參數資料
型號: TDA9113
廠商: STMICROELECTRONICS
元件分類: 偏轉
英文描述: HORIZ/VERT DEFLECTION IC, PDIP32
封裝: SHRINK, PLASTIC, DIP-32
文件頁數: 17/50頁
文件大?。?/td> 755K
代理商: TDA9113
TDA9113
24/50
Sad07/D7 - BOutPh
Phase of start of B+ drive signal on BOut pin
0: Just after horizontal flyback pulse
1: With one of edges of line drive signal on
HOut pin, selected by BOHEdge bit
Sad08/D7 - EWTrHFr
Tracking of all corrections contained in wave-
form on pin EWOut with Horizontal Frequency
0: Not active
1: Active
Sad15/D7 - VDyCorPol
Polarity of Vertical Dynamic Correction wave-
form (parabola)
0: Concave (minimum in the middle of the pa-
rabola)
1: Convex (maximum in the middle of the pa-
rabola)
Sad16/D0 - HLockEn
Enable of output of Horizontal PLL1 Lock/unlock
status signal on pin HLckVBk
0: Disabled, vertical blanking only on the pin
HLckVBk
1: Enabled
Sad16/D1 - PLL1InhEn
Enable of Inhibition of horizontal PLL1 during
extracted vertical synchronization pulse
0: Disabled, PLL1 is never inhibited
1: Enabled
Sad16/D2 - PLL1Pump
Horizontal PLL1 charge Pump current
0: Slow PLL1, low current
1: Fast PLL1, high current
Sad16/D4 - SDetReset
Reset to 0 of Synchronization Detection flags
VDet, HVDet and VExtrDet of status register ef-
fected with ACK bit of I2C Bus data transfer into
register containing the SDetReset bit. Also see
description of the flags.
0: No effect
1: Reset with automatic return of the bit to 0
Sad16/D5 - VSyncSel
Vertical Synchronization input Selection be-
tween the one extracted from composite HV sig-
nal on pin H/HVSyn and the one on pin VSyn.
No effect if VSyncAuto bit is at 1.
0: V. sync extracted from composite signal on
H/HVSyn pin selected
1: V. sync applied on VSyn pin selected
Sad16/D6 - VSyncAuto
Vertical Synchronization input selection Auto-
matic mode. If enabled, the device automatically
selects between the vertical sync extracted from
composite HV signal on pin H/HVSyn and the
one on pin VSyn, based on detection mecha-
nism. If both are present, the one coming first is
kept.
0: Disabled, selection done according to bit
VSyncSel
1: Enabled, the bit VSyncSel has no effect
Sad16/D7 - XRayReset
Reset to 0 of XRay flag of status register effect-
ed with ACK bit of I2C Bus data transfer into reg-
ister containing the XRayReset bit. Also see de-
scription of the flag.
0: No effect
1: Reset with automatic return of the bit to 0
Sad17/D0 - BlankMode
Blanking operation Mode
0: Blanking pulse starting with detection of
vertical synchronization pulse and ending
with end of vertical oscillator discharge
(start of vertical sawtooth ramp on the VOut
pin)
1: Permanent blanking - high blanking level in
composite signal on pin HLckVBk is per-
manent
Sad17/D1 - VOutEn
Vertical Output Enable
0: Disabled, VoffVOut on VOut pin (see 6.5 -
Vertical section)
1: Enabled, vertical ramp with vertical position
offset on VOut pin
相關PDF資料
PDF描述
TDA9115 HORIZ/VERT DEFLECTION IC, PDIP32
TDA9116 HORIZ/VERT DEFLECTION IC, PDIP32
TDA9141N COLOR SIGNAL DECODER, PDIP32
TDA9170N SPECIALTY CONSUMER CIRCUIT, PDIP32
TDA9177N SPECIALTY CONSUMER CIRCUIT, PDIP24
相關代理商/技術參數
參數描述
TDA9115 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:LOW-COST I2C CONTROLLED DEFLECTION PROCESSOR FOR MULTISYNC MONITOR
TDA9116 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:LOW-COST I2C CONTROLLED DEFLECTION PROCESSOR FOR MULTISYNC MONITOR
TDA9118 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:行/場掃描處理電路
TDA9141 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:PAL/NTSC/SECAM decoder/sync processor
TDA9143 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:I2C-bus controlled, alignment-free PAL/NTSC/SECAM decoder/sync processor