- 您現在的位置：買賣IC網 > PDF目錄98142 > SST55LC100-45-C-BWE FLASH MEMORY DRIVE CONTROLLER, PBGA84 PDF資料下載
參數資料
| 型號： | SST55LC100-45-C-BWE |
| 元件分類： | 存儲控制器/管理單元 |
| 英文描述： | FLASH MEMORY DRIVE CONTROLLER, PBGA84 |
| 封裝： | ROHS COMPLIANT, MO-210, TFBGA-84 |
| 文件頁數： | 11/80頁 |
| 文件大小： | 758K |
| 代理商： | SST55LC100-45-C-BWE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
Advance Information
CompactFlash Card Controller
SST55LC100
2005 Silicon Storage Technology, Inc.
S71298-00-000
10/05
19
8.1 Attribute Memory Function
Attribute memory is a space where CompactFlash card identification and configuration information are stored, and
is limited to 8-bit wide accesses only at even addresses. The card configuration registers are also located here.
For the Attribute Memory Read function, signals REG# and OE# must be active and WE# inactive during the cycle.
As in the Main Memory Read functions, the signals CE1# and CE2# control the Even Byte and Odd Byte address,
but only the Even Byte data is valid during the Attribute Memory access. Refer to Table 8-3 below for signal states
and bus validity for the Attribute Memory function.
Note: The CE# signal or both the OE# signal and the WE# signal must be de-asserted between consecutive cycle operations.
8.2 Configuration Option Register (Address 200H in Attribute Memory)
The Configuration Option register is used to configure the cards interface, address decoding and interrupt and to
issue a soft reset to the CompactFlash card.
SRESET
Soft Reset - Setting this bit to one (1), waiting the minimum reset width time and
returning to zero (0) places the CompactFlash card in the Reset state. Setting this bit to
one (1) is equivalent to assertion of the RESET signal except that the SRESET bit is not
cleared. Returning this bit to zero (0) leaves the CompactFlash card in the same un-
configured Reset state as following power-up and hardware reset. This bit is set to zero
(0) by power-up and hardware reset. Using the PCMCIA Soft Reset is considered a hard
Reset by the ATA Commands. Contrast with Soft Reset in the Device Control register.
LevlREQ
This bit is set to one (1) when Level Mode Interrupt is selected, and zero (0) when Pulse
mode is selected. Set to zero (0) by Reset.
Conf5-Conf0 Configuration Index. Set to zero (0) by reset. It’s used to select operation mode of the
CompactFlash card as shown below.
Note: Conf5 and Conf4 are reserved and must be written as (0).
TABLE
8-3: ATTRIBUTE MEMORY FUNCTION
Function Mode
REG#
CE2#
CE1#
A10
A9
A0
OE#
WE#
D15-D8
D7-D0
Standby mode
X
VIH
X
High Z
Read Byte Access CIS ROM (8 bits)
VIL
VIH
VIL
VIH
High Z
Even Byte
Write Byte Access CIS (8 bits) (Invalid)
VIL
VIH
VIL
VIH
VIL
Don’t Care
Even Byte
Read Byte Access Configuration (8 bits)
VIL
VIH
VIL
VIH VIL
VIL
VIH
High Z
Even Byte
Write Byte Access Configuration (8 bits)
VIL
VIH
VIL
VIH VIL
VIH
VIL
Don’t Care
Even Byte
Read Word Access CIS (16 bits)
VIL
XVIL
VIH
Not Valid
Even Byte
Write Word Access CIS (16 bits) (Invalid)
VIL
XVIH
VIL
Don’t Care
Even Byte
Read Word Access Configuration (16 bits)
VIL
VIH
XVIL
VIH
Not Valid
Even Byte
Write Word Access Configuration (16 bits)
VIL
VIH
XVIH
VIL
Don’t Care
Even Byte
T8-3.0 1298
Operation
D7
D6
D5D4
D3D2D1D0
R/W
SRESET
LevlREQ
Conf5
Conf4
Conf3
Conf2
Conf1
Conf0
相關PDF資料 |
PDF描述 |
|---|---|
| SST55LC100M-45-C-BWE | IDE COMPATIBLE, FLASH MEMORY DRIVE CONTROLLER, PBGA84 |
| SST55LD017D-40-C-TQWE | FLASH MEMORY DRIVE CONTROLLER, PQFP100 |
| SST55LD017D-40-I-TQW | FLASH MEMORY DRIVE CONTROLLER, PQFP100 |
| SST55LD019A-45-C-TQPE | FLASH MEMORY DRIVE CONTROLLER, PQFP64 |
| SST55LD019C-45-I-BWE | FLASH MEMORY DRIVE CONTROLLER, PBGA84 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SST55LC100-45-C-TQWE | 功能描述:總線收發器 Compact Flash Card Controller RoHS:否 制造商:Fairchild Semiconductor 邏輯類型:CMOS 邏輯系列:74VCX 每芯片的通道數量:16 輸入電平:CMOS 輸出電平:CMOS 輸出類型:3-State 高電平輸出電流:- 24 mA 低電平輸出電流:24 mA 傳播延遲時間:6.2 ns 電源電壓-最大:2.7 V, 3.6 V 電源電壓-最小:1.65 V, 2.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-48 封裝:Reel |
| SST55LC100-45-I-BWE | 制造商:SST 制造商全稱:Silicon Storage Technology, Inc 功能描述:CompactFlash Card Controller |
| SST55LC100-45-I-TQWE | 制造商:SST 制造商全稱:Silicon Storage Technology, Inc 功能描述:CompactFlash Card Controller |
| SST55LC100M | 制造商:SST 制造商全稱:Silicon Storage Technology, Inc 功能描述:CompactFlash Card Controller |
| SST55LC100M-45-C-BWE | 功能描述:總線收發器 Compact Flash 45MHz 3.3V Commercial RoHS:否 制造商:Fairchild Semiconductor 邏輯類型:CMOS 邏輯系列:74VCX 每芯片的通道數量:16 輸入電平:CMOS 輸出電平:CMOS 輸出類型:3-State 高電平輸出電流:- 24 mA 低電平輸出電流:24 mA 傳播延遲時間:6.2 ns 電源電壓-最大:2.7 V, 3.6 V 電源電壓-最小:1.65 V, 2.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。