- 您現在的位置：買賣IC網 > PDF目錄383938 > TDA1315 (NXP Semiconductors N.V.) Digital audio input/output circuit DAIO PDF資料下載
參數資料
| 型號： | TDA1315 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Digital audio input/output circuit DAIO |
| 中文描述： | 數字音頻輸入/輸出電路交易代碼 |
| 文件頁數： | 14/36頁 |
| 文件大?。?/td> | 411K |
| 代理商： | TDA1315 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
1995 Jul 17
14
Philips Semiconductors
Product specification
Digital audio input/output circuit (DAIO)
TDA1315H
Stand-alone mode
In this mode, the TDA1315H is automatically configured as
a receiver. The configuration, i.e., the mode of operation of
the device, is determined by pins CTRLMODE, IECSEL,
IECOEN, CLKSEL, I
2
SSEL and I
2
SOEN. Because all of
the pins have internal pull-up resistors, the default
configuration can be changed by pulling a pin LOW.
The output signals listed below are provided from the
channel status. However, all of them are switched off when
the PLL is not locked. This includes the situation where no
IEC input signal is available:
Sample frequency is 32 kHz (pin FS32)
Sample frequency is 44.1 kHz (pin FS44)
Sample frequency is 48 kHz (pin FS48)
Copyright status bit (pin COPY)
Pre-emphasis bit (pin DEEM).
As there will be no output signals from the channel status
in the event that non-consumer IEC signals are received,
the I
2
S-bus output will still output data in 24 bits format. An
LED can be connected to pin CHMODE to provide an
indication of such a situation.
Host mode
In this mode, the exchange of data and control information
between the TDA1315H and a microcontroller is via a
serial hardware interface, which comprises the following
pins:
LDATA to microcontroller interface data line.
LCLK to microcontroller interface clock line.
LMODE to microcontroller interface mode line.
LADDR to microcontroller interface address switch.
Two different modes of operation can be distinguished:
1.
Addressing mode.
2.
Data transfer mode.
The addressing mode is used to select a device for
subsequent data transfer and to define the direction of that
transfer as well as the source or destination registers. The
addressing mode is characterized by LMODE being LOW
and a burst of 8 clock pulses at LCLK, accompanied by
8 data bits. The fundamental timing is illustrated in Fig.6.
Data bits 0 to 1 indicate the type of subsequent data
transfer as given in Table 7. The direction of the channel
status and user data transfers depends on the
transmit/receive mode.
Data bits 2 to 7 represent a 6-bit device address, with bit 7
being the MSB and bit 2 the LSB. The address of the
TDA1315H is 000001 (LADDR = 0) or 000010
(LADDR = 1). Should the TDA1315H receive a different
address, it will immediately 3-state the LDATA pin and
deselect its microcontroller interface logic. A dummy
address of 000000 is defined for the deselection of all
devices that are connected to the serial microcontroller
bus.
Fig.3 User data handshake.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA1315H | Digital audio input/output circuit DAIO |
| TDA1373H | General Digital Input GDIN |
| TDA1386 | Noise shaping filter DAC |
| TDA1386T | Noise shaping filter DAC |
| TDA1515AD | Single Audio Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA1315H | 制造商:NXP Semiconductors 功能描述:SPECIALTY CONSUMER CIRCUIT, PQFP44 |
| TDA1315HB-S | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Digital Audio |
| TDA1319 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| TDA1319T | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Digital Audio Tape Circuit |
| TDA1348AE | 功能描述:48V FAN 127X127X38MM RoHS:是 類別:風扇，熱管理 >> 風扇 - DC 系列:TDA 標準包裝:40 系列:OD8025 風扇類型:管軸式 尺寸/尺寸:方形 - 80mm L x 80mm H x 25mm W 電壓 - 額定:12VDC 功率（瓦特）:- 特點:PWM 控制；速度傳感器（轉速計） RPM:- 雜訊:- 靜態壓力:- 氣流:- 端子:4 引線 軸承類型:密封套筒 工作溫度:- 重量:- 額定電流:- 電壓范圍:- 預期壽命:- 其它名稱:OD802512MSS10A |
發布緊急采購，3分鐘左右您將得到回復。