- 您現在的位置：買賣IC網 > PDF目錄367823 > PCL-818L (Electronic Theatre Controls, Inc.) High-performance DAS card with programmable gain PDF資料下載
參數資料
| 型號： | PCL-818L |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | High-performance DAS card with programmable gain |
| 中文描述： | 高性能DAS的可編程增益卡 |
| 文件頁數： | 57/74頁 |
| 文件大?。?/td> | 546K |
| 代理商： | PCL-818L |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
Chapter 8 Programmable counter/timer
53
OUT
Current state of counter output
NC
Null count is 1 when the last count written to the counter
register has been loaded into the counting element
The counter enable register, located at address BASE+10, has a close
relationship with the counter operation. Refer to Chapter 4,
Timer/
counter enable register
, for the register data format. The TC0 bit
enables and disables the pacer. If TC0 = 0, the pacer is enabled. If
TC0 = 1, the pacer is disabled and trigger pulses from the pacer are
kept from the A/D until TRIG0 is taken high. The TC1 bit controls the
input source for Counter 0. If TC1 = 0, Counter 0 is configured to
accept external clock pulses. If TC1 = 1, Counter 0 is internally
connected to the 100 KHz clock source.
Counter operating modes
MODE 0 Stop on terminal count
The output will be initially low after this mode of operation is set.
After you load the count into the selected count register, the output
will remain low and the counter will count. When the counter reaches
the terminal count, its output will go high and remain high until you
reload it with the mode or a new count value. The counter continues to
decrement after it reaches the terminal count. Rewriting a counter
register during counting has the following results:
1. Writing to the first byte stops the current counting.
2. Writing to the second byte starts the new count.
MODE 1 Programmable one-shot
The output is initially high. The output will go low on the count
following the rising edge of the gate input. It will then go high on the
terminal count. If you load a new count value while the output is low,
the new value will not affect the duration of the one-shot pulse until
the succeeding trigger. You can read the current count at any time
without affecting the one-shot pulse. The one-shot is retriggerable,
thus the output will remain low for the full count after any rising edge
at the gate input.
相關PDF資料 |
PDF描述 |
|---|---|
| PCL01-6 | LOW CAPACITANCE TVS ARRAY |
| PCL100 | REINIGUNG TINTE FETT OEL 100ML |
| PCL19012-SERIES | Optoelectronic |
| PCL19010-SERIES | Optoelectronic |
| PCL19011-SERIES | Optoelectronic |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCL-818LS | 制造商:ADVANTECH 制造商全稱:Advantech Co., Ltd. 功能描述:100 kS/s, 12-bit, 16-ch ISA Multifunction Card |
| PCL-818LS-CE | 制造商:Advantech Co Ltd 功能描述:PCL-818L With PCLD-8115And Cable |
| PCL81A03 | 制造商:Amphenol PCD 功能描述:METAL P-CLAMP - Bulk |
| PCL82A06 | 制造商:Amphenol PCD 功能描述:METAL P-CLAMP - Bulk |
| PCL-832-A | 制造商:Advantech Co Ltd 功能描述:3-Axis Servomotor Control ISA-bus Card |
發布緊急采購，3分鐘左右您將得到回復。