- 您現在的位置：買賣IC網 > PDF目錄383443 > MAX5895 (Maxim Integrated Products, Inc.) 16-Bit, 500Msps Interpolating and Modulating Dual DAC with CMOS Inputs PDF資料下載
參數資料
| 型號： | MAX5895 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 16-Bit, 500Msps Interpolating and Modulating Dual DAC with CMOS Inputs |
| 中文描述： | 16位、500Msps、插值與調制、雙路DAC，CMOS輸入 |
| 文件頁數： | 12/32頁 |
| 文件大?。?/td> | 807K |
| 代理商： | MAX5895 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
M
16-Bit, 500Msps Interpolating and Modulating
Dual DAC with CMOS Inputs
12
______________________________________________________________________________________
Detailed Description
The MAX5895 dual, 500Msps, high-speed, 16-bit, cur-
rent-output DAC provides superior performance in
communication systems requiring low-distortion ana-
log-signal reconstruction. The MAX5895 combines two
DAC cores with 8x/4x/2x/1x programmable digital inter-
polation filters, a digital quadrature modulator, an SPI-
compatible serial interface for programming the device,
and an on-chip 1.20V reference. The full-scale output
current range is programmable from 2mA to 20mA to
optimize power dissipation and gain control.
Each channel contains three selectable interpolating fil-
ters making the MAX5895 capable of 1x, 2x, 4x, or 8x
interpolation, which allows for low-input and high-out-
put data rates. When operating in 8x interpolation
mode, the interpolator increases the DAC conversion
rate by a factor of eight, providing an eight-fold
increase in separation between the reconstructed
waveform spectrum and its first image. The MAX5895
accepts either two’s complement or offset binary input
data format and can operate from either a single- or
dual-port input bus.
The MAX5895 includes modulation modes at f
IM
/ 2 and
f
IM
/ 4, where f
IM
is the data rate at the input of the modu-
lator. If 2x interpolation is used, this data rate is 2x the
input data rate. If 4x or 8x interpolation is used, this data
rate is 4x the input data rate. Table 1 summarizes the
modulator operating data rates for dual-port mode.
The power-down modes can be used to turn off each
DAC’s output current or the entire digital section.
Programming both DACs into power-down simultane-
ously will automatically power down the digital interpo-
lator filters. Note the SPI section is always active.
The analog and digital sections of the MAX5895 have
separate power-supply inputs (AV
DD3.3
, AV
DD1.8
,
AV
CLK
, DV
DD3.3
, and DV
DD1.8
), which minimize noise
coupling from one supply to the other. AV
DD1.8
and
DV
DD1.8
operate from a typical 1.8V supply, and all
other supply inputs operate from a typical 3.3V supply.
Serial Interface
The SPI-compatible serial interface programs the
MAX5895 registers. The serial interface consists of the
CS
, SDI, SCLK, and SDO. Data is shifted into SDI on
the rising edge of the SCLK when
CS
is low. When
CS
is high, data presented at SDI is ignored and SDO is in
high-impedance mode.
Note:
CS
must transition high
after each read/write operation.
SDO is the serial data
output for reading registers to facilitate easy debug-
ging during development. SDI and SDO can be con-
nected together to form a 3-wire serial interface bus or
remain separate and form a 4-wire SPI bus.
The serial interface supports two-byte transfer in a
communication cycle. The first byte is a control byte
written to the MAX5895 only. The second byte is a data
byte and can be written to or read from the MAX5895.
Table 1. Quadrature Modulator Operating Data Rates (f
IM
is the Data Rate at the Input of
the Modulator) for Dual-Port Mode
INTERPOLATION RATE
MODULATION MODE (f
LO
)
MODULATION FREQUENCY
RELATIVE TO f
DAC
f
DAC
/ 2
f
DAC
/ 4
f
DAC
/ 2
f
DAC
/ 4
f
DAC
/ 2
f
DAC
/ 4
f
DAC
/ 4
f
DAC
/ 8
MODULATION FREQUENCY
RELATIVE TO f
DATA
f
DATA
/ 2
f
DATA
/ 4
f
DATA
f
DATA
/ 2
2 x f
DATA
f
DATA
2 x f
DATA
f
DATA
f
IM
/ 2
f
IM
/ 4
f
IM
/ 2
f
IM
/ 4
f
IM
/ 2
f
IM
/ 4
f
IM
/ 2
f
IM
/ 4
1x
2x
4x
8x
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5895EGK | 16-Bit, 500Msps Interpolating and Modulating Dual DAC with CMOS Inputs |
| MAX5901ACEUT | Analog IC |
| MAX5927 | Low-Voltage. Quad. Hot-Swap Controllers/Power Sequencers |
| MAX5929 | Low-Voltage. Quad. Hot-Swap Controllers/Power Sequencers |
| MAX5930 | Low-Voltage. Triple. Hot-Swap Controllers/Power Sequencers/Voltage Trackers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5895EGK+D | 功能描述:數模轉換器- DAC 16-Bit 2Ch 500Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5895EGK+TD | 功能描述:數模轉換器- DAC 16-Bit 2Ch 500Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5895EGK-D | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5895EGK-TD | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5895EVCMOD2 | 功能描述:數模轉換器- DAC Evaluation Kit for the MAX5893/MAX5894/MAX5895 RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。