參數資料
型號: M30201MX-XXXFP
廠商: Mitsubishi Electric Corporation
英文描述: SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
中文描述: 單片16位CMOS微機
文件頁數: 30/159頁
文件大?。?/td> 1496K
代理商: M30201MX-XXXFP
Unde
Interrupts
deeopmen
Mitsubishi microcomputers
M30201 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
30
Hardware Interrupts
Hardware interrupts are classified into two types — special interrupts and peripheral I/O interrupts.
(1) Special interrupts
Special interrupts are non-maskable interrupts.
Reset
Reset occurs if an “L” is input to the RESET pin.
DBC interrupt
This interrupt is exclusively for the debugger, do not use it in other circumstances.
Watchdog timer interrupt
Generated by the watchdog timer.
Single-step interrupt
This interrupt is exclusively for the debugger, do not use it in other circumstances. With the debug flag
(D flag) set to “1”, a single-step interrupt occurs after one instruction is executed.
Address match interrupt
An address match interrupt occurs immediately before the instruction held in the address indicated by
the address match interrupt register is executed with the address match interrupt enable bit set to “1”.
If an address other than the first address of the instruction in the address match interrupt register is
set, no address match interrupt occurs.
(2) Peripheral I/O interrupts
A peripheral I/O interrupt is generated by one of built-in peripheral functions. The interrupt vector table is
the same as the one for software interrupt numbers 0 through 31 the INT instruction uses. Peripheral I/O
interrupts are maskable interrupts.
Key-input interrupt
A key-input interrupt occurs if an “L” is input to the KI pin.
A-D conversion interrupt
This is an interrupt that the A-D converter generates.
UART0 and UART1 transmission interrupt
These are interrupts that the serial I/O transmission generates.
UART0 and UART1 reception interrupt
These are interrupts that the serial I/O reception generates.
Timer A0 interrupt
This is an interrupts that timer A0 generates.
Timer B0 and timer B2 interrupt
These are interrupts that timer B generates.
Timer X0 to timer X2 interrupt
INT0 and INT1 interrupt
An INT interrupt occurs if either a rising edge or a falling edge is input to the INT pin.
相關PDF資料
PDF描述
M30220MA-XXXGP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30220MA-XXXRP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30245F4-XXXGP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30245F8-XXXGP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30245FA-XXXGP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
相關代理商/技術參數
參數描述
M30201MX-XXXSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30201T-52SP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Converter for Connecting Pod Probe M30201T-PRB to 52-pin 1.778mm-pitch SDIP (for M30201 Group)
M30201T-56FP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Converter for Connecting Pod Probe M30201T-PRB to 56-pin 0.65mm-pitch QFP (for M30201 Group)
M30201T-PRB 制造商:Renesas Electronics Corporation 功能描述:POD PROBE FOR M16C/20 GROUP - Bulk
M3021-000002-017BG 功能描述:Pressure Sensor 246.56 PSI (1700 kPa) Vented Gauge Male - 1/4" (6.35mm) BSPP 0 mV ~ 100 mV (5V) Cylinder 制造商:te connectivity measurement specialties 系列:MSP300 零件狀態:有效 壓力類型:排氣式壓力計 工作壓力:246.56 PSI(1700 kPa) 輸出類型:模擬電壓 輸出:0 mV ~ 100 mV(5V) 精度:±1% 電壓 - 電源:5V 端口尺寸:公型 - 1/4"(6.35mm) BSPP 端口樣式:有螺紋 特性:溫度補償 端子類型:導線引線 最高壓力:493.13 PSI(3400 kPa) 工作溫度:-20°C ~ 85°C 封裝/外殼:圓柱型 供應商器件封裝:- 標準包裝:1