參數資料
型號： TC58FV321
廠商： Toshiba Corporation
英文描述： TOSHIBA MOS DIGITAL INTEGRATED CIRCUIT SILICON GATE CMOS 32-MBIT (4M X 8 BITS / 2M X 16 BITS) CMOS FLASH MEMORY
中文描述： 東芝馬鞍山數字集成電路硅柵CMOS 32兆位（4米× 8位/ 2米× 16位）的CMOS閃存
文件頁數： 17/48頁
文件大?。?/td> 560K
代理商： TC58FV321
TC58FVT321/B321FT/XB-70,-10
2002-08-06 17/48
DQ6 (Toggle bit 1)
The device status can be determined by the Toggle Bit function during an Auto-Program or auto-erase
operation. The Toggle bit begins toggling on the rising edge of WE in the last bus cycle. DQ6 alternately
outputs a 0 or a 1 for each OE access while CE
=
V
IL
while the device is busy. When the internal operation
has been completed, toggling stops and valid memory cell data can be read by subsequent reading. If the
operation fails, the DQ6 output toggles.
If an attempt is made to execute an Auto Program operation on a protected block, DQ6 will toggle for around 3
μ
s. It will then stop toggling. If an attempt is made to execute an auto erase operation on a protected block, DQ6
will toggle for around 100
μ
s. It will then stop toggling. After toggling has stopped the device will return to Read
Mode.
DQ5 (internal time-out)
If the internal timer times out during a Program or Erase operation, DQ5 outputs a 1. This indicates that the
operation has not been completed within the allotted time.
Any attempt to program a 1 into a cell containing a 0 will fail (see Auto-Program Mode). In this case DQ5
outputs a 1. Either a hardware reset or a software Reset command is required to return the device to Read Mode.
DQ3 (Block Erase timer)
The Block Erase operation starts 50
μ
s (the Erase Hold Time) after the rising edge of WE in the last
command cycle. DQ3 outputs a 0 for the duration of the Block Erase Hold Time and a 1 when the Block Erase
operation starts. Additional Block Erase commands can only be accepted during the Block Erase Hold Time.
Each Block Erase command input within the hold time resets the timer, allowing additional blocks to be marked
for erasing. DQ3 outputs a 1 if the Program or Erase operation fails.
DQ2 (Toggle bit 2)
DQ2 is used to indicate which blocks have been selected for Auto Block Erase or to indicate whether the device
is in Erase Suspend Mode.
If data is read continuously from the selected block during an Auto Block Erase, the DQ2 output will toggle.
Now 1 will be output from non-selected blocks; thus, the selected block can be ascertained. If data is read
continuously from the block selected for Auto Block Erase while the device is in Erase Suspend Mode, the DQ2
output will toggle. Because the DQ6 output is not toggling, it can be determined that the device is in Erase
Suspend Mode. If data is read from the address to which data is being written during Erase Suspend in
Programming Mode, DQ2 will output a 1.
RY
The TC58FVT321/B321 has a
state) indicates that an Auto-Program or auto-erase operation is in progress. A 1 (Ready state) indicates that the
operation has finished and that the device can now accept a new command.
operation has failed.
BY
/
RY
outputs a 0 after the rising edge of WE in the last command cycle.
During an Auto Block Erase operation, commands other than Erase Suspend are ignored.
during an Erase Suspend operation. The output buffer for the
allowing a wired-OR connection. A pull-up resistor must be inserted between V
DD
and the
BY
/
RY
signal to indicate the device status to the host processor. A 0 (Busy
BY
/
RY
outputs a 0 when an
BY
/
RY
outputs a 1
BY
/
RY
pin is an open-drain type circuit,
RY
BY
/
pin.
BUSY
相關PDF資料
PDF描述
TC58NS256DC TENTATIVE TOSHIBA MOS DIGITAL INTEGRATED CIRCUIT SILICON GATE CMOS 256-MBIT (32M ?8 BITS) CMOS NAND E2PROM (32M BYTE SmartMediaTM)
TC58V32ADC 32M Bit (4M×8Bits ) CMOS Flash Memory(4M×8位CMOS閃速存儲器)
TC59RM716RB-6 128M Bits（256K x16x32Banks）DRAM(128M位（256K x16x32組）動態RAM)
TC59RM716RB-7 128M Bits（256K x16x32Banks）DRAM(128M位（256K x16x32組）動態RAM)
TC59RM716RB-8 128M Bits（256K x16x32Banks）DRAM(128M位（256K x16x32組）動態RAM)
相關代理商/技術參數
參數描述
TC58FVB004FT-10 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:4M (512K x 8) BIT CMOS FLASH MEMORY
TC58FVB004FT-12 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:4M (512K x 8) BIT CMOS FLASH MEMORY
TC58FVB004FT-85 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:4M (512K x 8) BIT CMOS FLASH MEMORY
TC58FVB160A 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:TOSHIBA MOS DIGITAL INTEGRATED CIRCUIT SILICON GATE CMOS
TC58FVB160AF 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:16-MBIT (2M x 8 BITS / 1M x 16 BITS) CMOS FLASH MEMORY
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*