
TDA9113
23/50
Note 49: With exception of
HDUTY and BREF adjustments data that can take effect instantaneously if switches
HDutySyncV and B+SyncV are at 0 respectively.
Note 50: In Read Mode, the device always outputs data of the status register, regardless of sub address previously
selected.
Note 51: The TV, TH, TVM and THM bits are for testing purposes and must be kept at 0 by application.
Description of I2C Bus switches and flags
Write-to bits
Sad00/D7 - HDutySyncV
Synchronization of internal application of Hori-
zontal Duty cycle data, buffered in I2C Bus latch,
with internal discharge of Vertical oscillator
0: Asynchronous mode, new data applied
with ACK bit of I2C Bus transfer on this sub
address
1: Synchronous mode
Sad02/D7 - HMoiré
Horizontal Moiré characteristics
0: Adapted to an architecture with EHT gener-
ated in deflection section
1: Adapted to an architecture with separated
deflection and EHT sections
Sad03/D7 - B+SyncV
Same as HDutySyncV, applicable for B+ refer-
ence data
Sad04/D7 - HDyCorTr
Tracking of Horizontal Dynamic Correction
waveform amplitude with Horizontal Size at ad-
justment and EHT variation (voltage of HEHTIn).
0: Not active
1: Active
Sad05/D7 - HDyCorPh
Phase of start of Horizontal Dynamic Correction
waveform in relation to horizontal flyback pulse.
0: Start of the flyback
1: Middle of the flyback
Sad06/D7 - BOutPol
Polarity of B+ drive signal on BOut pin
0: adapted to N type of power MOS - high
level to make it conductive
1: adapted to P type of power MOS - low level
to make it conductive
11
Reserved
PCAC
(Pin cushion asymmetry correction)
1000000
12
Reserved
PARAL
(Parallelogram correction)
1000000
13
Reserved
14
Reserved
15
VDyCorPol
0: ”
∪"
VDC-AMP
(Vertical dynamic correction amplitude)
1000000
16
XRayReset
0: No effect
1: Reset
VSyncAuto
1: On
VSyncSel
0:Comp
1:Sep
SDetReset
0: No effect
1: Reset
0
PLL1Pump
1: Fast
0: Slow
PLL1InhEn
1: On
HLockEn
1: On
17
TV
0: Off(51)
TH
0: Off(51)
TVM
0: Off(51)
THM
0: Off(51)
BOHEdge
0: Falling
HBOutEn
0: Disable
VOutEn
0: Disable
BlankMode
1: Perm.
READ MODE (SLAVE ADDRESS = 8D)
XX
(50)
HLock
0: Locked
1: Not locked
VLock
0: Locked
1: Not lock.
XRayAlarm
1: On
0: Off
Polarity detection
Sync detection
HVPol
1: Negative
VPol
1: Negative
VExtrDet
0: Not det.
HVDet
0: Not det.
VDet
0: Not det.
Sad
D7
D6D5D4D3D2
D1
D0