- 您現在的位置：買賣IC網 > PDF目錄224792 > PPXY8300A6T1 (FREESCALE SEMICONDUCTOR INC) DIFFERENTIAL, PEIZORESISTIVE PRESSURE SENSOR, RECTANGULAR, SURFACE MOUNT PDF資料下載
參數資料
| 型號： | PPXY8300A6T1 |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | Pressure Sensor |
| 英文描述： | DIFFERENTIAL, PEIZORESISTIVE PRESSURE SENSOR, RECTANGULAR, SURFACE MOUNT |
| 封裝： | SOIC-20 |
| 文件頁數： | 92/162頁 |
| 文件大?。?/td> | 4316K |
| 代理商： | PPXY8300A6T1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁當前第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁
MPXY8300 Series
Sensors
Freescale Semiconductor
35
5.9.2
System Reset Status Register (SRS)
This register includes seven read-only status flags to indicate the source of the most recent reset. When a debug host forces
reset by writing 1 to BDFR in the SBDFR register, none of the status bits in SRS will be set. Writing any value to this register
address clears the COP watchdog timer without affecting the contents of this register. The reset state of these bits depends on
what caused the MCU to reset.
Figure 5-3 System Reset Status (SRS)
Table 5-4 IRQSC Register Field Descriptions
Field
Description
5
IRQEDG
Interrupt Request (IRQ) Edge Select — This read/write control bit is used to select the polarity of edges or lev-
els on the IRQ pin that cause IRQF to be set. The IRQMOD control bit determines whether the IRQ pin is sensi-
tive to both edges and levels or only edges. When the IRQ pin is enabled as the IRQ input and is configured to
detect rising edges, the optional pull-up resistor is re-configured as an optional pull-down resistor.
0
IRQ is falling edge or falling edge/low-level sensitive.
1
IRQ is rising edge or rising edge/high-level sensitive.
4
IRQPE
IRQ Pin Enable — This read/write control bit enables the IRQ pin function. When this bit is set the IRQ pin can
be used as an interrupt request. Also, when this bit is set, either an internal pull-up or an internal pull-down
resistor is enabled depending on the state of the IRQMOD bit.
0
IRQ pin function is disabled.
1
IRQ pin function is enabled.
3
IRQF
IRQ Flag — This read-only status bit indicates when an interrupt request event has occurred.
0
No IRQ request.
1
IRQ event detected.
2
IRQACK
IRQ Acknowledge — This write-only bit is used to acknowledge interrupt request events (write 1 to clear
IRQF). Writing 0 has no meaning or effect. Reads always return logic 0. If edge-and-level detection is selected
(IRQMOD = 1), IRQF cannot be cleared while the IRQ pin remains at its asserted level.
1
IRQIE
IRQ Interrupt Enable — This read/write control bit determines whether IRQ events generate a hardware inter-
rupt request.
0
Hardware interrupt requests from IRQF disabled (use polling).
1
Hardware interrupt requested whenever IRQF = 1.
0
IRQMOD
IRQ Detection Mode — This read/write control bit selects either edge-only detection or edge-and-level detec-
tion. The IRQEDG control bit determines the polarity of edges and levels that are detected as interrupt request
events.
0
IRQ event on falling edges or rising edges only.
1
IRQ event on falling edges and low levels or on rising edges and high levels.
7
6
5
4
3
2
1
0
R
POR
PIN
COP
ILOP
ILAD
PWU
LVD
0
W
Reset:
Writing any value to SIMRS address clears COP watchdog timer.
Power-on reset:
1
0
1
0
Low-voltage reset:
1
0
1
0
Any other reset:
0
((1))
NOTES:
1. Any of these reset sources that are active at the time of reset will cause the corresponding bit(s) to be set; bits corresponding
to sources that are not active at the time of reset will be cleared.
(1)
0
相關PDF資料 |
PDF描述 |
|---|---|
| PR35MT2 | RECTANGULAR ADAPTER |
| PR406-BCR5HD | T-1 3/4 SINGLE COLOR LED, RED, 4.6 mm |
| PR44-PCG28H-CG | SINGLE COLOR LED, GREEN, 6.35 mm |
| PRADA1-07F-BR000 | ROCKER SWITCH, DPST, LATCHED, 7A, PANEL MOUNT |
| PRADD1-07F-BB000 | ROCKER SWITCH, DPST, LATCHED, 7A, PANEL MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PPYY12C0.75 | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 0.75MM PER M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, PER M 制造商:PRIVATE LABEL 功能描述:CABLE, YY, 12 CORE, 0.75MM, PER M, No. of Conductors:12, Voltage Rating:500V, No 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, PER M, No. of Conductors:12, Voltage Rating:500V, No. of Max Strands x Strand Size:-, Conductor Area CSA:0.75mm2, Jacket Colour:Grey, Jacket Material:PVC (Polyvinyl Chloride), External Diameter:9.9mm, |
| PPYY12C0.75 100M | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 0.75MM 100M 制造商:PRIVATE LABEL 功能描述:CABLE, YY, 12 CORE, 0.75MM, 100M, Reel Length (Imperial):328ft, Reel Length (Met 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, 100M, Reel Length (Imperial):328ft, Reel Length (Metric):100m, No. of Conductors:12, Voltage Rating:500V, No. of Max Strands x Strand Size:-, Conductor Area CSA:0.75mm2, Jacket Colour:Grey, Jacket , RoHS Compliant: Yes |
| PPYY12C0.75 50M | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 0.75MM 50M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, 50M |
| PPYY12C1.50 | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 1.5MM PER M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 1.5MM, PER M |
| PPYY12C1.50 50M | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 1.5MM 50M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 1.5MM, 50M |
發(fā)布緊急采購，3分鐘左右您將得到回復。