參數資料
型號: MC705L16CFUE
廠商: Freescale Semiconductor
文件頁數: 89/146頁
文件大?。?/td> 0K
描述: IC MCU 8BIT EPROM 80-QFP
標準包裝: 84
系列: HC05
核心處理器: HC05
芯體尺寸: 8-位
速度: 2.1MHz
連通性: SPI
外圍設備: LCD,POR,WDT
輸入/輸出數: 16
程序存儲器容量: 16KB(16K x 8)
程序存儲器類型: OTP
RAM 容量: 512 x 8
電壓 - 電源 (Vcc/Vdd): 3 V ~ 5.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 80-QFP
包裝: 托盤
MC68HC05L16 MC68HC705L16 Data Sheet, Rev. 4.1
Freescale Semiconductor
47
Chapter 5
Low-Power Modes
5.1 Introduction
The MCU has two power-saving modes, stop and wait. Flowcharts of these modes are shown in
5.2 Stop Mode
The STOP instruction places the MCU in its lowest-power mode. In stop mode, the internal main oscillator
OSC is turned off, halting all internal processing, including timer operations (timer 1, timer 2, and
computer operating properly (COP) watchdog timer). Suboscillator XOSC does not stop oscillating.
Therefore, if XOSC is used as the clock source for the COP watchdog timer, COP is still functional in stop
During stop mode, the timer prescaler is cleared. The I bit in the condition code register (CCR) is cleared
to enable external interrupts. All other registers and memory remain unaltered. All input/output lines
remain unchanged. The processor can be brought out of stop mode only by RESET or an interrupt from
IRQ1, IRQ2, KWI, SSPI (slave mode only), or TBI. See Chapter 7 Oscillators/Clock Distributions.
5.3 Wait Mode
The WAIT instruction places the MCU in a low-power mode, but wait mode consumes more power than
stop mode. All CPU action is suspended, but on-chip peripherals and oscillators remain active. Any
interrupt or reset (including a COP reset) will cause the MCU to exit wait mode.
During wait mode, the I bit in the CCR is cleared to enable interrupts. All other registers, memory, and
input/output lines remain in their previous state. The timers may be enabled to allow a periodic exit from
wait mode. Wait mode must be exited and the COP must be reset to prevent a COP timeout.
The reduction of power in wait mode depends on how many of the on-chip peripheral's clocks can be shut
down. Therefore, the amount of power that will be consumed is dependent on the application, and it would
be prohibitive to test all parts for all variations. For these reasons, the values given in Chapter 12 Electrical
Specifications reflect typical application conditions after initial characterization of silicon.
相關PDF資料
PDF描述
MC705X32VFUE IC MCU 8BIT 32K FLASH 64-QFP
MC711P2CFNE3 IC MCU 8BIT 84-PLCC
MC7410VU450NE IC MPU RISC 32BIT 360-FCCBGA
MC7447AVU1333LB IC MPU RISC 32BIT 360-BGA
MC7448VS600ND IC MPU RISC 600MHZ 360-FCCLGA
相關代理商/技術參數
參數描述
MC705P6ACDWE 功能描述:8位微控制器 -MCU MCU 176 BYTES RAM A/D RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC705P6ACDWE 制造商:Freescale Semiconductor 功能描述:8-Bit Microcontroller IC
MC705P6ACDWER 功能描述:IC MCU 8BIT EPROM 28-SOIC RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:HC05 標準包裝:1 系列:AVR® ATmega 核心處理器:AVR 芯體尺寸:8-位 速度:16MHz 連通性:I²C,SPI,UART/USART 外圍設備:欠壓檢測/復位,POR,PWM,WDT 輸入/輸出數:32 程序存儲器容量:32KB(16K x 16) 程序存儲器類型:閃存 EEPROM 大小:1K x 8 RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:44-TQFP 包裝:剪切帶 (CT) 其它名稱:ATMEGA324P-B15AZCT
MC705P6ACPE 功能描述:8位微控制器 -MCU HC705P6A 176 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC705P6AMDWE 功能描述:8位微控制器 -MCU MCU 176 BYTES RAM EPP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT