參數(shù)資料
型號: M30625MGP-XXXGP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP128
封裝: 14 X 20 MM, 0.50 MM PITCH, PLASTIC, LQFP-128
文件頁數(shù): 125/348頁
文件大?。?/td> 4209K
代理商: M30625MGP-XXXGP
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁當前第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁第235頁第236頁第237頁第238頁第239頁第240頁第241頁第242頁第243頁第244頁第245頁第246頁第247頁第248頁第249頁第250頁第251頁第252頁第253頁第254頁第255頁第256頁第257頁第258頁第259頁第260頁第261頁第262頁第263頁第264頁第265頁第266頁第267頁第268頁第269頁第270頁第271頁第272頁第273頁第274頁第275頁第276頁第277頁第278頁第279頁第280頁第281頁第282頁第283頁第284頁第285頁第286頁第287頁第288頁第289頁第290頁第291頁第292頁第293頁第294頁第295頁第296頁第297頁第298頁第299頁第300頁第301頁第302頁第303頁第304頁第305頁第306頁第307頁第308頁第309頁第310頁第311頁第312頁第313頁第314頁第315頁第316頁第317頁第318頁第319頁第320頁第321頁第322頁第323頁第324頁第325頁第326頁第327頁第328頁第329頁第330頁第331頁第332頁第333頁第334頁第335頁第336頁第337頁第338頁第339頁第340頁第341頁第342頁第343頁第344頁第345頁第346頁第347頁第348頁
Mitsubishi microcomputers
M16C / 62P Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Programmable I/O Ports
210
Under
development
Preliminary Specifications Rev.1.0
Specifications in this manual are tentative and subject to change.
Programmable I/O Ports
The programmable input/output ports (hereafter referred to simply as “I/O ports”) consist of 87 lines P0 to
P10 (except P85) for the 100-pin version, or 113 lines P0 to P14 (except P85) for the 128-pin version. Each
port can be set for input or output every line by using a direction register, and can also be chosen to be or
not be pulled high every 4 lines. P85 is an input-only port and does not have a pull-up resistor. Port P85
_______
______
shares the pin with NMI, so that the NMI input level can be read from the P8 register P8_5 bit.
Figures 1.25.1 to 1.25.4 show the I/O ports. Figure 1.25.5 shows the I/O pins.
Each pin functions as an I/O port, a peripheral function input/output, or a bus control pin.
For details on how to set peripheral functions, refer to each functional description in this manual. If any pin
is used as a peripheral function input or D-A converter output pin, set the direction bit for that pin to “0” (input
mode). Any pin used as an output pin for peripheral functions other than the D-A converter is directed for
output no matter how the corresponding direction bit is set.
When using any pin as a bus control pin, refer to “Bus Control.”
P0 to P5, P12, and P13 are capable of VCC2-level input/output; P6 to P11 and P14 are capable of VCC1-
level input/output.
(1) Port Pi Direction Register (PDi Register, i = 0 to 13)
Figure 1.25.6 shows the direction registers.
This register selects whether the I/O port is to be used for input or output. The bits in this register corre-
spond one for one to each port.
During memory extension and microprocessor modes, the PDi registers for the pins functioning as bus
_______
_______ _______ _________ ______
__________________
_________
control pins (A0 to A19, D0 to D15, CS0 to CS3, RD, WRL/WR, WRH/BHE, ALE, RDY, HOLD, HLDA, and
BCLK) cannot be modified.
No direction register bit for P85 is available.
(2) Port Pi Register (Pi Register, i = 0 to 13)
Figure 1.25.7 and 1.25.8 show the Pi registers.
Data input/output to and from external devices are accomplished by reading and writing to the Pi register.
The Pi register consists of a port latch to hold the input/output data and a circuit to read the pin status. For
ports set for input mode, the input level of the pin can be read by reading the corresponding Pi register,
and data can be written to the port latch by writing to the Pi register.
For ports set for output mode, the port latch can be read by reading the corresponding Pi register, and
data can be written to the port latch by writing to the Pi register. The data written to the port latch is output
from the pin. The bits in the Pi register correspond one for one to each port.
During memory extension and microprocessor modes, the PDi registers for the pins functioning as bus
_______
_______ _______ _________ ______
__________________
_________
control pins (A0 to A19, D0 to D15, CS0 to CS3, RD, WRL/WR, WRH/BHE, ALE, RDY, HOLD, HLDA, and
BCLK) cannot be modified.
(3) Pull-up Control Register 0 to Pull-up Control Register 2 (PUR0 to PUR2 Registers)
Figure 1.25.9 shows the PUR0 to PUR2 registers.
The PUR0 to PUR2 register bits can be used to select whether or not to pull the corresponding port high
in 4 bit units. The port chosen to be pulled high has a pull-up resistor connected to it when the direction bit
is set for input mode.
However, the pull-up control register has no effect on P0 to P3, P40 to P43, and P5 during memory
extension and microprocessor modes. Although the register contents can be modified, no pull-up resis-
tors are connected.
(4) Port Control Register
Figure 1.25.10 shows the port control register.
When the P1 register is read after setting the PCR register’s PCR0 bit to “1”, the corresponding port latch
can be read no matter how the PD1 register is set.
相關PDF資料
PDF描述
M30627MHP-XXXGP 16-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP128
M30626FHPFP 16-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP100
M30623MWP-XXXGP 16-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP128
M30626MWP-XXXFP 16-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP100
M30620SPGP 16-BIT, 24 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數(shù)
參數(shù)描述
M30625MG-XXXGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30625MHP-XXXGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30625MWP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30625MWP-XXXGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30626FHPFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER