- 您現在的位置：買賣IC網 > PDF目錄382560 > STLC2411 (意法半導體) BLUETOOTH BASEBAND PDF資料下載
參數資料
| 型號： | STLC2411 |
| 廠商： | 意法半導體 |
| 英文描述： | BLUETOOTH BASEBAND |
| 中文描述： | 藍牙基帶 |
| 文件頁數： | 15/25頁 |
| 文件大?。?/td> | 216K |
| 代理商： | STLC2411 |
15/25
STLC2411
Sleep Mode. If some HCI transmission is needed, the UART link will be reactivated, using one of the two
ways explained in 7.5, and the STLC2411 will move from the Deep Sleep Mode to the Sleep Mode.
7.10.2 INQUIRY/PAGE SCAN
When only inquiry scan or page scan is enabled, the STLC2411 will go in Sleep Mode or Deep Sleep
Mode outside the receiver activity. The selection between Sleep Mode and Deep Sleep Mode depend on
the UART activity like in SNIFF or PARK.
7.10.3 NO CONNECTION
If the Host places the UART in low power and there is no activity, then the STLC2411 can be placed in
Deep Sleep Mode.
7.10.4 ACTIVE LINK
When there is an active link (SCO or ACL), the STLC2411 cannot go in Deep Sleep Mode whatever the
UART state is. But the STLC2411 baseband is made such that whenever it is possible, depending on the
scheduled activity (number of link, type of link, amount of data exchanged), it goes in Sleep Mode.
7.11 SW initiated low power mode
A wide set of wake up mechanisms are supported.
7.12 Bluetooth - WLAN coexistence in collocated scenario
The coexistence interface uses 4 GPIO pins, when enabled.
Bluetooth and WLAN 802.11 b/g technologies occupy the same 2.4 GHz ISM band. STLC2411 imple-
ments a set of mechanisms to avoid interference in a collocated scenario.
The STLC2411 supports 5 different algorithms in order to provide efficient and flexible simultaneous func-
tionality between the two technologies in collocated scenarios:
–
Algorithm 1:
PTA (Packet Traffic Arbitration) based coexistence algorithm defined in accordance with
the IEEE 802.15.2 recommended practice.
–
Algorithm 2:
the WLAN is the master and it indicates to the STLC2411 when not to operate in case of
simultaneous use of the air interface.
–
Algorithm 3:
the STLC2411 is the master and it indicates to the WLAN chip when not to operate in case
of simultaneous use of the air interface.
–
Algorithm 4:
Two-wire mechanism
–
Algorithm 5:
Alternating Wireless Medium Access (AWMA), defined in accordance with the WLAN
802.11 b/g technologies.
The algorithm is selected via HCI command. The default algorithm is algorithm 1.
7.12.1 Algorithm 1: PTA (Packet Traffic Arbitration)
The Algorithm is based on a bus connection between the STLC2411 and the WLAN chip:
By using this coexistence interface it's possible to dynamically allocate bandwidth to the two devices when
simultaneous operations are required while the full bandwidth can be allocated to one of them in case the
other one does not require activity. The algorithm involves a priority mechanism, which allows preserving
the quality of certain types of link. A typical application would be to guarantee optimal quality to the Blue-
STLC2411
WLAN
相關PDF資料 |
PDF描述 |
|---|---|
| STLC2416 | BLUETOOTH BASEBAND WITH INTEGRATED FLASH |
| STLC60243 | DUAL CHANNEL ADSL LINE DRIVER |
| STLC7545 | Enhanced V.34 BIS Analog Front-End(單片模擬前端) |
| STLC7549 | Stereo Audio/MODEM/Telephony Codec(立體聲音頻/調制解調器/電話編解碼器) |
| STLVD210B | DIFFERENTIAL LVDS CLOCK DRIVER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| STLC2415 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:BLUETOOTH BASEBAND WITH INTEGRATED FLASH |
| STLC2416 | 制造商:STMicroelectronics 功能描述: |
| STLC2450 | 功能描述:射頻無線雜項 Eval Board STLC2450 RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel |
| STLC2500 | 制造商:STMicroelectronics 功能描述:BLUETOOTH CLS II 2.65V TO 2.85V 0.721MBPS 84TFBGA - Trays |
| STLC2500A | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Bluetooth Single Chip |
發布緊急采購，3分鐘左右您將得到回復。