- 您現在的位置：買賣IC網 > PDF目錄98143 > ST10R172LT6 (STMICROELECTRONICS) 16-BIT, 50 MHz, MICROCONTROLLER, PQFP100 PDF資料下載
參數資料
| 型號： | ST10R172LT6 |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, 50 MHz, MICROCONTROLLER, PQFP100 |
| 封裝： | 14 X 14 MM, TQFP-100 |
| 文件頁數： | 28/68頁 |
| 文件大?。?/td> | 657K |
| 代理商： | ST10R172LT6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
34/68
ST10R172L - ELECTRICAL CHARACTERISTICS
PORT0 configuration current3
IP0H
4
–-4
AV
IN = VIHmin
IP0L
5
-50
–
AV
IN = VILmax
RPD pulldown current2
IRPD
5
100
500
AV
OUT = VDD
XTAL1 input current
IIL
CC
–
±20
A
0 V <
VIN < VDD
Pin capacitance6)
(digital inputs/outputs)
CIO
CC
–
10
pF
f = 1 MHz
TA = 25 °C
Power supply current
ICC
–15 +
2.5 * fCPU
mA
fCPU in [MHz]
7))
Idle mode supply current
IID
–10 +
0.9 * fCPU
mA
RSTIN =
VIH1
fCPU in [MHz]
7
Power-down mode supply current I
PD
8
–200
A
VDD = 3.6 V
9
1) This specification is not valid for outputs which are switched to open drain mode. In this case
the respective output will float and the resulting voltage comes from the external circuitry.
2) This specification is only valid during reset, or interruptible power-down mode, after recep-
tion of an external interrupt signal that will wake up the CPU.
3) This specification is only valid during reset, hold or adapt-mode. Port 6 pins are only affected
if they are used for CS output and the open drain function is not enabled.
4) The maximum current may be drawn while the signal line remains inactive.
5) The minimum current must be drawn in order to drive the signal line active.
6) Not 100% tested, guaranteed by design characterization.
7) Supply current is a function of operating frequency as illustrated in Figure 7 on page 35.
This parameter is tested at VDDmax and 50 MHz CPU clock with all outputs disconnected
and all inputs at VIL or VIH with an infinite execution of NOP instruction fetched from external
memory (16-bit demux bus mode, no waitstates, no memory tri-state waitstates, normal
ALE).
8) Typical value at 25°C = 20A.
9) This parameter is tested including leakage currents. All inputs (including pins configured as
inputs) at 0 V to 0.1 V or at VDD – 0.1 V to VDD, VREF = 0 V, all outputs (including pins con-
figured as outputs) disconnected.
Parameter
Symbol
Limit Values
Unit
Test Condition
min.
max.
Table 11 DC characteristics
1
相關PDF資料 |
PDF描述 |
|---|---|
| ST10R272LT6 | 16-BIT, 50 MHz, MICROCONTROLLER, PQFP100 |
| ST16C452PSIJ68 | 2 CHANNEL(S), SERIAL COMM CONTROLLER, PQCC68 |
| ST16C452ATIJ68 | 2 CHANNEL(S), SERIAL COMM CONTROLLER, PQCC68 |
| ST16C654IQ64/TR | 4 CHANNEL(S), 1.5M bps, SERIAL COMM CONTROLLER, PQFP64 |
| ST18931CR | 16-BIT, 50 MHz, OTHER DSP, CPGA121 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST10R262-T1 | 制造商:STMicroelectronics 功能描述: 制造商:STMicroelectronics 功能描述:10R262-T1 |
| ST10R272 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16-BIT LOW VOLTAGE ROMLESS MCU WITH MAC |
| ST10R272L | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16-BIT LOW VOLTAGE ROMLESS MCU WITH MAC |
| ST10R272L_ER | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:16-BIT LOW VOLTAGE ROMLESS MCU WITH MAC (ERRATA SHEET) |
| ST10R272L-B0 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16-BIT ROMLESS LOW VOLTAGE MCU WITH MAC |
發布緊急采購，3分鐘左右您將得到回復。