- 您現在的位置：買賣IC網 > PDF目錄17162 > OM11078 (NXP Semiconductors)KIT LCD TOUCH 5.7" FOR LPC3250 PDF資料下載
參數資料
| 型號： | OM11078 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 30/57頁 |
| 文件大?。?/td> | 0K |
| 描述： | KIT LCD TOUCH 5.7" FOR LPC3250 |
| 標準包裝： | 1 |
| 傳感器類型： | 觸摸屏幕 |
| 電源電壓： | 5V |
| 嵌入式： | 是，MCU，16/32 位 |
| 已供物品： | 主板，LPC3250 板，LCD 觸摸屏板，線纜，CD，調試器，電源 |
| 已用 IC / 零件： | LPC3250 ARM9 |
| 配用： | 568-4744-ND - MODULE DIMM LPC3250 ARM9 568-4742-ND - MODULE DIMM LPC2478 ARM7 |
| 相關產品： | 568-4533-ND - IC ARM9 MCU 256K 296-TFBGA |
| 其它名稱： | 568-4743 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
LPC3220_30_40_50
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 2 — 20 October 2011
36 of 79
NXP Semiconductors
LPC3220/30/40/50
16/32-bit ARM microcontrollers
output to be used directly. The maximum PLL output frequency supported by the CPU is
266 MHz. The only output frequency supported by the USB PLL is 48 MHz, and the clock
has strict requirements for nominal frequency (500 ppm) and jitter (500 ps).
7.7.4.4
Power control modes
The LPC3220/30/40/50 supports three operational modes, two of which are specifically
designed to reduce power consumption. The modes are: Run mode, Direct Run mode,
and Stop mode.
Run mode is the normal operating mode for applications that require the CPU, AHB bus,
or any peripheral function other than the USB block to run faster than the main oscillator
frequency. In Run mode, the CPU can run at up to 266 MHz and the AHB bus can run at
up to 133 MHz.
Direct Run mode allows reducing the CPU and AHB bus rates in order to save power.
Direct Run mode can also be the normal operating mode for applications that do not
require the CPU, AHB bus, or any peripheral function other than the USB block to run
faster than the main oscillator frequency. Direct Run mode is the default mode following
chip reset.
Stop mode causes all CPU and AHB operation to cease, and stops clocks to peripherals
other than the USB block.
7.7.4.5
Reset
Reset is accomplished by an active LOW signal on the RESET input pin. A reset pulse
with a minimum width of 10 main oscillator clocks after the oscillator is stable is required to
guarantee a valid chip reset. At power-up, 10 milliseconds should be allowed for the
oscillator to start up and stabilize after VDD reaches operational voltage. An internal reset
with a minimum duration of 10 clock pulses will also be applied if the watchdog timer
generates an internal device reset.
The RESET pin is located in the RTC power domain. This means that the RTC power
must be present for an external reset to have any effect. The RTC power domain
nominally runs from 1.2 V, but the RESET pin can be driven as high as 1.95 V.
7.8
Communication peripheral interfaces
In addition to the Ethernet MAC and USB interfaces there are many more serial
communication peripheral interfaces available on the LPC3220/30/40/50. Here is a list of
the serial communication interfaces:
Seven UARTs; four standard UARTs and three high-speed UARTs
Two SPI serial I/O controllers
Two SSP serial I/O controllers
Two I2C serial I/O controllers
Two I2S audio controllers
A short functional description of each of these peripherals is provided in the following
sections.
相關PDF資料 |
PDF描述 |
|---|---|
| 24180C | INDUCTOR 18UH 1.26A SMD |
| LTC1558CS-5#TRPBF | IC BACKUP BATT CNTRLR 5V 16-SOIC |
| DK-57TS-LPC3250 | KIT LCD TOUCH 5.7" FOR LPC3250 |
| 594D107X9016C2W | CAP TANT 100UF 16V 10% 2812 |
| C8051F020DK | DEV KIT FOR F020/F021/F022/F023 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OM11078,598 | 功能描述:開發板和工具包 - ARM NXP LPC3250 IRD2.0-5.7"LCD/Lnx RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V |
| OM11079 | 功能描述:MODULE DIMM LPC3250 ARM9 RoHS:是 類別:編程器，開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230，RCB231，RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE |
| OM11079,598 | 功能描述:開發板和工具包 - ARM NXP LPC3250 SODIMM for IRD2.0 RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V |
| OM11080,598 | 制造商:NXP Semiconductors 功能描述:LPC1768 CORTEX-M3 3.2" 2X40 LCD DISPLAY KIT, ARM CORTEX-M3 M - Boxed Product (Development Kits) |
| OM11082,598 | 功能描述:開發板和工具包 - ARM NXP LPC3250 IRD2.0-5.7"LCD/Lnx RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V |
發布緊急采購，3分鐘左右您將得到回復。