- 您現在的位置：買賣IC網 > PDF目錄11750 > MCZ33780EGR2 (Freescale Semiconductor)IC MASTER DUAL DBUS DIFF 16-SOIC PDF資料下載
參數資料
| 型號： | MCZ33780EGR2 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 26/37頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MASTER DUAL DBUS DIFF 16-SOIC |
| 標準包裝： | 1,000 |
| 系列： | * |
| 應用： | * |
| 接口： | * |
| 電源電壓： | * |
| 封裝/外殼： | 16-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 16-SOIC W |
| 包裝： | 帶卷 (TR) |
| 安裝類型： | 表面貼裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
Analog Integrated Circuit Device Data
32
Freescale Semiconductor
33780
FUNCTIONAL DEVICE OPERATION
LOGIC COMMANDS AND REGISTERS
SWLEN[3:0]–Short Word Length in Bits
These bits specify the bit length of the short word
command that will be sent onto the specified DBUS channel.
The reset value for these bits is 1000 (8 bits), which is the
default DSI value. Allowed SWLEN[3:0] values range from
8 bits to 15 bits. If an attempt is made to write a value that is
less than 8 bits, a 1 is automatically written to SWLEN3,
thereby making the register value greater than or equal to 8
bits.
Note If a SWLEN[3:0] value greater than 8 bits is chosen,
it is necessary to write a full 8 bits into both the DnL and DnH
registers with an SPI command, even though there will be
some MSBs of DnH that are not sent out on the DBUS.
Similarly, to read the data back onto the SPI, it is necessary
to read the full DnL and DnH registers, ignoring unused DnH
bits.
The SWLEN3 bit is not used, since words less than 8 bits
are not allowed. When reading the SWLEN3, bit 0 is always
return; however, the logic interprets the bit as if it were a 1.
CRCLEN[3:0]–CRC Length in Bits
These bits specify the bit length of CRCs that are sent out
with commands and read back in. The length is valid for both
short and long word commands. The reset value for these
bits is 0100 (4 bits), which is the default DSI value. Allowed
CRCLEN[3:0] values range from 0 bits (no CRC) to 8 bits. If
an attempt is made to write a value that is greater than 8 bits,
the value 8 (1000) is automatically written into this register.
The CRCLEN[3:0] value overrides the CRCPOLY and
CRCSEED bit values that are beyond what the CRCLEN[3:0]
specifies.
DnSSCTRL REGISTERS
These registers control the operation of the spread
spectrum circuits.
A write to the register will abort any current activity on the
bus. Any bit changes will take place on the next DBUS
transaction following the conclusion of the SPI write to this
register. The bit assignments are shown in Figure 33.
Figure 33. Dn Spread Spectrum Control Register Bit Assignments
SSEN–Spread Spectrum Enable for Channel n
This bit enables spread spectrum on the particular channel
that is specified. With deviation enabled, the DBUS bit
periods will be pseudo-randomly varied from one bit to the
next, while keeping the time between successive Frame
edges constant. The DBUS data rate will be controlled by a
programmable PLL loop, rather than the 4.0 MHz external
clock.
PLLOFF–Spread Spectrum PLL Disable for Channel n
This bit disables the PLL loop updating of the DBUS
frequency. The PLL adjusts the spread spectrum frequency
up and down by comparing it to a divided down version of the
external 4.0 MHz clock. If the internal spread spectrum clock
is stable, then it is useful to be able to turn off the PLL
updates, thus avoiding clock jitter. In order to change the
frequency of the PLL, PLLOFF must be reset. A write
operation to the frequency offset registers is not allowed
while PLLOFF is set.
PRBS[1:0]–Pseudo-Random Binary Sequence
Register Length for Channel n
These bits control the length of the Pseudo-Random
Binary Sequence register (PRBS). The PRBS is used to
randomize the DBUS spread spectrum frequencies, and
choosing different lengths will change the XOR tap position
on the PRBS. The following Table 11 describes the bit
encoding of this field.
SPI Data Bit
Bit 7
6
5
4
3
2
1
0
Read/Write
0
SSEN
PLLOFF
PRBS1
PRBS0
DEV1
DEV0
Reset
0
Table 11. PRBS Bit Encoding
PRBS[1:0]
PRBS Reg
Length
XOR Input A
XOR Input B
00
6
5
4
01
7
6
5
10
11
10
8
11
15
14
13
相關PDF資料 |
PDF描述 |
|---|---|
| PIC18F27J13-I/SO | IC PIC MCU 128KB FLASH 28SOIC |
| D38999/20FE99PA | CONN RCPT 23POS WALL MNT W/PINS |
| V300B12H150B3 | CONVERTER MOD DC/DC 12V 150W |
| V300B12H150B2 | CONVERTER MOD DC/DC 12V 150W |
| V300B12H150B | CONVERTER MOD DC/DC 12V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCZ33781EK | 功能描述:輸入/輸出控制器接口集成電路 DBUS2 MASTER STND RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| MCZ33781EKR2 | 功能描述:輸入/輸出控制器接口集成電路 DBUS2 MASTER STND RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| MCZ33784EF | 功能描述:加速計 - 板上安裝 DBUS2 SENSOR INTERFACE RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C |
| MCZ33784EF/R2- | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:DSI 2.02 Sensor Interface |
| MCZ33784EFR2 | 功能描述:加速計 - 板上安裝 DBUS2 SENSOR INTERFACE RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C |
發布緊急采購，3分鐘左右您將得到回復。