- 您現在的位置：買賣IC網 > PDF目錄98210 > TEA1612T (NXP SEMICONDUCTORS) SPECIALTY ANALOG CIRCUIT, PDSO24 PDF資料下載
參數資料
| 型號： | TEA1612T |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PDSO24 |
| 封裝： | 7.50 MM, PLASTIC, MS-013, SOT137-1, SOP-24 |
| 文件頁數： | 18/19頁 |
| 文件大?。?/td> | 108K |
| 代理商： | TEA1612T |
TEA1612T_1
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 01 — 24 September 2009
8 of 19
NXP Semiconductors
TEA1612T
Zero voltage switching resonant converter controller
Bridge frequency accuracy is optimum in the low frequency region. At higher frequencies
both the non-overlap time and the oscillator frequency show a decay.
The frequency of the oscillator depends on the value of capacitor Cf, the peak-to-peak
voltage swing VCF, and the charge and discharge currents. However, at higher
frequencies the accuracy decreases due to delays in the circuit.
7.6 Error amplier
The error amplier is a transconductance amplier. Thus the output current at pin VCO is
determined by the amplier transconductance, the differential voltage on input pin P, and
the internal reference voltage (2.5 V). The output current IVCO is fed to the IRS input of the
current-controlled oscillator.
The source capability of the error amplier increases current in the IRS pin when the
differential input voltage is positive. Therefore the minimum current is determined by
resistor Rf(min) and the minimum frequency setting is independent of the characteristics of
the error amplier.
The error amplier has a maximum output current of 0.5 mA for an output voltage up to
2.5 V. If the source current decreases, the oscillator frequency also decreases resulting in
a higher regulated output voltage.
During start-up, the output voltage of the amplier is connected to the soft start (CSS) pin
via a buffer. This will hold the VCO pin at a constant value of VVCO(start).
7.7 Soft start
The CSS pin voltage is copied to the VCO pin via a buffer. This buffer only has a source
capability i.e. it can only charge the VCO pin. This means that the error amplier output
can increase the VCO pin voltage above the CSS voltage level.
Fig 6.
Frequency range
014aaa038
0
fosc(max)
fosc(start)
fosc
fosc(min)
IIRS
相關PDF資料 |
PDF描述 |
|---|---|
| TEA1742T | 2 A POWER FACTOR CONTROLLER, 150 kHz SWITCHING FREQ-MAX, PDSO8 |
| TEA1761T/N2 | 1.4 A SWITCHING CONTROLLER, PDSO8 |
| TEA1795T/N1 | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| TEA2025D013TR | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO16 |
| TEA2025D | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TEA1612T/N1,518 | 功能描述:交流/直流開關轉換器 IC RESONANT CONV CTRLR RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel |
| TEA1613T/N1,518 | 功能描述:交流/直流開關轉換器 IC CTLR RESONANT CONV RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel |
| TEA1620P | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:STARplug |
| TEA1620P/N1,112 | 功能描述:開關變換器、穩壓器與控制器 STARPLUG SMPS CNTRLR 48 OHM RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| TEA1622P | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:STARplugTM |
發布緊急采購，3分鐘左右您將得到回復。