參數資料
型號： OM11078
廠商： NXP Semiconductors
文件頁數： 32/57頁
文件大?。?/td> 0K
描述： KIT LCD TOUCH 5.7" FOR LPC3250
標準包裝： 1
傳感器類型： 觸摸屏幕
電源電壓： 5V
嵌入式： 是，MCU，16/32 位
已供物品： 主板，LPC3250 板，LCD 觸摸屏板，線纜，CD，調試器，電源
已用 IC / 零件： LPC3250 ARM9
配用： 568-4744-ND - MODULE DIMM LPC3250 ARM9
568-4742-ND - MODULE DIMM LPC2478 ARM7
相關產品： 568-4533-ND - IC ARM9 MCU 256K 296-TFBGA
其它名稱： 568-4743
LPC3220_30_40_50
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 2 — 20 October 2011
38 of 79
NXP Semiconductors
LPC3220/30/40/50
16/32-bit ARM microcontrollers
Only a single master and a single slave can communicate on the interface during a given
data transfer. During a data transfer the master always sends a byte of data to the slave,
and the slave always sends a byte of data to the master. The SPI implementation on the
LPC3220/30/40/50 does not support operation as a slave.
7.8.2.1
Features
Supports slaves compatible with SPI modes 0 to 3.
Half duplex synchronous transfers.
DMA support for data transmit and receive.
1-bit to 16-bit word length.
Choice of LSB or MSB first data transmission.
64 16-bit input or output FIFO.
Bit rates up to 52 Mbit/s.
Busy input function.
DMA time out interrupt to allow detection of end of reception when using DMA.
Timed interrupt to facilitate emptying the FIFO at the end of a transmission.
SPI clock and data pins may be used as general purpose pins if the SPI is not used.
Slave selects can be supported using GPO or GPIO pins
7.8.3 SSP serial I/O controller
The LPC3220/30/40/50 contains two SSP controllers. The SSP controller is capable of
operation on a SPI, 4-wire SSI, or Microwire bus. It can interact with multiple masters and
slaves on the bus. Only a single master and a single slave can communicate on the bus
during a given data transfer. The SSP supports full duplex transfers, with frames of 4 bits
to 16 bits of data flowing from the master to the slave and from the slave to the master. In
practice, often only one of these data flows carries meaningful data.
7.8.3.1
Features
Compatible with Motorola SPI, 4-wire TI SSI, and National Semiconductor Microwire
buses
Synchronous serial communication
Master or slave operation
8-frame FIFOs for both transmit and receive
4-bit to 16-bit frame
Maximum SPI bus data bit rate of 12 (Master mode) and 12 (Slave mode) of the input
clock rate
DMA transfers supported by GPDMA
7.8.4 I2C-bus serial I/O controller
There are two I2C-bus interfaces in the LPC32x0 family of controllers. These I2C blocks
can be configured as a master, multi-master or slave supporting up to 400 kHz. The I2C
blocks also support 7 or 10 bit addressing. Each has a four word FIFO for both transmit
and receive. An interrupt signal is available from each block.
相關PDF資料
PDF描述
24180C INDUCTOR 18UH 1.26A SMD
LTC1558CS-5#TRPBF IC BACKUP BATT CNTRLR 5V 16-SOIC
DK-57TS-LPC3250 KIT LCD TOUCH 5.7" FOR LPC3250
594D107X9016C2W CAP TANT 100UF 16V 10% 2812
C8051F020DK DEV KIT FOR F020/F021/F022/F023
相關代理商/技術參數
參數描述
OM11078,598 功能描述:開發板和工具包 - ARM NXP LPC3250 IRD2.0-5.7"LCD/Lnx RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
OM11079 功能描述:MODULE DIMM LPC3250 ARM9 RoHS:是 類別:編程器，開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230，RCB231，RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE
OM11079,598 功能描述:開發板和工具包 - ARM NXP LPC3250 SODIMM for IRD2.0 RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
OM11080,598 制造商:NXP Semiconductors 功能描述:LPC1768 CORTEX-M3 3.2" 2X40 LCD DISPLAY KIT, ARM CORTEX-M3 M - Boxed Product (Development Kits)
OM11082,598 功能描述:開發板和工具包 - ARM NXP LPC3250 IRD2.0-5.7"LCD/Lnx RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*