- 您現在的位置：買賣IC網 > PDF目錄11750 > MCZ33780EGR2 (Freescale Semiconductor)IC MASTER DUAL DBUS DIFF 16-SOIC PDF資料下載
參數資料
| 型號： | MCZ33780EGR2 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 9/37頁 |
| 文件大小： | 0K |
| 描述： | IC MASTER DUAL DBUS DIFF 16-SOIC |
| 標準包裝： | 1,000 |
| 系列： | * |
| 應用： | * |
| 接口： | * |
| 電源電壓： | * |
| 封裝/外殼： | 16-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 16-SOIC W |
| 包裝： | 帶卷 (TR) |
| 安裝類型： | 表面貼裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
Analog Integrated Circuit Device Data
Freescale Semiconductor
17
33780
FUNCTIONAL DESCRIPTIONS
FUNCTIONAL INTERNAL BLOCK DESCRIPTION
SPREAD SPECTRUM
Figure 12. Spread Spectrum Block Diagram
The dominant source of radiated electromagnetic
interference (EMI) from the DBUS bus is due to the regular
periodic frequency of the data bits. At a steady bit rate, the
time period for each bit is the same, which results in a steady
fundamental frequency plus harmonics. This results in
undesired signals appearing at multiples of the frequency
that can be strong enough to interfere with a desired signal.
A significant decrease of radiated EMI can be achieved by
randomly changing the duration of each bit. This can
significantly reduce the amplitude by having the signal spend
a much smaller percentage of time at any specific frequency.
The signal strength of the fundamental and harmonics are
reduced directly by the percentage of time it spends on a
specific frequency. For instance, if the bit rate is 136 kbps,
there will be a harmonic at 680 kHz. If it is changed in
frequency so that only 1/10 of the bits are at the 136 kbps
rate, the signal energy at 680 kHz will be reduced by 90%.
A circuit to do this is included in this IC and can perform the
spreading of the signal independently for each channel. This
is done in the Spread Spectrum (SS) Block Diagram shown
in Figure 12.
Spreading can be enabled by setting the SSENn bits in the
DnSSCTRL registers. There are 64 possible bit durations that
are equally spaced between the shortest and longest bit
times. Because they are evenly spaced by a time difference
and not by a frequency difference (the reciprocal of time), all
frequency domain parameters of the SS block are expressed
in units of time.
VCO
The output of the voltage-controlled oscillator (VCO) is
used as the bit rate clock. Three cycles of this clock are used
to create each bit of data on the DBUS.
There are two voltages that control the period (1/
frequency) of the signal coming from the VCO. The voltage
coming from the Center Frequency DAC (Digital-to-Analog
Converter) in Figure 12 is used to keep the average period
constant. The voltage coming from the Spreader DAC
changes the period in random steps to spread the signal. The
Phase Locked Loop (PLL)-derived changes are much slower
to update the period than the ones derived from the Spreader
Logic. This prevents the two “l(fā)oops” from interacting with
each other.
PLL
The PLL loop compensates for temperature drift and the
variations in processing of the IC that would otherwise
change the average data rate (center frequency). It does this
by comparing a time reference derived from the clock signal
(4.0 MHz) to the period of the VCO output. If the ratio is not
correct, it will change the frequency of the VCO by changing
the digital value it sends to the Center Frequency DAC.
The PLL has fast and slow update rates for making these
changes. It enters a fast update mode automatically anytime
the OFFSET register is written to using the SPI, or following
a reset. This fast acquisition mode consists of 64 VCO update
cycles (1.4 ms per update cycle) that last about 90 ms. This
is done to quickly adjust the center frequency after changes
have been made. After the fast acquisition, the PLL switches
PLL Logic
Spreader Logic
Center
Frequency
DAC
Modulation
DAC
VCO
CLK (4.0 MHz typ)
CLK_VCOn (408 kHz typ)
OFFSET[8:0]
PLLOFF
SSEN
DEV[1:0]
PRBS[1:0]
SSUD
相關PDF資料 |
PDF描述 |
|---|---|
| PIC18F27J13-I/SO | IC PIC MCU 128KB FLASH 28SOIC |
| D38999/20FE99PA | CONN RCPT 23POS WALL MNT W/PINS |
| V300B12H150B3 | CONVERTER MOD DC/DC 12V 150W |
| V300B12H150B2 | CONVERTER MOD DC/DC 12V 150W |
| V300B12H150B | CONVERTER MOD DC/DC 12V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCZ33781EK | 功能描述:輸入/輸出控制器接口集成電路 DBUS2 MASTER STND RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| MCZ33781EKR2 | 功能描述:輸入/輸出控制器接口集成電路 DBUS2 MASTER STND RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| MCZ33784EF | 功能描述:加速計 - 板上安裝 DBUS2 SENSOR INTERFACE RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C |
| MCZ33784EF/R2- | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:DSI 2.02 Sensor Interface |
| MCZ33784EFR2 | 功能描述:加速計 - 板上安裝 DBUS2 SENSOR INTERFACE RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C |
發布緊急采購，3分鐘左右您將得到回復。