 1 k
is recommended, which is a good compromise between
bandwidth and phase margin that yields a very stable amplifier.
Consistent with current feedback amplifiers, increasing the gain is best accomplished by changing the gain
resistor, not the feedback resistor. This is because the bandwidth of the amplifier is dominated by the feedback
resistor value and internal dominant-pole capacitor. The ability to control the amplifier gain independently of the
bandwidth constitutes a major advantage of current feedback amplifiers over conventional voltage feedback
amplifiers. Therefore, once a frequency response is found suitable to a particular application, adjust the value
of the gain resistor to increase or decrease the overall amplifier gain.
Finally, it is important to realize the effects of the feedback resistance on distortion. Increasing the resistance
decreases the loop gain and increases the distortion. It is also important to know that decreasing load
impedance increases total harmonic distortion (THD). Typically, the third order harmonic distortion increases
more than the second order harmonic distortion.
offset voltage
The output offset voltage, (V
OO
) is the sum of the input offset voltage (V
IO
) and both input bias currents (I
IB
) times
the corresponding gains. The following schematic and formula can be used to calculate the output offset
voltage:
VOO
VIO
1
RF
RG
IIB
RS
1
RF
RG
IIB–RF
+
–
VI
+
RG
RS
RF
IIB–
VO
IIB+
Figure 40. Output Offset Voltage Model
相關PDF資料 |
PDF描述 |
|---|---|
| THS6012EVM | 500-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6012IGQE | 500-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6012CGQE | 500-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6022GQE | 250-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6022EVM | 250-mA DUAL DIFFERENTIAL LINE DRIVER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS6012EVM | 功能描述:其他開發工具 THS6012 Hi-Spd Amp Eval Mods RoHS:否 制造商:Parallax 產品:ELEV-8 Hex Upgrade Kits 類型:Robotics 工具用于評估:ELEV-8 Quadcopter 工作電源電壓: |
| THS6012GQE | 制造商:TI 制造商全稱:Texas Instruments 功能描述:500-mA DUAL DIFFERENTIAL LINE DRIVER |
| THS6012IDWP | 功能描述:緩沖器和線路驅動器 500-mA Dual Diff Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel |
| THS6012IDWPG4 | 功能描述:緩沖器和線路驅動器 500mA Dual Diff Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel |
| THS6012IDWPR | 功能描述:緩沖器和線路驅動器 500-mA Dual Diff Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。