參數資料
型號: PC87393F-VJG
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 外設及接口
英文描述: 100-Pin LPC SuperI/O Devices for Portable Applications
中文描述: MULTIFUNCTION PERIPHERAL, PQFP100
封裝: TQFP-100
文件頁數: 77/148頁
文件大?。?/td> 1733K
代理商: PC87393F-VJG
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁當前第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁
2.0 Device Architecture and Configuration (Continued)
34
www.national.com
2.4
INTERRUPT SERIALIZER
The Interrupt Serializer translates parallel interrupt request (PIRQ) signals received from external devices, via the PIRQn (n
can be A, B, C or D) pins and from internal IRQ sources, into serial interrupt request data transmitted over the SERIRQ bus.
This enables the integration of devices that support only parallel IRQs in a system which supports only serial IRQs.
PIRQ signals that enter the device or internal IRQs are fed into an IRQ Mapping, Enable, and Polarity Control block. This
block maps them to their associated IRQ slots. The IRQs are then fed into the Interrupt Serializer, where they are translated
into serial data and transmitted over the SERIRQ bus.
The PIRQn input value is routed to the Interrupt Serializer as the IRQ value to be driven onto IRQ slot n.
The same slot cannot be shared among different interrupt sources in this device.
When a transition is sensed on an IRQ source,the new value of the IRQ source is transmitted over the SERIRQ bus during
the corresponding IRQ slot. For example, when a transition on PIRQA is sensed, the new value of PIRQA is transmitted
during slot n of the SERIRQ bus.
Figure 4 shows the mechanism for both interrupt serialization and wake-up.
Figure 4. Interrupt Serialization and Wake-Up Mechanism
2.5
WAKE-UP CONTROL
The Wake-Up Control module receives the parallel interrupt request (PIRQn) signals from external devices and the IRQ sig-
nals from internal sources. It generates the PWUREQ system wake-up signal. All mapped IRQ signals, both internal and
external, enter the Wake-Up Enable Control block. If one of them becomes active and is enabled for wake-up, an active
PWUREQ signal is generated.
2.6
THE PARALLEL PORT MULTIPLEXER (PPM)
The Parallel Port Multiplexer (PPM) allows connection of an external Floppy Disk Drive (FDD) through the Parallel Port con-
nector (25-pin DIN) instead of, or in addition to, the internal FDD on the normal FDC header. This is done by turning the
Parallel Port pins into an additional set of FDC pins, while isolating them from Parallel Port functionality (see Section 1.4 for
a signal multiplexing description).
A printer, or any other parallel device, may be exchanged with an external FDD without turning the system off. The PPM
logic automatically detects whether a parallel device or the FDD is connected, and routes the Parallel Port pins to either the
Parallel Port or the FDC functional blocks accordingly. See Figure 5.
To enable PPM mode, set bits 6-5 (Pin 35 Function Select) of the SIOCF5 register to the values that represent the desired
configuration (see Section 2.10.6). The control of the connection, after enabling PPM mode, is done by bit SIOCF5[7] (PNF
status) of this register as follows:
q
PNF status = 1, PPM is inactive and the Parallel Port pins are assigned Parallel Port functionality
q
PNF status = 0, PPM is active and the Parallel Port pins are assigned FDC functionality.
The value of bit SIOCF5[7] is determine by the PNF pin signal and the PNF polarity setting (bits SIOCF5[6:5]).
When PPM mode is disabled (both bits 6-5 of the SIOCF5 register = 0), the Parallel Port pins are assigned Parallel Port
functionality, regardless of the value of PNF.
The internal FDD on the normal FDC pins, and the external FDD on the Parallel Port pins can be assigned as Drive A and
Drive B, respectively, or the drive assignment can be switched between them.
IRQ Mapping
and Polarity
Control
Internal
IRQ
Sources
Control
Signals
PIRQn
Interrupt
Serializer
Bus Interface
SERIRQ
IRQ1
IRQ15
PWUREQ
Wake-Up
Enable
Control
Pins
相關PDF資料
PDF描述
PC906N 896 MHz - 940 MHz YAGI ANTENNA, 10.65 dBi GAIN, 65 deg 3dB BEAMWIDTH
PC926N 928 MHz - 960 MHz YAGI ANTENNA, 10.65 dBi GAIN, 65 deg 3dB BEAMWIDTH
PCA.1D.694.CNAD42Z CABLE TERMINATED, FEMALE, RF CONNECTOR, SOCKET
PCA.1D.694.CNAD42 CABLE TERMINATED, FEMALE, RF CONNECTOR, SOCKET
PCA.1D.694.CNAD52Z CABLE TERMINATED, FEMALE, RF CONNECTOR, SOCKET
相關代理商/技術參數
參數描述
PC87393VJG 制造商:Texas Instruments 功能描述: 制造商:Texas Instruments 功能描述:IC, SUPER I/O DEVICE, TQFP-100, Logic Device Type:Buffer, Supply Voltage Min:3V,
PC87393-VJG 制造商:NSC 制造商全稱:National Semiconductor 功能描述:100-Pin LPC SuperI/O Devices for Portable Applications
PC87410 制造商:NSC 制造商全稱:National Semiconductor 功能描述:PC87410 PCI-IDE Interface Controller
PC87410VLK 制造商:Rochester Electronics LLC 功能描述:- Bulk
PC87413 制造商:NSC 制造商全稱:National Semiconductor 功能描述:LPC ServerI/O for Servers and Workstations