CLKOUT period jitter, measured at" />
參數資料
型號： SC5554MVR132
廠商： Freescale Semiconductor
文件頁數： 14/58頁
文件大?。?/td> 0K
描述： MCU MPC5554 DP ONLY 416-PBGA
標準包裝： 200
系列： MPC55xx Qorivva
核心處理器： e200z6
芯體尺寸： 32-位
速度： 132MHz
連通性： CAN，EBI/EMI，SCI，SPI
外圍設備： DMA，POR，PWM，WDT
輸入/輸出數： 256
程序存儲器容量： 2MB（2M x 8）
程序存儲器類型： 閃存
RAM 容量： 64K x 8
電壓 - 電源 (Vcc/Vdd)： 1.35 V ~ 1.65 V
數據轉換器： A/D 40x12b
振蕩器型： 外部
工作溫度： -40°C ~ 125°C
封裝/外殼： 416-TBGA
包裝： 托盤
Electrical Characteristics
MPC5554 Microcontroller Data Sheet, Rev. 4
Freescale Semiconductor
21
19
CLKOUT period jitter, measured at fSYS max:
13, 14
Peak-to-peak jitter (clock edge to clock edge)
Long term jitter (averaged over a 2 ms interval)
CJITTER
—
5.0
0.01
%
fCLKOUT
20
Frequency modulation range limit 15
(do not exceed fsys maximum)
CMOD
0.8
2.4
%fSYS
21
ICO frequency
fico = [fref_crystal (MFD + 4)] (PREDIV + 1)
16
fico = [fref_ext (MFD + 4) ] (PREDIV + 1)
fico
48
fMAX
MHz
22
Predivider output frequency (to PLL)
fPREDIV
420 17
MHz
1 Nominal crystal and external reference values are worst-case not more than 1%. The device operates correctly if the frequency
remains within ± 5% of the specification limit. This tolerance range allows for a slight frequency drift of the crystals over time.
The designer must thoroughly understand the drift margin of the source clock.
2 All internal registers retain data at 0 Hz.
3 Up to the maximum frequency rating of the device (refer to Table 1).
4 Loss of reference frequency is defined as the reference frequency detected internally, which transitions the PLL into self-clocked
mode.
5 The PLL operates at self-clocked mode (SCM) frequency when the reference frequency falls below f
LOR. SCM frequency is
measured on the CLKOUT ball with the divider set to divide-by-two of the system clock.
NOTE: In SCM, the MFD and PREDIV have no effect and the RFD is bypassed.
6 Use the EXTAL input high voltage parameter when using the FlexCAN oscillator in crystal mode (no quartz crystals or
resonators). (Vextal – Vxtal) must be 400 mV for the oscillator’s comparator to produce the output clock.
7 Use the EXTAL input low voltage parameter when using the FlexCAN oscillator in crystal mode (no quartz crystals or
resonators). (Vxtal –Vextal) must be 400 mV for the oscillator’s comparator to produce the output clock.
8 I
xtal is the oscillator bias current out of the XTAL pin with both EXTAL and XTAL pins grounded.
9 C
PCB_EXTAL and CPCB_XTAL are the measured PCB stray capacitances on EXTAL and XTAL, respectively.
10 This specification applies to the period required for the PLL to relock after changing the MFD frequency control bits in the
synthesizer control register (SYNCR). From power up with crystal oscillator reference, the lock time also includes the crystal
startup time.
11 PLL is operating in 1:1 PLL mode.
12 V
DDE = 3.0–3.6 V.
13 Jitter is the average deviation from the programmed frequency measured over the specified interval at maximum f
sys.
Measurements are made with the device powered by filtered supplies and clocked by a stable external clock signal. Noise
injected into the PLL circuitry via VDDSYN and VSSSYN and variation in crystal oscillator frequency increase the jitter percentage
for a given interval. CLKOUT divider is set to divide-by-two.
14 Values are with frequency modulation disabled. If frequency modulation is enabled, jitter is the sum of (jitter + Cmod).
15 Modulation depth selected must not result in f
sys value greater than the fsys maximum specified value.
16 f
sys = fico (2
RFD).
17 Maximum value for dual controller (1:1) mode is (f
MAX 2) with the predivider set to 1 (FMPLL_SYNCR[PREDIV] = 0b001).
Table 12. FMPLL Electrical Specifications (continued)
(VDDSYN = 3.0–3.6 V; VSS = VSSSYN = 0.0 V; TA = TL to TH)
Spec
Characteristic
Symbol
Minimum
Maximum
Unit
相關PDF資料
PDF描述
SCC2681AE1A44,529 IC UART DUAL 44-PLCC
SCC2691AC1N24,129 IC UART 24-DIP
SCC2692AC1N28,602 IC DUART 28-DIP
SCC2698BC1A84,512 IC UART OCTAL ENHANCED 84-PLCC
SCC68681C1N40,112 IC DUART 40DIP
相關代理商/技術參數
參數描述
SC5554MZP112 制造商:Freescale Semiconductor 功能描述:MPC5554, 84M68C, DP ONLY - Trays
SC5554MZP112R2 制造商:Freescale Semiconductor 功能描述:MPC5554, 84M68C, DP ONLY - Tape and Reel
SC5554MZP132 制造商:Freescale Semiconductor 功能描述:32-BIT MPC55XX POWERPC RISC 2MB FLASH 1.8V/2.5V/3.3V/5V 416 - Trays
SC5554MZP132R2 制造商:Freescale Semiconductor 功能描述:MPC5554, 84M68C, DP ONLY - Tape and Reel
SC5565MVZ132 制造商:Freescale Semiconductor 功能描述:2MB FLASH W/ECC, 3 CANS - Trays
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*