參數資料
型號: M37735MHBXXXFP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP80
封裝: 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80
文件頁數: 13/93頁
文件大?。?/td> 1802K
代理商: M37735MHBXXXFP
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
17
MITSUBISHI MICROCOMPUTERS
M37735MHBXXXFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
TIMER
There are eight 16-bit timers. They are divided by type into timer A(5)
and timer B(3).
The timer I/O pins are also used as I/O pins for ports P5 and P6. To
use these pins as timer input pins, the port direction register bit
corresponding to the pin must be cleared to “0” to specify the input
mode.
TIMER A
Figure 13 shows a block diagram of timer A.
Timer A has four modes; timer mode, event counter mode, one-shot
pulse mode, and pulse width modulation mode. The mode is selected
with bits 0 and 1 of the timer Ai mode register (i = 0 to 4). Each of
these modes is described below.
(1) Timer mode [00]
Figure 14 shows the bit configuration of the timer Ai mode register
during timer mode. Bits 0, 1, and 5 of timer Ai mode register must
always be “0” in the timer mode.
Bit 3 is ignored if bit 4 is “0”.
Bits 6 and 7 are used to select the timer counter source. The counting
of the selected clock starts when the count start flag is “1” and stops
when it is “0”.
Figure 15 shows the bit configuration of the count start flag. The
counter is decremented. An interrupt is caused and the interrupt
request bit of the timer Ai interrupt control register is set when the
contents becomes 000016. At the same time, the contents of the reload
register are transferred to the counter, and count is continued.
Fig. 13 Block diagram of timer A
Data bus (odd)
Data bus (even)
Count start flag
Down count
Up-down flag
(High-order 8 bits)
Counter(16)
Up/Down
Polarity
selection
Timer (gate function)
TAi IN
f2
f16
f64
f512
Clock source selection
(i = 0 – 4)
Timer
One-shot
Pulse width modulation
Event counter
External trigger
Always decremented
except in event count mode
Timer A0 4716 4616
Timer A1 4916 4816
Timer A2 4B16 4A16
Timer A3 4D16 4C16
Timer A4 4F16 4E16
Address
(Low-order
8 bits)
(Address 4016)
Pulse output
TAi OUT
(i = 0 – 4)
(Address 4416)
Reload register(16)
Toggle flip-flop
相關PDF資料
PDF描述
M37735MHLXXXHP 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80
M37735S4LHP 16-BIT, 12 MHz, MICROCONTROLLER, PQFP80
M37736EHBGS 16-BIT, UVPROM, 24 MHz, MICROCONTROLLER, CQCC100
M37736EHBXXXGP 16-BIT, OTPROM, 25 MHz, MICROCONTROLLER, PQFP100
M37736EHBGS 16-BIT, UVPROM, 25 MHz, MICROCONTROLLER, CQCC100
相關代理商/技術參數
參數描述
M37735MHL 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M37735MHL-143HP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:PROM VERSION OF M37735MHLXXXHP
M37735MHLXXXHP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M37735S4BFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37735S4LHP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER