參數資料
型號： OM11078
廠商： NXP Semiconductors
文件頁數： 24/57頁
文件大?。?/td> 0K
描述： KIT LCD TOUCH 5.7" FOR LPC3250
標準包裝： 1
傳感器類型： 觸摸屏幕
電源電壓： 5V
嵌入式： 是，MCU，16/32 位
已供物品： 主板，LPC3250 板，LCD 觸摸屏板，線纜，CD，調試器，電源
已用 IC / 零件： LPC3250 ARM9
配用： 568-4744-ND - MODULE DIMM LPC3250 ARM9
568-4742-ND - MODULE DIMM LPC2478 ARM7
相關產品： 568-4533-ND - IC ARM9 MCU 256K 296-TFBGA
其它名稱： 568-4743
LPC3220_30_40_50
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 2 — 20 October 2011
30 of 79
NXP Semiconductors
LPC3220/30/40/50
16/32-bit ARM microcontrollers
– extended wait
Power-saving modes dynamically control EMC_CKE[1:0] and EMC_CLK.
Dynamic memory self-refresh mode supported by software.
Controller supports 2 k, 4 k, and 8 k row address synchronous memory parts. That is,
typical 512 MB, 256 MB, 128 MB, and 16 MB parts, with 8, 16, or 32 data bits per
device.
Two reset domains enable dynamic memory contents to be preserved over a soft
reset.
This controller does not support synchronous static memory devices (burst mode
devices).
7.6 AHB master peripherals
The LPC3220/30/40/50 implements four AHB master peripherals, which include a
General Purpose Direct Memory Access (GPDMA) controller, a 10/100 Ethernet Media
Access Controller (MAC), a Universal Serial Bus (USB) controller, and an LCD controller.
Each of these four peripherals contain an integral DMA controller optimized to support the
performance demands of the peripheral.
7.6.1 General Purpose DMA (GPDMA) controller
The GPDMA controller allows peripheral-to memory, memory-to-peripheral,
peripheral-to-peripheral, and memory-to-memory transactions. Each DMA stream
provides unidirectional serial DMA transfers for a single source and destination. For
example, a bidirectional port requires one stream for transmit and one for receive. The
source and destination areas can each be either a memory region or a peripheral, and
can be accessed through the same AHB master, or one area by each master. The DMA
controller supports the following peripheral device transfers.
Secure Digital (SD) Memory interface
High-speed UARTs
I2S0 and I2S1 ports
SPI1 and SPI2 interfaces
SSP0 and SSP1 interfaces
Memory
The DMA controls eight DMA channels with hardware prioritization. The DMA controller
interfaces to the system via two AHB bus masters, each with a full 32-bit data bus width.
DMA operations may be set up for 8-bit, 16-bit, and 32-bit data widths, and can be either
big-endian or little-endian. Incrementing or non-incrementing addressing for source and
destination are supported, as well as programmable DMA burst size. Scatter or gather
DMA is supported through the use of linked lists. This means that the source and
destination areas do not have to occupy contiguous areas of memory.
7.6.2 Ethernet MAC
The Ethernet block contains a full featured 10 Mbit/s or 100 Mbit/s Ethernet MAC
designed to provide optimized performance through the use of DMA hardware
acceleration. Features include a generous suite of control registers, half or full duplex
operation, flow control, control frames, hardware acceleration for transmit retry, receive
相關PDF資料
PDF描述
24180C INDUCTOR 18UH 1.26A SMD
LTC1558CS-5#TRPBF IC BACKUP BATT CNTRLR 5V 16-SOIC
DK-57TS-LPC3250 KIT LCD TOUCH 5.7" FOR LPC3250
594D107X9016C2W CAP TANT 100UF 16V 10% 2812
C8051F020DK DEV KIT FOR F020/F021/F022/F023
相關代理商/技術參數
參數描述
OM11078,598 功能描述:開發板和工具包 - ARM NXP LPC3250 IRD2.0-5.7"LCD/Lnx RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
OM11079 功能描述:MODULE DIMM LPC3250 ARM9 RoHS:是 類別:編程器，開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230，RCB231，RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE
OM11079,598 功能描述:開發板和工具包 - ARM NXP LPC3250 SODIMM for IRD2.0 RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
OM11080,598 制造商:NXP Semiconductors 功能描述:LPC1768 CORTEX-M3 3.2" 2X40 LCD DISPLAY KIT, ARM CORTEX-M3 M - Boxed Product (Development Kits)
OM11082,598 功能描述:開發板和工具包 - ARM NXP LPC3250 IRD2.0-5.7"LCD/Lnx RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*