- 您現在的位置：買賣IC網 > PDF目錄383491 > MAX7032 (Maxim Integrated Products, Inc.) Low-Cost, Crystal-Based, Programmable, ASK/FSK Transceiver with Fractional-N PLL PDF資料下載
參數資料
| 型號： | MAX7032 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | Low-Cost, Crystal-Based, Programmable, ASK/FSK Transceiver with Fractional-N PLL |
| 中文描述： | 低成本、基于晶振的可編程ASK/FSK收發器，帶有N分頻PLL |
| 文件頁數： | 13/32頁 |
| 文件大?。?/td> | 449K |
| 代理商： | MAX7032 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Detailed Description
The MAX7032 300MHz to 450MHz CMOS transceiver
and a few external components provide a complete
transmit and receive chain from the antenna to the digi-
tal data interface. This device is designed for transmit-
ting and receiving ASK and FSK data. All transmit
frequencies are generated by a fractional-N-based syn-
thesizer, allowing for very fine frequency steps in incre-
ments of f
XTAL
/ 4096. The receive LO is generated by
a traditional integer-N-based synthesizer. Depending
on component selection, data rates as high as 33kbps
(Manchester encoded) or 66kbps (NRZ encoded) can
be achieved.
Receiver
Low-Noise Amplifier (LNA)
The LNA is a cascode amplifier with off-chip inductive
degeneration that achieves approximately 30dB of volt-
age gain that is dependent on both the antenna match-
ing network at the LNA input, and the LC tank network
between the LNA output and the mixer inputs.
The off-chip inductive degeneration is achieved by
connecting an inductor from LNASRC to AGND. This
inductor sets the real part of the input impedance at
LNAIN, allowing for a more flexible match for low-input
impedance such as a PC board trace antenna. A nomi-
nal value for this inductor with a 50
input impedance
is 12nH at 315MHz and 10nH at 434MHz, but the
inductance is affected by PC board trace length.
LNASRC can be shorted to ground to increase sensitiv-
ity by approximately 1dB, but the input match must
then be reoptimized.
The LC tank filter connected to LNAOUT consists of L5
and C9 (see the
Typical Application Circuit
). Select L5
and C9 to resonate at the desired RF input frequency.
The resonant frequency is given by:
where L
TOTAL
= L5 + L
PARASITICS
and C
TOTAL
= C9 +
C
PARASITICS
.
L
PARASITICS
and C
PARASITICS
include inductance and
capacitance of the PC board traces, package pins,
mixer input impedance, LNA output impedance, etc.
These parasitics at high frequencies cannot be
ignored, and can have a dramatic effect on the tank fil-
ter center frequency. Lab experimentation must be
done to optimize the center frequency of the tank. The
total parasitic capacitance is generally between 5pF
and 7pF.
Automatic Gain Control (AGC)
When the AGC is enabled, it monitors the RSSI output.
When the RSSI output reaches 1.28V, which corre-
sponds to an RF input level of approximately -55dBm,
the AGC switches on the LNA gain-reduction attenua-
tor. The attenuator reduces the LNA gain by 36dB,
thereby reducing the RSSI output by about 540mV to
740mV. The LNA resumes high-gain mode when the
RSSI output level drops back below 680mV (approxi-
mately -59dBm at the RF input) for a programmable
interval called the AGC dwell time. The AGC has a hys-
teresis of approximately 4dB. With the AGC function,
the RSSI dynamic range is increased, allowing the
MAX7032 to reliably produce an ASK output for RF
input levels up to 0dBm with a modulation depth of
18dB. AGC is not required and can be disabled in
either ASK or FSK mode. AGC is not necessary for FSK
mode because large received signal levels do not
affect FSK performance.
f
L
C
TOTAL
TOTAL
=
×
1
2
π
M
Low-Cost, Crystal-Based, Programmable,
ASK/FSK Transceiver with Fractional-N PLL
______________________________________________________________________________________
13
Pin Description (continued)
PIN
NAME
FUNCTION
27
HV
IN
High-Voltage Supply Input. For 3V operation, connect HV
IN
to PAV
DD
, AV
DD
, and DV
DD
.
For 5V
operation, tie only HV
IN
to 5V. Bypass HV
IN
to GND with 0.01μF and 220pF capacitors placed as
close to the pin as possible.
28
29
30
31
32
EP
CS
DIO
SCLK
XTAL1
XTAL2
GND
Serial Interface Active-Low Chip Select
Serial Interface Serial Data Input/Output
Serial Interface Clock Input
Crystal Input 1. Bypass to GND if XTAL2 is driven by an AC-coupled external reference.
Crystal Input 2. XTAL2 can be driven from an AC-coupled external reference.
Exposed Paddle. Solder evenly to the board’s ground plane for proper operation.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX7032ATJ | Low-Cost, Crystal-Based, Programmable, ASK/FSK Transceiver with Fractional-N PLL |
| MAX708CUA-T | Analog IC |
| MAX707CUA-T | Analog IC |
| MAX707ESA-T | Analog IC |
| MAX708T | +3V Voltage Monitoring.Low-Cost.µ.P Supervisory Circuits |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX7032_09 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Low-Cost, Crystal-Based, Programmable, ASK/FSK Transceiver with Fractional-N PLL |
| MAX7032_10 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Low-Cost, Crystal-Based, Programmable, ASK/FSK Transceiver with Fractional-N PLL |
| MAX7032ATJ | 制造商:Maxim Integrated Products 功能描述:LOW-COST,CRYSTAL-BASED,308MHZ,315MHZ,&433.92M - Rail/Tube |
| MAX7032ATJ+ | 功能描述:射頻收發器 Crystal-Based Prog ASK/FSK Transceiver RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| MAX7032ATJ+T | 功能描述:射頻收發器 Crystal-Based Prog ASK/FSK Transceiver RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。