- 您現在的位置：買賣IC網 > PDF目錄385765 > R2023T (Ricoh Co., Ltd.) 2-wire Serial Interface Real Time Clock IC PDF資料下載
參數資料
| 型號： | R2023T |
| 廠商： | Ricoh Co., Ltd. |
| 英文描述： | 2-wire Serial Interface Real Time Clock IC |
| 中文描述： | 2線串行接口實時時鐘芯片 |
| 文件頁數： | 31/50頁 |
| 文件大?。?/td> | 512K |
| 代理商： | R2023T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁當前第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
R2023K/T
Course (A)
When the time count precision of each RTC is not to be adjusted, the quartz crystal unit intended for use in that
RTC may have any CL value requiring no presetting. The quartz crystal unit may be subject to frequency
variations which are selectable within the allowable range of time count precision. Several quartz crystal units and
RTCs should be used to find the center frequency of the quartz crystal units by the method described in "P30
Measurement of Oscillation Frequency" and then calculate an appropriate oscillation adjustment value by the
method described in "P33
Oscillation Adjustment Circuit" for writing this value to the R2023K/T.
Course (B)
When the time count precision of each RTC is to be adjusted within the oscillation frequency variations of the
quartz crystal unit plus the frequency variations of the real-time clock ICs, it becomes necessary to correct
deviations in the time count of each RTC by the method described in " P30
Oscillation Adjustment Circuit".
Such oscillation adjustment provides quartz crystal units with a wider range of allowable settings of their oscillation
frequency variations and their CL values. The real-time clock IC and the quartz crystal unit intended for use in
that real-time clock IC should be used to find the center frequency of the quartz crystal unit by the method
described in " P30
Measurement of Oscillation Frequency" and then confirm the center frequency thus found to
fall within the range adjustable by the oscillation adjustment circuit before adjusting the oscillation frequency of the
oscillation circuit. At normal temperature, the oscillation frequency of the oscillator circuit can be adjusted by up to
approximately
±
0.5ppm.
Course (C)
Course (C) together with Course (D) requires adjusting the time count precision of each RTC as well as the
frequency of 32.768-kHz clock pulses output from the 32KOUT pin. Normally, the oscillation frequency of the
crystal oscillator intended for use in the RTCs should be adjusted by adjusting the oscillation stabilizing capacitors
CG and CD connected to both ends of the crystal oscillator. The R2023K/T, which incorporate the CG and the
CD, require adjusting the oscillation frequency of the crystal oscillator through its CL value.
Generally, the relationship between the CL value and the CG and CD values can be represented by the following
equation:
CL = (CG
×
CD)/(CG + CD) + CS where "CS" represents the floating capacity of the printed circuit board.
The crystal oscillator intended for use in the R2023K/T is recommended to have the CL value on the order of 6 to
9pF. Its oscillation frequency should be measured by the method described in " P.30
Measurement of
Oscillation Frequency ". Any crystal oscillator found to have an excessively high or low oscillation frequency
(causing a time count gain or loss, respectively) should be replaced with another one having a smaller and greater
CL value, respectively until another one having an optimum CL value is selected. In this case, the bit settings
disabling the oscillation adjustment circuit (see " P.33
Oscillation Adjustment Circuit") should be written to the
oscillation adjustment register.
Incidentally, the high oscillation frequency of the crystal oscillator can also be adjusted by adding an external
oscillation stabilization capacitor CGOUT or/and CDOUT as illustrated in the diagram below.
OSCIN
Oscillator
Circuit
31
32kHz
RD
CG
CD
OSCOUT
CGOUT
CDOUT
*1) The CGOUT or/and CDOUT should have a
capacitance ranging from 0 to 6 pF.
相關PDF資料 |
PDF描述 |
|---|---|
| R2023T-E2 | 2-wire Serial Interface Real Time Clock IC |
| R2025D | High precision I2C-Bus Real-Time Clock Module |
| R2025S | High precision I2C-Bus Real-Time Clock Module |
| R5326Z003B | Automatic Mode Shift 2ch 150mA LDO |
| R5326Z004A | Automatic Mode Shift 2ch 150mA LDO |
相關代理商/技術參數 |
參數描述 |
|---|---|
| R2023T-E2 | 制造商:RICOH 制造商全稱:RICOH electronics devices division 功能描述:2-wire Serial Interface Real Time Clock IC |
| R2-0257-02 | 制造商:Southco 功能描述: |
| R2-0259-02 | 制造商:Southco 功能描述: |
| R2025D | 制造商:RICOH 制造商全稱:RICOH electronics devices division 功能描述:High precision I2C-Bus Real-Time Clock Module |
| R2025S | 制造商:RICOH 制造商全稱:RICOH electronics devices division 功能描述:High precision I2C-Bus Real-Time Clock Module |
發布緊急采購，3分鐘左右您將得到回復。