參數資料
型號： MAX9879ERV+T
廠商： Maxim Integrated Products
文件頁數： 21/32頁
文件大小： 0K
描述： IC AUDIO SUBSYSTEM 30-UCSP
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 2,500
系列： DirectDrive®
類型： D 類
輸出類型： 2-通道（立體聲）帶立體聲耳機
在某負載時最大輸出功率 x 通道數量： 715mW x 2 @ 8 歐姆; 58mW x 2 @ 16 歐姆
電源電壓： 2.7 V ~ 5.5 V
特點： 消除爆音，差分輸入，I²C，靜音，短路和熱保護，關機，音量控制
安裝類型： 表面貼裝
供應商設備封裝： 30-UCSP（5x6）
封裝/外殼： 30-WFBGA，CSPBGA
包裝： 帶卷 (TR)
MAX9879
Stereo Class D Audio Subsystem
with DirectDrive Headphone Amplifier
28
Maxim Integrated
actual speaker lead length. Select a capacitor less than
1nF based on EMI performance.
Input Capacitor
An input capacitor, CIN, in conjunction with the input
impedance of the MAX9879 forms a highpass filter that
removes the DC bias from an incoming signal. The AC-
coupling capacitor allows the amplifier to automatically
bias the signal to an optimum DC level. Assuming zero
source impedance, the -3dB point of the highpass filter
is given by:
Choose CIN so that f-3dB is well below the lowest fre-
quency of interest. Use capacitors whose dielectrics
have low-voltage coefficients, such as tantalum or alu-
minum electrolytic. Capacitors with high-voltage coeffi-
cients, such as ceramics, may result in increased
distortion at low frequencies.
BIAS Capacitor
BIAS is the output of the internally generated DC bias volt-
age. The BIAS bypass capacitor, CBIAS, reduces power
supply and other noise sources at the common-mode
bias node. Bypass BIAS with a 1F capacitor to GND.
Charge-Pump Capacitor Selection
Use capacitors with an ESR less than 100m
Ω for optimum
performance. Low-ESR ceramic capacitors minimize the
output resistance of the charge pump. Most surface-
mount ceramic capacitors satisfy the ESR requirement.
For best performance over the extended temperature
range, select capacitors with an X7R dielectric.
Flying Capacitor (C1)
The value of the flying capacitor (C1) affects the output
resistance of the charge pump. A C1 value that is too
small degrades the device’s ability to provide sufficient
current drive, which leads to a loss of output voltage.
Increasing the value of C1 reduces the charge-pump out-
put resistance to an extent. Above 1F, the on-resistance
of the switches and the ESR of C1 and C2 dominate.
Output Holding Capacitor (C2)
The output capacitor value and ESR directly affect the
ripple at VSS. Increasing the value of C2 reduces output
ripple. Likewise, decreasing the ESR of C2 reduces both
ripple and output resistance. Lower capacitance values
can be used in systems with low maximum output power
levels. See the
Output Power vs. Load Resistance graph
in the
Typical Operating Characteristics.
PVDD Bulk Capacitor (C3)
In addition to the recommended PVDD bypass capaci-
tance, bulk capacitance equal to C3 should be used.
Place the bulk capacitor as close as possible to the device.
Supply Bypassing,
Layout, and Grounding
Proper layout and grounding are essential for optimum
performance. Use wide traces for the power-supply
inputs and amplifier outputs to minimize losses due to
parasitic trace resistance. Wide traces also aid in mov-
ing heat away from the package. Proper grounding
improves audio performance, minimizes crosstalk
between channels, and prevents any switching noise
from coupling into the audio signal. Connect PGND and
GND together at a single point on the PCB. Route all
traces that carry switching transients away from GND
and the traces/components in the audio signal path.
Connect the PVDD_ pins to a 2.7V to 5.5V source.
Bypass PVDD_ to PGND pin with a 1F ceramic capac-
itor. Additional bulk capacitance should be used to pre-
vent power supply pumping. Bypass PVDD_ to the
PGND pin with a 1F ceramic capacitor. Additional
bulk capacitance should be used to prevent power-
supply pumping. Place the bypass capacitors as close
as possible to the MAX9879.
Connect VDD to PVDD_. Bypass VDD to GND with a
1F capacitor. Place the bypass capacitors as close as
possible to the MAX9879.
f
RC
dB
IN IN
=
3
1
2
π
RF SUSCEPTIBILITY
MAX9877
fig14
FREQUENCY (Hz)
EFFICIENCY
(dB
μ
)
10k
1k
100
-130
-110
-90
-70
-50
-30
-10
-150
10
100k
THRESHOLD OF HEARING
MAX9879
NOISE FLOOR
Figure 14. MAX9879 Susceptibility to a GSM Cell Phone Radio
相關PDF資料
PDF描述
MAX987EUK-T IC COMP MICRPWR R-R I/O SOT23-5
MAX9888EWY+T IC CODEC AUDIO FLEXSOUND 63WLP
MAX9890AEBL+T IC SUPP CLICK-POP 9-UCSP
MAX9892ELT+T IC ELIMINATOR CLICK/POP 6UDFN
MAX995EUD+ IC COMPARATOR R-R 14-TSSOP
相關代理商/技術參數
參數描述
MAX9879EVKIT+ 功能描述:音頻放大器 Stereo Class D Audio Subsystem with DirectDrive Headphone Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
MAX987ESA 功能描述:校驗器 IC Single uPower Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel
MAX987ESA+ 功能描述:校驗器 IC Single uPower Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel
MAX987ESA+T 功能描述:校驗器 IC Single uPower Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel
MAX987ESA-T 功能描述:校驗器 IC Single uPower Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*