- 您現在的位置：買賣IC網 > PDF目錄44992 > LTC3616IUDD#TRPBF (LINEAR TECHNOLOGY CORP) 13.5 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC24 PDF資料下載
參數資料
| 型號： | LTC3616IUDD#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 13.5 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封裝： | 3 X 5 MM, LEAD FREE, PLASTIC, QFN-24 |
| 文件頁數： | 8/28頁 |
| 文件大?。?/td> | 490K |
| 代理商： | LTC3616IUDD#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC3616
16
3616fa
applicaTions inForMaTion
Output Capacitor (COUT) Selection
The selection of COUT is typically driven by the required
ESR to minimize voltage ripple and load step transients
(low ESR ceramic capacitors are discussed in the next
section). Typically, once the ESR requirement is satisfied,
the capacitance is adequate for filtering. The output ripple
VOUT is determined by:
VOUT ≤ IL ESR +
1
8 fSW COUT
where fOSC = operating frequency, COUT = output capaci-
tance and IL = ripple current in the inductor. The output
ripple is highest at maximum input voltage since IL
increases with input voltage.
In surface mount applications, multiple capacitors may
have to be paralleled to meet the capacitance, ESR or RMS
currenthandlingrequirementoftheapplication.Aluminum
electrolytic, special polymer, ceramic and dry tantalum
capacitors are all available in surface mount packages.
Tantalum capacitors have the highest capacitance density,
but can have higher ESR and must be surge tested for
use in switching power supplies. Aluminum electrolytic
capacitors have significantly higher ESR, but can often
be used in extremely cost-sensitive applications provided
that consideration is given to ripple current ratings and
long-term reliability.
Ceramic Input and Output Capacitors
Ceramic capacitors have the lowest ESR and can be cost
effective, but also have the lowest capacitance density,
high voltage and temperature coefficients, and exhibit
audible piezoelectric effects. In addition, the high Q of
ceramic capacitors along with trace inductance can lead
to significant ringing.
They are attractive for switching regulator use because
of their very low ESR, but great care must be taken when
using only ceramic input and output capacitors.
Ceramic capacitors are prone to temperature effects
which require the designer to check loop stability over
the operating temperature range. To minimize their large
temperature and voltage coefficients, only X5R or X7R
ceramic capacitors should be used.
Whenaceramiccapacitorisusedattheinputandthepower
is being supplied through long wires, such as from a wall
adapter, a load step at the output can induce ringing at the
VIN pin. At best, this ringing can couple to the output and
be mistaken as loop instability. At worst, the ringing at the
input can be large enough to damage the part.
Since the ESR of a ceramic capacitor is so low, the input
and output capacitor must instead fulfill a charge storage
requirement. During a load step, the output capacitor
must instantaneously supply the current to support the
load until the feedback loop raises the switch current
enough to support the load. The time required for the
feedback loop to respond is dependent on the compensa-
tion components and the output capacitor size. Typically,
3 to 4 cycles are required to respond to a load step, but
only in the first cycle does the output drop linearly. The
output droop, VDROOP, is usually about 2 to 4 times the
linear drop of the first cycle; however, this behavior can
vary depending on the compensation component values.
Thus, a good place to start is with the output capacitor
size of approximately:
COUT ≈
3.5 IOUT
fSW VDROOP
This is only an approximation; more capacitance may
be needed depending on the duty cycle and load step
requirements.
Inmostapplications,theinputcapacitorismerelyrequired
to supply high frequency bypassing, since the impedance
to the supply is very low.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3617EUDD#PBF | 14 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC24 |
| LTC3618EUF#TRPBF | 8 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PQCC24 |
| LTC3618IFE#PBF | 8 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3618EFE#TRPBF | 8 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3620EDC#PBF | SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3616MPUDD#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 6A 24QFN |
| LTC3616MPUDD#TRPBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 6A 24QFN |
| LTC3617EUDD#PBF | 功能描述:IC REG SYNC 6A BUCK 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:2,000 系列:- 應用:控制器，DSP 輸入電壓:4.5 V ~ 25 V 輸出數:2 輸出電壓:最低可調至 1.2V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:30-TFSOP（0.173"，4.40mm 寬） 供應商設備封裝:30-TSSOP 包裝:帶卷 (TR) |
| LTC3617EUDD#TRPBF | 功能描述:IC REG SYNC 6A BUCK 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC3617IUDD#PBF | 功能描述:IC REG SYNC 6A BUCK 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。