參數資料
型號: MMDF2C03HDR2
廠商: MOTOROLA INC
元件分類: JFETs
英文描述: 2 A, 30 V, 0.09 ohm, 2 CHANNEL, N AND P-CHANNEL, Si, POWER, MOSFET
封裝: SO-8
文件頁數: 10/12頁
文件大小: 381K
代理商: MMDF2C03HDR2
MMDF2C03HD
7
Motorola TMOS Power MOSFET Transistor Device Data
DRAIN–TO–SOURCE DIODE CHARACTERISTICS
The switching characteristics of a MOSFET body diode
are very important in systems using it as a freewheeling or
commutating diode. Of particular interest are the reverse re-
covery characteristics which play a major role in determining
switching losses, radiated noise, EMI and RFI.
System switching losses are largely due to the nature of
the body diode itself. The body diode is a minority carrier de-
vice, therefore it has a finite reverse recovery time, trr, due to
the storage of minority carrier charge, QRR, as shown in the
typical reverse recovery wave form of Figure 15. It is this
stored charge that, when cleared from the diode, passes
through a potential and defines an energy loss. Obviously,
repeatedly forcing the diode through reverse recovery further
increases switching losses. Therefore, one would like a
diode with short trr and low QRR specifications to minimize
these losses.
The abruptness of diode reverse recovery effects the
amount of radiated noise, voltage spikes, and current ring-
ing. The mechanisms at work are finite irremovable circuit
parasitic inductances and capacitances acted upon by high
di/dts. The diode’s negative di/dt during ta is directly con-
trolled by the device clearing the stored charge. However,
the positive di/dt during tb is an uncontrollable diode charac-
teristic and is usually the culprit that induces current ringing.
Therefore, when comparing diodes, the ratio of tb/ta serves
as a good indicator of recovery abruptness and thus gives a
comparative estimate of probable noise generated. A ratio of
1 is considered ideal and values less than 0.5 are considered
snappy.
Compared to Motorola standard cell density low voltage
MOSFETs, high cell density MOSFET diodes are faster
(shorter trr), have less stored charge and a softer reverse re-
covery characteristic. The softness advantage of the high
cell density diode means they can be forced through reverse
recovery at a higher di/dt than a standard cell MOSFET
diode without increasing the current ringing or the noise gen-
erated. In addition, power dissipation incurred from switching
the diode will be less due to the shorter recovery time and
lower switching losses.
N–Channel
P–Channel
Figure 10. Diode Forward Voltage versus Current
I S
,SOURCE
CURRENT
(AMPS)
VSD, SOURCE–TO–DRAIN VOLTAGE (VOLTS)
1.0
1.5
2.0
3.0
2.5
0.5
0.55
0
0.5
TJ = 25°C
VGS = 0 V
0.6
0.65
0.7
0.75
0.8
0.85
0.5
0.7
0.9
1.1
1.3
1.9
0
0.4
1.2
1.6
2
VSD, SOURCE–TO–DRAIN VOLTAGE (VOLTS)
I S
,SOURCE
CURRENT
(AMPS)
0.8
1.5
1.7
TJ = 25°C
VGS = 0 V
相關PDF資料
PDF描述
MMDF2P01HDR2 3.4 A, 12 V, 0.18 ohm, 2 CHANNEL, P-CHANNEL, Si, POWER, MOSFET
MMDF3N06HDR2 3300 mA, 60 V, 2 CHANNEL, N-CHANNEL, Si, SMALL SIGNAL, MOSFET
MMDF4207R2 4.8 A, 20 V, 0.033 ohm, P-CHANNEL, Si, POWER, MOSFET
MMDF4207R2 4.8 A, 20 V, 0.033 ohm, P-CHANNEL, Si, POWER, MOSFET
MMDF4P03HDR2 4 A, 30 V, 0.085 ohm, 2 CHANNEL, P-CHANNEL, Si, POWER, MOSFET, SO-8
相關代理商/技術參數
參數描述
MMDF2C03HDR2G 功能描述:MOSFET COMP S08C 30V 4.1A 70mOhm RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS(導通):0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube
MMDF2C03HDR2G 制造商:ON Semiconductor 功能描述:MOSFET
MMDF2N02E 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Power MOSFET 2 Amps, 25 Volts N−Channel SO−8, Dual
MMDF2N02ER2 功能描述:MOSFET 25V 2A N-Channel RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS(導通):0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube
MMDF2N02ER2G 功能描述:MOSFET NFET SO8D 25V 3.6A 100mOhm RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS(導通):0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube