- 您現在的位置：買賣IC網 > Datasheet目錄45 > NCV8881PWR2G (ON Semiconductor)IC REG TRPL BUCK/LINEAR 16SOIC Datasheet資料下載
參數資料
| 型號： | NCV8881PWR2G |
| 廠商： | ON Semiconductor |
| 文件頁數： | 23/33頁 |
| 文件大?。?/td> | 321K |
| 描述： | IC REG TRPL BUCK/LINEAR 16SOIC |
| 標準包裝： | 1 |
| 拓?fù)洌?/td> | 降壓（降壓）（1），線性（LDO）（2） |
| 功能： | 車載 |
| 輸出數： | 3 |
| 頻率 - 開關： | 170kHz |
| 電壓/電流 - 輸出 1： | 3.3 V ~ 8 V，1.5A |
| 電壓/電流 - 輸出 2： | 5V，100mA |
| 電壓/電流 - 輸出 3： | 8.5V，40mA |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 無 |
| 電源電壓： | 5 V ~ 19 V |
| 工作溫度： | -40°C ~ 150°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.295"，7.50mm 寬）裸露焊盤 |
| 供應商設備封裝： | 16-SOIC W |
| 包裝： | 標準包裝 |
| 其它名稱： | NCV8881PWR2GOSDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
NCV8881
http://onsemi.com
23
regulation, a softstart circuit slowly raises the switching
regulator error amplifier reference to V
FBR
in order to avoid
overloading the input supply.
VOLTAGE REFERENCE
An internal, temperature compensated Bandgap voltage
reference provides the SMPS Error Amplifier and the 5P0
and 8P5 linear regulators with a stable, precision reference
voltage.
SMPS ERROR AMPLIFIER
The error amplifier is an operational amplifier. The
Voltage Mode control method employed by the NCV8881
requires Type III compensation for optimum regulator
response to load and line transients.
The output voltage of the error amplifier controls the duty
cycle of the power switch by controlling the moment at
which the power switch shuts off (power switch turnons
occur at a fixed rate).
SMPS OSCILLATOR
With no connections to the ROSC or SYNC pins, the
NCV8881 switching frequency will be the factoryset
default frequency f
OSC
of the internal oscillator.
ROSC SMPS FREQUENCY CONTROL
Connection of a resistor between the ROSC pin and
ground will raise the switching frequency above the
factoryset default according to the following equation.
F
SW
+6840 R
ROSC
0.97
)170
Connection of a resistor between the ROSC pin and 5P0 will
lower the switching frequency below the default. The
programmed switching frequency should be no higher than
the highest synchronization frequency if synchronization is
used.
SMPS SYNCHRONIZATION
Applying a clock signal to the SYNC pin will cause power
switch turnon edges to coincide with rising edges of the
applied clock signal. When synchronization will be
significantly higher than the default frequency, an ROSC
resistor which sets the internal oscillator frequency at (but
no higher than) the synchronization frequency can be used
to maintain the switching frequency approximately the same
as the synchronization frequency in the absence of the
SYNC signal.
Besides controlling the switching frequency, the ROSC
resistor controls the internal ramp slope, and can be used to
adjust the gain of the pulse width modulator.
A steady low or high SYNC input will restore SMPS
operation to the factoryset default or ROSC programmed
frequency after the Desynchronization delay.
OUTPUT VOLTAGE REGULATION MONITOR
When the FB voltage is below V
FBMONL
, RESB is pulled
low, and the POR, BOOT and Watchdog Delays are
initialized. When FB voltage exceeds V
FBMONH
the POR
Delay begins to time out. If, when the FB voltage is below
V
FBMONL
, the SoftStart Timer has expired and the EN
input is low, the NCV8881 will completely shut off (see
Figures 46 through 48).
0
8P5
1
2
3
4
5
6
7
9
10
11
OUTPUT
ENABLE
5P0
VIN
8
SMPS
SOFTSTART TIMER
ShortCircuit Threshold
Current is Limited
Regulation Threshold
Figure 46. SMPS Overload During Startup
相關PDF資料 |
PDF描述 |
|---|---|
| NE1617ADS,112 | IC TEMP MONITOR 16SSOP |
| NE1619DS,118 | IC TEMP MONITOR 16SSOP |
| NIS5112D1R2G | IC ELECTRONIC FUSE HOTSWAP 8SOIC |
| NIS5132MN2TXG | IC ELECTRONIC FUSE 12V 10DFN |
| NIS5132MN3TXG | IC ELECTRONIC FUSE 12V 10-DFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCV890100 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:1.2A, 2MHz Automotive Buck Switching Regulator |
| NCV890100MWTXG | 功能描述:IC REG BUCK ADJ 1.2A 8-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:50 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:5 V ~ 25 V 輸入電壓:2.3 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:600kHz，1.2MHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 包裝:管件 供應商設備封裝:8-MSOP |
| NCV890100PDR2G | 功能描述:直流/直流開關調節器 Auto Buck Switching Regulator 1.2A 2 MHz RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| NCV890101 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:1.2A, 2MHz Automotive Buck Switching Regulator |
| NCV890101MWTXG | 功能描述:IC REG BUCK ADJ 1.2A 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:兩者兼有 輸出數:1 輸出電壓:5V，1 V ~ 10 V 輸入電壓:3.5 V ~ 28 V PWM 型:電流模式 頻率 - 開關:220kHz ~ 1MHz 電流 - 輸出:600mA 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:16-QSOP |
發布緊急采購，3分鐘左右您將得到回復。