- 您現在的位置：買賣IC網 > PDF目錄30771 > LTC3860IUH#PBF (LINEAR TECHNOLOGY CORP) DUAL SWITCHING CONTROLLER, 1250 kHz SWITCHING FREQ-MAX, PQCC32 PDF資料下載
參數資料
| 型號： | LTC3860IUH#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | DUAL SWITCHING CONTROLLER, 1250 kHz SWITCHING FREQ-MAX, PQCC32 |
| 封裝： | 5 X 5 MM, LEAD FREE, PLASTIC, MO-220WHHD, QFN-32 |
| 文件頁數： | 7/36頁 |
| 文件大?。?/td> | 436K |
| 代理商： | LTC3860IUH#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LTC3860
15
3860fc
APPLICATIONS INFORMATION
Choosing the Inductor and Setting the Current Limit
The inductor value is related to the switching frequency,
which is chosen based on the trade-offs discussed in the
Operation section. The inductor can be sized using the
following equation:
L
=
V
OUT
f
ΔI
L
1
V
OUT
V
IN
Choosing a larger value of ΔIL leads to smaller L, but re-
sults in greater core loss (and higher output voltage ripple
for a given output capacitance and/or ESR). A reasonable
starting point for setting the ripple current is 30% of the
maximum output current, or:
ΔIL = 0.3 IOUT
The inductor saturation current rating needs to be higher
than the peak inductor current during transient conditions.
If IOUT is the maximum rated load current, then the maxi-
mum transient current, IMAX, would normally be chosen
to be some factor (e.g., 60%) greater than IOUT:
IMAX = 1.6 IOUT
The minimum saturation current rating should be set to
allow margin due to manufacturing and temperature varia-
tion in the sense resistor or inductor DCR. A reasonable
value would be:
ISAT = 2.2 IOUT
The programmed current limit must be low enough to
ensure that the inductor never saturates and high enough
to allow increased current during transient conditions and
allow margin for DCR variation.
For example, if:
ISAT = 2.2 IOUT
and
IMAX = 1.6 IOUT
A reasonable ILIMIT would be:
ILIMIT = 2 IOUT
If the sensed inductor current exceeds current limit, the
IC will three-state the PWM outputs, reset the soft-start
timer and wait 32768 switching cycles before attempting
to return the output to regulation.
The current limit is programmed using a resistor from the
ILIM pin to SGND. The ILIM pin sources 20μA to generate
a voltage corresponding to the current limit. The current
sense circuit has a voltage gain of 20 and a zero current
level of 500mV. Therefore, the current limit resistor should
be set using the following equation:
R
ILIM =
18.5 I
LIMIT(SET) RSENSE + 0.53V
20A
In multiphase applications only one current limit resistor
should be used per LTC3860. The ILIM2 pin should be tied
to VCC. Internal logic will then cause channel 2 to use the
same current limit levels as channel 1. If an LTC3860 has
a slave and an independent, then both ILIM pins must be
independently set to the right voltage.
Inductor Core Selection
Once the value of L is known, the type of inductor must be
selected. High efciency converters generally cannot afford
the core losses found in low cost powdered iron cores,
forcing the use of more expensive ferrite or molypermalloy
cores. Also, core losses decrease as inductance increases.
Unfortunately, increased inductance requires more turns
of wire, larger inductance and larger copper losses.
Ferrite designs have very low core loss and are preferred at
high switching frequencies. However, these core materials
exhibit “hard” saturation, causing an abrupt reduction in the
inductance when the peak current capability is exceeded.
Do not allow the core to saturate!
CIN Selection
The input bypass capacitor in an LTC3860 circuit is com-
mon to both channels. The input bypass capacitor needs
to meet these conditions: its ESR must be low enough to
keep the supply drop low as the top MOSFETs turn on, its
RMS current capability must be adequate to withstand the
ripple current at the input, and the capacitance must be
large enough to maintain the input voltage until the input
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3862HUH#TRPBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC24 |
| LTC3862IFE#PBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3862HFE#PBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3862EGN#TRPBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3862IUH#PBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3861EUH-1#PBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN 制造商:Linear Technology 功能描述:BUCK CNTRL DUAL 12PH 2.25MHZ 32QFN 制造商:Linear Technology 功能描述:BUCK, CNTRL, DUAL, 12PH, 2.25MHZ, 32QFN 制造商:Linear Technology 功能描述:PWM CONTROLLER, BUCK, 2.25MHZ, 24V, QFN-32, Input Voltage:24V, Output Voltage:5.5V, Output Current:60A, Supply Voltage Min:3V, Supply Voltage Max:5.5V, Digital IC Case Style:QFN, No. of Pins:32, Frequency:2.25MHz , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Dual-Phase/Dual-Channel Step-Down Voltage Mode Controller w |
| LTC3861EUH-1#TRPBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN |
| LTC3861EUHE#PBF | 功能描述:IC REG CTRLR BUCK PWM VM 36-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3861EUHE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM VM 36-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3861IUH-1#PBF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Dual-OUT Sync Step Down 3V to 24V Input 32-Pin QFN EP 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN 制造商:Linear Technology 功能描述:BUCK CNTRL DUAL 12PH 2.25MHZ 32QFN 制造商:Linear Technology 功能描述:BUCK, CNTRL, DUAL, 12PH, 2.25MHZ, 32QFN 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Dual-Phase/Dual-Channel Step-Down Voltage Mode Controller w 制造商:Linear Technology 功能描述:PWM CONTROLLER, BUCK, 2.25MHZ, 24V, QFN-32, Input Voltage:24V, Output Voltage:5.5V, Output Current:60A, Supply Voltage Min:3V, Supply Voltage Max:5.5V, Digital IC Case Style:QFN, No. of Pins:32, Frequency:2.25MHz , RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。